2018 TOYOTA YARIS iA fuel filter

Engine Oil and Filter
Maintenance
Your vehicle is equipped with
0W-20 synthetic oil which allows for
extended oil change intervals and optimum
fuel economy. It is recommended that
Toyota Genuine 0W-20 Motor Oil be used
during scheduled oil changes. For normal
operating conditions, Toyota recommends
changing your oil and filter every
7,500 miles or 6 months,whichever
occurs first. However, if your vehicle is
primarily driven under any of the following
Special Operating Conditions, it is
recommended that you change your oil
and filter every 5,000 miles or 4 months,
whichever occurs first:
•Driving on dirt roads or dusty roads
•Driving while towing, using a car-top
carrier, or heavy vehicle loading
•Repeated trips of less than five miles in
temperatures below 32°F /0°C
•Extensive idling and/or low speed
driving for a long distance such as
police, taxi or door-to-door delivery use
Additional Maintenance
In addition to scheduled maintenance,
your Toyota requires ongoing general
maintenance such as fluid checks and
visual inspections. These procedures are
explained in the “Maintenance and Care”
section of the
Owner’s Manual. Be sure to
perform these procedures regularly to
ensure the most trouble-free operation of
your vehicle.
SuperChrome and Alloy Wheel
Care
If you purchased genuine Toyota
accessory Aluminum Alloy Wheels, follow
these cleaning guidelines to maintain the
appearance of your alloy wheels:
•If wheels are hot, wait for them to cool
before washing.
•Use a soft sponge or cotton cloth to
apply the same mild car-wash soap as
used for the vehicle body. Quickly rinse
off with water. Use a soft cloth to apply
the same car wax as used for the
vehicle body.
•DO NOT USE: Any kind of chemical
based cleaners, alcohol, solvents,
gasoline, steam cleaners, scouring
pads, wire brushes, or coarse abrasives
to clean your wheels.
USING THE MAINTENANCE LOG CHARTS
Maintenance Log37
MAINTENANCE

22,500 miles or 18 months
Check installation of driver’s floor matInspect and adjust all fluid levels1
Inspect wiper bladesReplace engine oil and oil filter2
Rotate tiresVisually inspect brake linings/drums
and brake pads/discs
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
30,000 miles or 24 months
Check installation of driver’s floor matInspect and adjust all fluid levels1
Inspect emergency flat tire repair kit (if
equipped)3
Inspect wiper bladesReplace cabin air filterReplace engine oil and oil filter2
Rotate tiresTighten nuts and bolts on body and
chassis
Inspect the following:Ball joints and dust coversBrake lines and hosesBrake linings/drums and
brake pads/discs4
Drive shaft bootsEngine coolant5
Fuel lines and connections, fuel tank
band and fuel tank vapor vent system
hoses
Fuel tank cap gasketRadiator and condenserSteering gearSteering linkage and bootsTransmission fluid or oil
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
1Inspect sealed transmissions, transfer cases, and differentials for signs of leakage. If any leakage from a sealed
component is suspected, it is recommended that you have the sealed component inspected by a Toyota dealer. Inspect
power steering fluid (if equipped) and brake fluid level/condition. Inspect engine and inverter (if equipped) coolant
level/condition/freezing point. Your dealer may recommend services (Dealer-Recommended Maintenance) based on
inspection results.
2Reset the scheduled maintenance indicator light. Use 0W-20 Genuine Toyota Motor Oil or equivalent.3Check the tire repair fluid expiration date every year during inspection. Replace the tire repair fluid bottle with a new
one before the expiration date.
4Inspect thickness measurement and disc runout.5Refer to “Engine Coolant” in the “Explanation of Maintenance Items” section in the back of this guide for more
information.
MAINTENANCE LOG
MAINTENANCE
Maintenance Log39

52,500 miles or 42 months
Check installation of driver’s floor matInspect and adjust all fluid levels1
Inspect wiper bladesReplace engine oil and oil filter2
Rotate tiresVisually inspect brake linings/drums
and brake pads/discs
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
60,000 miles or 48 months
Check installation of driver’s floor matInspect and adjust all fluid levels1
Inspect emergency flat tire repair kit (if
equipped)3
Inspect wiper bladesReplace cabin air filterReplace engine oil and oil filter2
Rotate tiresTighten nuts and bolts on body and
chassis
Inspect the following:Ball joints and dust coversBrake lines and hosesBrake linings/drums and
brake pads/discs4
Drive shaft bootsEmission hoses and tubesEngine coolant5
Fuel lines and connections, fuel tank
band and fuel tank vapor vent system
hoses
Fuel tank cap gasketRadiator and condenserSteering gearSteering linkage and bootsTransmission fluid or oil
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
1Inspect sealed transmissions, transfer cases, and differentials for signs of leakage. If any leakage from a sealed
component is suspected, it is recommended that you have the sealed component inspected by a Toyota dealer. Inspect
power steering fluid (if equipped) and brake fluid level/condition. Inspect engine and inverter (if equipped) coolant
level/condition/freezing point. Your dealer may recommend services (Dealer-Recommended Maintenance) based on
inspection results.
2Reset the scheduled maintenance indicator light. Use 0W-20 Genuine Toyota Motor Oil or equivalent.3Check the tire repair fluid expiration date every year during inspection. Replace the tire repair fluid bottle with a new
one before the expiration date.
4Inspect thickness measurement and disc runout.5Refer to “Engine Coolant” in the “Explanation of Maintenance Items” section in the back of this guide for more
information.
MAINTENANCE LOG
MAINTENANCE
Maintenance Log41

82,500 miles or 66 months
Check installation of driver’s floor matInspect and adjust all fluid levels1
Inspect wiper bladesReplace engine oil and oil filter2
Rotate tiresVisually inspect brake linings/drums
and brake pads/discs
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
90,000 miles or 72 months
Check installation of driver’s floor matInspect and adjust all fluid levels1
Inspect emergency flat tire repair kit (if
equipped)3
Inspect wiper bladesReplace cabin air filterReplace engine oil and oil filter2
Rotate tiresTighten nuts and bolts on body and
chassis
Inspect the following:Ball joints and dust coversBrake lines and hosesBrake linings/drums and
brake pads/discs4
Drive shaft bootsEngine coolant5
Exhaust pipes and mountingsFuel lines and connections, fuel tank
band and fuel tank vapor vent system
hoses
Fuel tank cap gasketRadiator and condenserSteering gearSteering linkage and bootsTransmission fluid or oil
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
1Inspect sealed transmissions, transfer cases, and differentials for signs of leakage. If any leakage from a sealed
component is suspected, it is recommended that you have the sealed component inspected by a Toyota dealer. Inspect
power steering fluid (if equipped) and brake fluid level/condition. Inspect engine and inverter (if equipped) coolant
level/condition/freezing point. Your dealer may recommend services (Dealer-Recommended Maintenance) based on
inspection results.
2Reset the scheduled maintenance indicator light. Use 0W-20 Genuine Toyota Motor Oil or equivalent.3Check the tire repair fluid expiration date every year during inspection. Replace the tire repair fluid bottle with a new
one before the expiration date.
4Inspect thickness measurement and disc runout.5Refer to “Engine Coolant” in the “Explanation of Maintenance Items” section in the back of this guide for more
information.
MAINTENANCE LOG
MAINTENANCE
Maintenance Log43

112,500 miles or 90 months
Check installation of driver’s floor matInspect and adjust all fluid levels1
Inspect drive beltsInspect wiper bladesReplace engine air filterReplace engine oil and oil filter2
Rotate tiresVisually inspect brake linings/drums
and brake pads/discs
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
120,000 miles or 96 months
Check installation of driver’s floor matInspect and adjust all fluid levels1
Inspect emergency flat tire repair kit (if
equipped)3
Inspect wiper bladesReplace cabin air filterReplace engine coolant4
Replace engine oil and oil filter2
Rotate tiresTighten nuts and bolts on body and
chassis
Inspect the following:Ball joints and dust coversBrake lines and hosesBrake linings/drums and
brake pads/discs5
Drive shaft bootsEmission hoses and tubesFuel lines and connections, fuel tank
band and fuel tank vapor vent system
hoses
Fuel tank cap gasketRadiator and condenserSteering gearSteering linkage and bootsTransmission fluid or oil
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
1Inspect sealed transmissions, transfer cases, and differentials for signs of leakage. If any leakage from a sealed
component is suspected, it is recommended that you have the sealed component inspected by a Toyota dealer. Inspect
power steering fluid (if equipped) and brake fluid level/condition. Inspect engine and inverter (if equipped) coolant
level/condition/freezing point. Your dealer may recommend services (Dealer-Recommended Maintenance) based on
inspection results.
2Reset the scheduled maintenance indicator light. Use 0W-20 Genuine Toyota Motor Oil or equivalent.3Check the tire repair fluid expiration date every year during inspection. Replace the tire repair fluid bottle with a new
one before the expiration date.
4NOTE:Initial replacement at 120,000 miles/120 months. Replace every 60,000 miles/60 months thereafter. Refer to
“Engine Coolant” in the “Explanation of Maintenance Items” section in the back of this guide for more information.
5Inspect thickness measurement and disc runout.
MAINTENANCE LOG
MAINTENANCE
Maintenance Log45

Driver’s Floor Mat
•Only use the driver’s floor mat
designed specifically for the model and
model year of your vehicle.
•Always properly secure the driver’s
floor mat using the retaining hooks.
•Never install another floor mat on top
of the existing driver’s floor mat.
•Never install the driver’s floor mat
upside down.
Emergency Flat Tire Repair Kit
Inspect at specified intervals.
Emission Hoses and Tubes
Visually inspect for corrosion, damage,
cracks, and loose or leaking connections.
Tighten connections or replace parts as
necessary.
Engine Air Filter
Inspect or replace at specified intervals.
When performing inspections, check for
damage, excessive wear and oiliness, and
replace if necessary.
Engine Coolant
NOTE:
Initial replacement is at
120,000 miles/120 months. Replace
every 60,000 miles/60 months
thereafter.
Drain the cooling system and refill with
the coolant specified by Toyota for your
vehicle. Inspect hoses and connections for
corrosion and leaks. Tighten connections
and replace parts when necessary. A
qualified technician should perform these
operations.
Engine Oil and Oil Filter
Replace the oil filter and drain and refill
the engine oil at specified intervals. For
recommended oil grade and viscosity,
refer to the
Owner’s Manual.
Your vehicle is equipped with
0W-20 synthetic oil which allows for
extended oil change intervals and optimum
fuel economy. It is recommended that
Toyota Genuine 0W-20 Motor Oil be used
during scheduled oil changes. For normal
operating conditions, Toyota recommends
changing your oil and filter every 7,500
miles or 6 months, whichever occurs first.
For special operating condition
maintenance recommendations, refer to
page 37 of this publication.
Exhaust Pipes and Mountings
Visually inspect the exhaust pipes, muffler
and hangers for cracks, deterioration and
damage. Start the engine and listen
carefully for any exhaust gas leakage.
Tighten connections or replace parts as
necessary.
Explanation of Maintenance Items
Maintenance Log47
MAINTENANCE