Page 374 of 502
area Fig. 186otorway journeys in summer, when towing a 
trailer Trailer towing 
Checking the engine oil level and refilling the engine oil 
 
Fig. 186 Engine oil level markings on the oil dipstick (variants). 
 
Fig. 187 In the engine compartment: engine oil filler cap (illustration). 
First read and observe the introductoryinformation and safety warnings
Key to Fig. 186 
Engine oil level too high observe the messages on the instrument cluster display or contact a 
qualified workshop, if necessary. 
Do not fill engine oil. 
Engine oil level OK. 
Engine oil level too low fill engine oil. 
Checklist 
Carry out the steps in the specified order   
     
        
        Page 375 of 502

With the engine at operating temperature, park the vehicle on a level surface to ensure that the 
engine oil reading is correct. 
 
Switch off the engine and wait a few minutes for the engine oil to flow back into the sump. 
 
Open the bonnet In the engine compartment. 
 
Identify the engine oil filler cap and oil dipstick. The engine oil filler opening can be recognised by 
the symbol  on the cap and the oil dipstick has a coloured handle. If you cannot find the cap and 
dipstick, please contact a qualified workshop. 
 
Pull the dipstick out of the guide tube and wipe it off with a clean cloth. 
 
Insert the oil dipstick into the guide tube again as far as it will go. If there is a marking on the upper 
end of the oil dipstick, this marking must fit into the corresponding groove at the top end of the 
guide tube upon insertion. 
Engine oil 
level too high. Observe any messages that are shown on the instrument cluster display or contact a 
qualified workshop . Do not fill any engine oil . Continue with step 16. Engine oil level OK. 
Engine oil can, e.g. in the case of high engine loads , be filled up to the upper limit of this range. 
Continue with step 8 or 16. Engine oil level is too low. Engine oil must be filled. Continue with 
step 8. 
 
After reading off the oil level, push the oil dipstick back into the guide tube as far as it will go. 
 
Unscrew the cap of the engine oil filler opening . 
 
Using only the engine oil approved by Volkswagen expressly for this engine, fill oil gradually in small 
amounts (no more than 0.5 l). 
  
     
        
        Page 376 of 502

engine oil to flow into the sump up to the marking on the engine oil dipstick. 
 
Read the engine oil level from the dipstick again before refilling with a further small quantity of 
engine oil. Never overfill engine oil . 
 
After refilling, the engine oil level should be in the middle of area 
area nd must not be in area . 
 
If too much engine oil has been added unintentionally and the engine oil level is in area 
start the engine. Inform a qualified workshop and seek expert assistance if necessary. 
 
Close the engine oil filler opening with the cap after filling. 
 
Insert the oil dipstick into the guide tube as far as it will go. If there is a marking on the upper end of 
the oil dipstick, this marking must fit into the corresponding groove at the top end of the guide tube 
upon insertion. 
 
Close the bonnet In the engine compartment. 
 
WARNING 
Engine oil can ignite if it comes into contact with hot engine components. It can cause fires, burns 
and other serious injuries. 
up and ignite when the engine is running. 
dipstick is properly inserted back into the guide tube. This will prevent the engine oil from draining 
out on to hot engine components when the engine is running. 
 
NOTICE 
Fig. 186
necessary. The catalytic converter and the engine could otherwise be damaged.