2018 TOYOTA RAV4 low beam

3 The indicator flashes to indicate that the system is operating.
5
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
5 ECO mode indicator
Electric power steering system
warning2
Ice warning indicator1
Intuitive parking assist indicator1
Pre-Collision System (PCS)
warning2
Rear passenger’s seat belt reminder
Vehicle Stability Control (VSC) OFF
indicator2
Slip indicator2,3
SPORT mode indicator
Seat belt reminder
(alarm will sound if speed is over 12 mph)
SRS airbag warning2
Theft deterrent/Engine immobilizer
system indicator
Turn signal indicator
Fog light indicator1
Headlight indicator
Headlight high beam indicator
Lane Departure Alert (LDA)
indicator
Low fuel level warning
Low Tire Pressure Warning2
Master warning2
Malfunction/Check Engine
indicator2
Eco driving indicator2

11
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Tilt & telescopic steering wheel
Lights & turn signals
Hold wheel, push lever down, set angle and length, and return lever.


NOTE: Do not attempt to adjust while the vehicle is in motion.
Length
Lock release leverAngle
Daytime Running Light system (DRL) Automatically turns on the headlights at a
reduced intensity.
Automatic On/Off
1 The side marker, parking, tail, license plate, instrument panel
and headlights turn on and off automatically
Automatic light cut off system
1 Automatically turns lights off after a 30-second
delay, or when lock switch on remote is pushed after all the doors are locked.
Automatic High Beam (AHB) system Automatically switches between high
and low beams as appropriate to provide the most light possible and enhance
forward visibility. Refer to Toyota Safety Sense™ P (TSS-P) in this guide or the
Owner’s Manual for more details on the Automatic High Beam feature.
* Operating conditions must be met. Refer to Owner’s Manual for details.
1 If equipped.
Type A
Type C
Type B
HEADLIGHTS
Parking lights
Parking lightsLow beam
High beam
flasher
High
beam
or
Auto High beam* Auto
DRL ONHeadlights
HeadlightsDRL OFFParking lights
DRL ONHeadlights
OFF

12
Windshield wipers & washers
FEATURES & OPERATIONS
Front fog lights come on only when the headlights are on low beam.
TurnOFF
OFF
OFF
ON
FRONT
REAR
1 Intermittent windshield wiper frequency adjustment Rotate to increase/
decrease wipe frequency.
Intermittent
Pull to wash and wipeAdjust frequency
1
Interval wipe
Slow
Fast Mist
Wash and wipe
Wipe
Interval wipe
1 The right hand signals will flash three times.2 The left hand signals will flash three times.
Right turn
Lane change
1
Lane change2
Left turn
FOG LIGHTS (IF EQUIPPED)
TURN SIGNALS

35
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Automatic High Beams (AHB)
(1) With the engine switch in IGNITION ON mode and headlight switch turned to
“AUTO” position, push lever away from you.
The “
” indicator will come on when the headlights are turned on
automatically to indicate that the system is active.
(2) Pull the lever back toward you to turn the AHB system off.
The “
” will turn off and the “” turns on.
When all of these conditions are met, high beams will be automatically turned on
(after approximately 1 second):
• Vehicle speed is above approximately 21 mph (34 km/h).
• The area ahead of the vehicle is dark.
• There are no oncoming or preceding vehicles with headlights or tail lights
turned on.
• There are few street lights on the road ahead.
If any of these conditions occur, the system is designed to automatically turn off
high beams:
• Vehicle speed drops below approximately 17 mph (27 km/h).
• The area ahead of the vehicle is not dark.
• Oncoming or preceding vehicles have headlights or tail lights
turned on.
• There are many streetlights on the road ahead.
ACTIVATING THE AHB SYSTEM
CONDITIONS WHERE AHB WILL TURN ON/OFF AUTOMATICALLY
AHB is a safety system designed to help drivers see more of what’s ahead at
nighttime without dazzling other drivers. When enabled, AHB uses an in-vehicle
camera to help detect the headlights of oncoming vehicles and tail lights of
preceding vehicles, then automatically switches between high and low beams
as appropriate to provide the most light possible and enhance forward visibility.
By using high beams more frequently, the system may allow earlier detection of
pedestrians and obstacles.
Refer to a Toyota Owner’s Manual for additional information on AHB operation,
settings adjustments, limitations, and precautions before attempting to use it.