Page 15 of 33
13
Windshield Wipers
To turn on the wipers, press the wiper control lever down one level for intermittent,
two levels for low, or three levels for high speed. Return the lever to the “OFF”
position to stop the wipers. For a single wipe, move the lever up. To spray washer
fluid, pull and hold the lever toward you. Rotate the dial to adjust the intermittent
wiper speed.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only a reduced brightness
high beam will be automatically turned on when the engine has started, the
parking brake is fully released and the light switch is in the “OFF” or “
”
position. The brightness of the illumination of the high beam headlights\
is reduced
by the daytime running light system. You must always switch on your headlights
when it is dark outside by turning the light switch to the “
” position.
OFF
1
2
3
INT.
LOW
HIGH
Controls
3156598_18a_BRZ_QRG_100217.indd 1310/3/17 8:57 AM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 17 of 33
15
Dual Zone Automatic Climate Control System (if equipped)
1. Automatic On and Off This system automatically controls
outlet air temperature, fan speed,
air flow distribution, air inlet control,
and air conditioner compressor
operation. Press “AUTO” to activate.
Push “OFF” to turn off the system.
2. Temperature Control Dials
Rotate the dial to select a temperature
and maintain a comfortable climate
within the driver and passenger
compartment. Temperature is
displayed digitally on the screen.
Separate temperature settings
can be adjusted for the driver’s
side and passenger’s side.
Operation in Manual Mode
3. Recirculated/Outside Air Switch Push the air inlet selection switch to
prevent outside air from being drawn
into the passenger compartment.
Push the switch again to allow
outside air into the compartment.
TO PREVENT WINDSHIELD
FOGGING, DO NOT REMAIN IN THE
RECIRCULATED MODE FOR AN
EXTENDED PERIOD OF TIME.
4. Fan Speed Control Dial
In the automatic setting, the system
determines the fan speed to achieve
the desired temperature, or you can
manually rotate the fan speed control
dial to select one of seven fan speeds.
5. Air Flow Mode Selection Button Press the button to select the desired
air flow mode. The selected air flow
mode is shown on the display above.
6. Dual Mode Switch Push the “DUAL” switch to activate
or deactivate the dual mode. Dual
mode makes it possible to have
separate temperature settings for the
driver’s side and passenger’s side.
7. Air Conditioner Switch Push the “A/C” switch to activate
the air conditioning. Push it again
to turn off the air conditioning.
8. Front Defroster Button Press the button to defrost
or dehumidify the windshield
and front door windows.
9. Rear Window Defogger Switch Push the switch to turn on the
defogger. It will automatically shut off
after about 15 minutes. If the window
clears before that time, you can
push the switch again to turn it off.
2
36917
4
158
2
Controls
3156598_18a_BRZ_QRG_100217.indd 1510/3/17 8:58 AM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 19 of 33
17
Controls
Multi-Information Display Control Switches (if equipped)
For more information about the meter control switches, please refer to the
“Multi-information display (color display)” section in your Owne\
r’s Manual.Press the switch left or right to
select menu icons.
Enter
button.
Press the top or bottom
of the switch to change
the displayed content,
scroll up or down, or
move the cursor.Press to return to
the previous screen.
3156598_18a_BRZ_QRG_100217.indd 1710/3/17 8:58 AM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 21 of 33
19
Cruise Control
Increase speed
Push the lever up to the “RES” side;
hold until your vehicle reaches the
desired speed and release. To increase
speed using the accelerator pedal,
press the pedal until you reach the
desired speed. Push the lever down
to the “SET” side to set the speed. Decrease speed
Push the lever down to the “SET”
side; hold until your vehicle slows to
the desired speed and release. To
decrease the speed using the brake
pedal, press the pedal to release cruise
control temporarily. When the speed
decreases to the desired speed, push
the lever down to the “SET” side to set
the speed.
To cancel the cruise control, pull the
lever toward you, push the brake
pedal or press the “ON-OFF” button.
If you have a manual transmission,
you can push in the clutch pedal.
Press the accelerator pedal until
your vehicle reaches the desired
speed. Push the lever down to the
“SET” side and release. Ease off
the accelerator pedal. Your vehicle
will maintain the desired speed.
To activate the cruise control,
press the “ON-OFF” button. The
cruise control indicator light on
the instrument panel will turn
on. To deactivate cruise control,
press the “ON-OFF” button again.
To resume your speed after
canceling, push the lever
up to the “RES” side.Controls
3156598_18a_BRZ_QRG_100217.indd 1910/3/17 8:58 AM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 22 of 33
20
While Operating
Trunk Lid Opener
To open the trunk, press the trunk lid opener switch.
Paddle Shift Control Switches (if equipped)
• Temporary use: Even when the selector is in the
“D” (Drive) position, you can temporarily shift the
gear by pulling the “+” or “–” paddle shift control
switch. The transmission will automatically
switch back to Normal Mode.
• When the selector lever is in Manual Mode,
shift to the next higher gear by pulling the “+” paddle shift cont\
rol switch on the steering
wheel. Pull the “–” paddle shift control switch to shift into the next lower gear.
Manual Shifting Operation
Arrow-shaped lights in the center of the instrument panel show whether an u\
pshift is possible
and whether a downshift is possible.
3156598_18a_BRZ_QRG_100217.indd 2010/3/17 8:59 AM
Page 23 of 33
21
Automatic Transmission Shift Mode (if equipped)
The automatic transmission gives you ultimate control with two different driving
modes: Normal Mode and Manual Mode.
Normal Mode
When the selector lever is in the “D” (Drive) position, the tran\
smission is in Normal
shift mode. The shift position indicator on the instrument panel shows “\
D” and the
transmission automatically shifts into a suitable forward gear.
Manual Mode
In Manual Mode, you select the desired gear position to obtain necessary
acceleration and engine braking. Moving the selector lever left into the\
manual
gate
1 from the “D” (Drive) position causes the transmission to change in\
to
Manual Mode. To shift, use the paddle shift control switches or gear lever. The
shift position indicator shows the selected gear position.
6-Speed Manual Transmission (if equipped)
This manual transmission is a fully synchromeshed
6-forward and 1-reverse speed transmission. Before
you can shift into reverse gear, you must raise the slider
ring and hold it in that position. Only pull the slider ring
up when shifting into reverse gear.
1
While
Operating
3156598_18a_BRZ_QRG_100217.indd 2110/3/17 8:59 AM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 25 of 33
23
Location of Spare Tire and Jack
A spare tire, jack, jack handle, towing eyelet, screwdriver and wheel nut wrench are
stored under the floor of the trunk.
Subaru Roadside Assistance
Subaru Roadside Assistance is free and standard on every 2018 BRZ vehicle.
Coverage is automatic; there are no forms to complete. Subaru Roadside
Assistance is available anytime during the 3-year/36,000-mile Subaru Lim\
ited
Warranty, whichever comes first.* A Subaru Roadside Assistance decal has been \
affixed to the driver’s door window.
Subaru Roadside Assistance: 1-800-261-2155
Exclusions
Specifically excluded from Subaru Roadside Assistance coverage are service
requests or claims resulting from: accidents, vandalism, acts of God, violation
of any laws, misuse and abuse, or vehicle modifications not recommended by
the manufacturer.
*See your Retailer for details.
Safety/In Case of Emergency
3156598_18a_BRZ_QRG_100217.indd 2310/3/17 8:59 AM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 26 of 33
24
Additional Information
Fuel
Use premium unleaded gasoline with an octane rating of 91 AKI or higher. Consult the
Owner’s Manual for more detailed information.
Fuel Capacity
• 13.2 US gal (50 liters, 11 Imp gal)
• When the low fuel indicator light is displayed on the instrument panel, \
approximately
1.8 US gal (7.0 liters, or 1.5 Imp gal) of fuel remain.
• If you have recently fueled your vehicle, the Check Engine light on the
instrument panel may stay on due to a missing or loose fuel filler cap\
(the cap should be tightened until a click is heard).
Fuel Filler Lid Release
The fuel filler lid release is located on the floor to the left of the driver’s seat. To open the fuel
filler lid, pull the fuel filler lever up and release.
3156598_18a_BRZ_QRG_100217.indd 2410/3/17 8:59 AM
