Page 32 of 150

4-8
4
EBU18722Fuel tank capRemove the fuel tank cap by turning it counter-
clockwise.EBU37251FuelMake sure there is sufficient gasoline in the tank
before starting off. This model has been designed
to use premium unleaded gasoline of RON 97. If
knocking or pinging occurs, use a gasoline of a
higher octane (research octane number) or a dif-
ferent brand. Use of unleaded fuel will extend
spark plug life and reduce maintenance costs.
WARNING
EWB02522Gasoline and gasoline vapors are extremely
flammable. To avoid fires and explosions and
to reduce the risk of injury when refueling, fol-
low these instructions. 1. Before refueling, turn off the engine and besure that no one is sitting on the vehicle. Nev-
er refuel while smoking, or while in the vicinity
of sparks, open flames, or other sources of
ignition such as the pilot lights of water heat-
ers and clothes dryers.
2. When refueling, be sure to select the recom- mended fuel as specified. Do not overfill the
fuel tank. Since fuel expands when heated,
stop filling when the fuel reaches the bottom
of the filler tube. Otherwise heat from the en-
gine or sun can cause the fuel to expand and
spill out of the fuel tank.
1. Fuel tank cap
1
UBW261E0.book Page 8 Friday, May 26, 2017 9:38 AM
Page 34 of 150
4-10
43. After refueling, return the nozzle and then
close the fuel tank cap fully by turning it
clockwise. Make sure the fuel tank cap is se-
curely closed.
4. Wipe up any spilled fuel immediately. NOTICE: Immediately wipe off spilled fuel
with a clean, dry, soft cloth, since fuel may
deteriorate painted surfaces or plastic
parts.
[ECB00982]
WARNING
EWB02532Gasoline is poisonous and can cause injury or
death. Handle gasoline with care. Never siphon
gasoline by mouth. If you should swallow some
gasoline or inhale a lot of gasoline vapor, or get
some gasoline in your eyes, see your doctor
immediately. If gasoline spills on your skin,
wash with soap and water. If gasoline spills on
your clothing, change your clothes.
EBU26733SeatTo remove the seat
Insert your hand between the rear of the seat and
the rear fender, pull the seat lock lever and pull up
the seat at the rear.1. Seat lock lever
1
UBW261E0.book Page 10 Friday, May 26, 2017 9:38 AM
Page 94 of 150
8-10
8
EBU30131Removing and installing the cowling
and panelsThe cowling and panels shown need to be re-
moved to perform some of the maintenance jobs
described in this chapter. Refer to this section
each time a cowling or panel needs to be removed
and installed.
EBU29596Panel A
To remove the panel1. Remove the seat. (See page 4-10.)
2. Remove the fuel tank cap by turning it coun-terclockwise. (See page 4-8.) NOTICE: Make
sure that no foreign material enters the
fuel tank.
[ECB01052]
3. Loosen the quick fasteners.
1. Panel A
2. Panel B
3. Cowling
1
2
3
1. Panel C
1
UBW261E0.book Page 10 Friday, May 26, 2017 9:38 AM
Page 95 of 150
8-11
8
4. Remove the quick fasteners, and then slide
the panel backward and pull upward. 5. Install the fuel tank cap by turning it clock-
wise.
To install the panel
1. Remove the fuel tank cap by turning it coun- terclockwise.
2. Place the panel in the original position, and then install the quick fasteners. NOTICE:
When installing the panel, be sure not to
pinch the cables or wires.
[ECB00382]
3. Tighten the quick fasteners.
4. Install the fuel tank cap by turning it clock- wise.
5. Install the seat.
1. Quick fastener
1. Quick fastener
1 1
1
UBW261E0.book Page 11 Friday, May 26, 2017 9:38 AM
Page 131 of 150
8-47
8
3. Remove the socket by pushing it in and turn-
ing it counterclockwise, and then remove the
burnt-out bulb.
4. Place a new headlight bulb into position. NOTICE: Do not touch the glass part of the
bulb. Oil from your fingers or other con-
tamination will adversely affect the trans-
parency of the glass, luminosity of the
bulb, and bulb life. Thoroughly clean off
any dirt and fingerprints using a cloth
moistened with alcohol or thinner.
[ECB00653]
5. Install the socket by pushing it in and turning it clockwise.
6. Install the bulb cover.TIPWhen installing the bulb cover, make sure the
“TOP” mark faces upwards.
1. Socket
1
1. Do not touch the glass part of the bulb.
UBW261E0.book Page 47 Friday, May 26, 2017 9:38 AM