2018 SUZUKI JIMNY coolant reservoir

INSPECTION AND MAINTENANCE
NOTE: SUZUKI highly recommends the use of ECSTAR brand coolant. ECSTAR has been specially formulated for your SUZUKI product and contributes to the desired vehicle performance and ideal driving experience.
Coolant level check
Check the coolant level at the reservoir tank, not at the radiator. With the engine cool, the coolant level should be between "FULL" and "LOW" marks.
Adding coolant
,A WARNING
Swallowing engine coolant can cause severe injury or death. Inhaling cool­ant mist or vapors or getting coolant in your eyes could result in severe injury. • Do not drink antifreeze or coolant solution. If swallowed, do not induce vomiting. Immediately con­tact a poison control center or a physician. • Avoid inhaling coolant mist or hot vapors. If inhaled, remove to a fresh air area. (Continued)
6-29
,A WARNING
(Continued) • If coolant gets in the eyes, flush with water and seek medical atten­tion. Wash thoroughly after handling coolant. Keep engine coolant out of the reach of children and pets.
NOTICE
SUZUKI LLC: Super (Blue) coolant; This coolant is already diluted to the proper percentage. Do not dilute with distilled water additionally. Doing so may result in the possibility of freez­ing and/or overheating coolant.
NOTICE
SUZUKI LLC: Standard (Green) cool­ant; • The mixture you use should con­tain 50% concentration of anti­freeze. If the lowest ambient temperature in your area is expected lo be -35°C (-31'F) or below, use higher con­centrations up to 60% following the instructions on the antifreeze con­tainer.
78RB07005
If the coolant level is below "LOW" mark, coolant should be added. While the engine is cool, remove the reservoir tank cap and add coolant until the reservoir tank level reaches "FULL" mark. Never fill the reser­voir tank above "FULL" mark.
NOTICE
When putting the cap on the reser­voir tank, line up the mark on the cap and the mark on the tank. Failure to follow this can result in coolant leak­age.
Coolant replacement
Since special procedures are required, ask a SUZUKI dealer for this job.

EMERGENCY SERVICE
If the high engine coolant temperature warning light does not go off or the tem­perature indication does not come down to within the normal, acceptable range:
1) Turn off the engine and check that the water pump belt and pulleys are not damaged or slipping. If any abnormality is found, correct it. 2) Check the coolant level in the reservoir. If it is found to be lower than "LOW" line, check radiator, water pump, radia­tor hoses and heater hoses for leakage. If leakage that may cause overheating is found, do not run the engine until these problems have been corrected. 3) If leakage is not found, carefully add coolant to the reservoir and then the radiator, if necessary. (Refer to "Engine coolant" in "INSPECTION AND MAIN­TENANCE" section.)
NOTE: If engine overheats and you are not sure what to do, contact a SUZUKI dealer.
7-11
650614
A WARNING
• It is hazardous to remove the radia­tor cap when the water temperature is high, because scalding fluid and steam may be blown out under pressure. The cap should only be taken off when the coolant tem­perature has lowered. To help prevent personal injury, keep hands, tools and clothing away from the engine cooling fan and air-conditioner fan. These elec­tric fans can automatically turn on without warning.

SPECIFICATION
ITEM: Recommended fuel / lubricants and capacities (approx.)
Fuel See "FUEL RECOMMENDATION" section. 40 L (8.8 Imp gal)
Engine oil Classification: ACEAA1/B1, A3/B3, A3/B4, A5/B5 For EU countries and API SL, SM or SN Israel ILSAC GF-3, GF-4 or GF-5 3.6 L (6.3 Imp pt) Viscosity: SAE 0W-16, 0W-20 or SW-30
Classification: API SG, SH, SJ, SL, SM or SN (replacement with oil filter) Except For EU coun-tries and Israel Viscosity: SAE 0W-20, SW-30, 10W-30, 1 0W-40, 15W40 or 20W-40
Engine coolant MIT 5.0 L (8.8 Imp pt)
"SUZUKI LLC: Super (Blue) Coolant" (including reservoir tank)
A/T 4.9 L (8.6 Imp pt) (including reservoir tank)
9-7