Page 129 of 360
Opening and closing
For the sake of the environment
Please dispose of your used batteries cor-
rectly and with r espect f
or the environ-
ment. Synchronising the remote control
key
If it is not possible to unlock or lock the door
with the remot
e contr
ol, it should be re-
synchronised.
While the vehicle is open:
Page 130 of 360

Operation
Note
For anti-theft security, only the driver door
is fitted with a l ock cylinder
.Security system “Safe”*
1)This is an anti-theft device which consists of a
double l
ock f
or the door locks and a deacti-
vation function for the boot in order to prevent
forced entry.
Activation
The “safe” system is activated when the vehi-
cle is locked using the key or the remote con-
trol.
To activate it with the key, rotate once it is in-
serted in the door lock cylinder in the locking
direction.
To activate the system using the remote con-
trol, press the lock button once on the re- mote.
Once this system is activated, opening doors
from the outside and the inside is not possi-
ble. The rear lid can not be opened. The cen-
tral lock button does not work. When the ignition is switched off, the instru-
ment panel display indicat
es that the “Saf
e”
system is on.
Deactivation
Rotate the key inserted in the lock cylinder
twice towards the locking direction.
To activate the system using the remote con-
trol, press the lock button on the remote twice
in less than five seconds.
On deactivating the “Safe” system, the alarm
volumetric sensor is also deactivated.
With the “Safe” switched off, doors can be
opened from the interior but not from the ex-
terior.
See “Selective unlocking system*”
“Safe” status
On the driver door, there is warning lamp visi-
ble from outside the vehicle through the win-
dow which shows the “Safe” system status.
We will know that “Safe” system is activated
by the flashing warning lamp. The indicator
will flash on all vehicles, fitted and nor fitted
with an alarm, until they unlock.
Remember: Safe enabled with or without alarm: con-
tinuous flashing of warning l
amp.
Safe disabled without alarm: the warning
lamp stays off.
Safe disabled with alarm: the warning lamp
stays off. WARNING
No one should remain inside the vehicle if
the “Safe” syst em is activ
ated because
opening the doors will not be possible in
the event of an emergency neither from the
inside nor the outside and help from the
outside is made difficult. Danger of death.
Passengers could become trapped inside
in case of emergency. Selective unlocking system*
This system allows to unlock either just the
driv
er door or all the v
ehicl
e.
Driver door unlock button
Unlock once. Use either the key or the remote
control.
Once the key is inserted in the lock cylinder,
rotate once in the unlock direction. The driver
door will remain without “Safe” and unlocked. 1)
Available depending on market and version.
128
Page 131 of 360
Opening and closing
In vehicles fitted with an alarm, see the Anti-
theft Al arm section
Page 132 of 360
Page 133 of 360
Opening and closing
Once the doors have been locked, they can-
not be opened again immediat ely. This will
enabl e you t
o check that the doors are prop-
erly closed.
If you wish, when unlocking, you can unlock
only the driver
Page 134 of 360
Operation
What happens when locking the vehicle
with a second k ey
If ther e is a v
ehicle key inside the vehicle and
it is locked from the outside with a second ve-
hicle key, the key inside the vehicle is blocked
for engine ignition
Page 135 of 360
Opening and closing
recommends visiting a SEAT dealership for
this.
Page 136 of 360
Operation
flash along with the turn signals, indicating
that the al arm and the l
ocking securit
y sys-
tem (double lock) have been turned on.
If any of the doors or the bonnet are open,
they will not be included in the protection
zones of the vehicle when the alarm is con-
nected. If the door or the bonnet are subse-
quently closed, they will be automatically in-
cluded in the protection areas of the vehicle
and the turn signals will flash accordingly
when the doors close.