Page 161 of 256
Start and driving
the vehicle resulting in an accident and
considerabl
e damage
.
Page 162 of 256
Page 163 of 256
Page 164 of 256
Driving
Starting when going up a slope
The st eeper the gr
adient, the l
ower the gear
you will need.
When stopping on a slope with a gear range
engaged, the vehicle must be prevented from
rolling backwards by always pressing the
brake pedal or pulling the handbrake lever
up. When starting, release the brake pedal or
the handbrake
Page 165 of 256
Start and driving
In all cases the automatic gearbox must be
check ed at a specialised w
orkshop
.
Automatic gearbox overheating
The automatic gearbox can overheat with a
prolonged start up, or when stopping and
starting continuously. This overheating is dis-
played with a warning lamp in the instru- ment panel. Additionally, an audible warning
can be heard. Stop and let the gearbox cool
Page 166 of 256
Driving
Lock the steering column by removing the key
fr om the ignition when the v
ehicl
e is stopped.Please engage steering lock
Park the vehicle
Page 167 of 256
Start and driving
Run-in and economical driv-
ing Running in Please observe the instructions for running-in
new components.
Running-in the engine
The engine needs t
o be run in o
ver the first
1,500 km. During its first few hours of running,
the internal friction in the engine is greater
than later on when all the moving parts have
bedded down.
How the vehicle is driven for the first 1,500 km
influences the future engine performance.
Throughout the life of the vehicle, it should be
driven at a moderate speed, especially when
the engine is cold, as this will reduce engine
wear and increase its useful life. Never drive
at extremely low engine speeds. Change
down to a lower gear when the engine no
longer runs “smoothly”. Up to 1,000 kilome-
tres the following instructions apply:
Page 168 of 256
Driving
Economical and environmentally
friendly driving Fig. 165
Fuel consumption in litres per 100 km
at 2 diff erent outside t
emperaturesFuel consumption, environmental impact and
engine
, br
ak
e and tyre wear depend largely
on three factors: