2018 PEUGEOT EXPERT key

60
Changing the battery
Battery type: CR2032 / 3 volts.
T his replacement battery is available from a
PEUGEOT dealer or a qualified workshop.
A message is displayed in the instrument panel
screen when replacement of the battery is
needed.
Do not throw the remote control
batteries away, they contain metals
which are harmful to the environment.
Take them to an approved collection
point.
F

U
nclip the cover using a small screwdriver
at the cut-out.
F

R
emove the cover.
F

R
emove the dead battery from its
compartment.
F

F
it the new battery into its compartment
observing the original fitting direction.
F

C
lip the cover onto the casing. Lost keys, remote control
Go to a PEUGEOT dealer, taking with you the
vehicle's registration certificate, your personal
identification documents and if possible, the
label bearing the key code.
The PEUGEOT dealer will be able to retrieve
the key code and the transponder code
required to order a new key.
Remote control
The high frequency remote control is a
sensitive system; do not operate it while it is
in your pocket as there is a possibility that
it may unlock the vehicle, without you being
aware of it.
Do not repeatedly press the buttons of your
remote control out of range and out of sight
of your vehicle. You may stop it from working
and the remote control would have to be
reinitialised.
The remote control does not operate when
the key is in the ignition, even when the
ignition is switched off.
Locking the vehicle
Driving with the doors locked may make
access to the passenger compartment by
the emergency ser vices more difficult in an
emergency.
As a safety precaution (with children on
board), remove the key from the ignition or
take the remote control with you when leaving
the vehicle, even for a short time.Electrical interference
The
K eyless Entry and Starting remote
control may not operate if close to certain
electronic devices: telephone, laptop
computer, strong magnetic fields, etc.
Anti-theft protection
Do not make any modifications to the
electronic engine immobiliser system; this
could cause malfunctions.
Do not forget to turn the steering to engage
the steering lock.
When purchasing a second-hand vehicle
Have the key codes memorised by a
PEUGEOT dealer, to ensure that the keys in
your possession are the only ones which can
start the vehicle.
Access

61
Accumulations (water, dust, grime, salt,
etc.) on the inner sur face of the door
handle may affect detection.
If cleaning the inner sur face of the door
handle using a cloth does not restore
detection, contact a PEUGEOT dealer or a
qualified workshop.
A sudden splash of water (stream of water,
high pressure jet washer, etc.) may be
identified by the system as the desire to
open the vehicle.Locking/unlocking from
inside
Locking the vehicle
This button is inoperative if the vehicle
has been locked or deadlocked from
outside (using the key, remote control or
Keyless Entry and Starting, depending
on equipment) or if one of the opening
elements is still open.
Automatic
The cab doors lock automatically while driving
(speed above 6 mph (10 km/h)); the indicator
lamp comes on.
F

T
o activate or deactivate this
function, with the ignition on,
press this button until a message
appears in the screen.
Manual
The indicator lamp comes on to confirm the
locking.
When carrying long objects with the
tailgate or rear doors open, you can press
this button to lock just the cab doors.
When locking from inside, the door mirrors
do not fold.
Driving with the doors locked could make
it difficult for the emergency ser vices to
enter the vehicle in an emergency.
If the vehicle is deadlocked or locked with
the remote control or the door handles,
the button is not operational. Then, use
the key or remote control to unlock. F

P
ress this button.
2
Access

62
F Press this button.
The indicator lamp also goes off when
unlocking one or more doors.
Locking/unlocking the
loading area
This button is unavailable if the vehicle
has been locked or deadlocked from
outside (using the key, remote control or
Keyless Entry and Starting, depending
on equipment) or if one of the opening
elements is still open.
Unlocking the vehicle
The indicator lamp goes off to confirm the
unlocking.
Automatic
Manual
Cab and loading area selectivity
disabled.
F

W
ith the vehicle unlocked, press
this button.
F

W
ith the vehicle locked, press
this button.
Cab and loading area selectivity
enabled.
F

W
ith the loading area unlocked,
press this button.
The loading area
is always locked when
driving.
The indicator lamp comes on to confirm the
vehicle i s locked.
The indicator lamp goes off to confirm the
vehicle is unlocked.
The indicator lamp comes on to confirm that
the loading area is locked. F

W
ith the loading area locked,
press this button.
Driving with the doors locked could make
it difficult for the emergency ser vices to
enter the vehicle in an emergency.
The indicator lamp also goes off when
unlocking one or more opening elements
of the loading area .
For energy efficiency purposes, with the
ignition off and vehicle fully locked, the
indicator lamp goes off.
For more information on the Key, Remote
control or

K
eyless Entr y and Star ting,
and in particular programming the
selective locking of the loading area, refer
to the corresponding section.
The indicator lamp goes off to confirm that the
loading area
is unlocked.
To deactivate the automatic locking
function, go to a PEUGEOT dealer or a
qualified workshop.
Access

63
Front doors
Opening
From outside
F After unlocking the vehicle (using the key, remote control or K eyless Entry and
Starting, depending on equipment), pull the
door handle.
For more information on the Key, Remote
control or

K
eyless Entr y and Star ting ,
and in particular unlocking the vehicle,
refer to the corresponding section.
From inside
If the door is unlocked, pull the handle to
open the door.
The interior door controls do not operate
when the vehicle is deadlocked.
Vehicle locked.
Cab and loading area selectivity
deactivated and vehicle locked.
Cab and loading area selectivity
activated and vehicle locked.
F

P

ull the interior control lever on a door to
totally unlock the vehicle and open the
d o o r.
F

P

ull the interior control lever on a door to
unlock the cab and open the door. F

P
ull the interior control lever on a door to
totally unlock the vehicle and open the
d o o r.
2
Access

64
Closing
F Push or pull the door to close it, then lock it.When a door is not closed correctly:
-

w
ith the vehicle stationary and the
engine running, this warning lamp
comes on, accompanied by an
alert message for a few seconds,
-

w
ith the vehicle moving (speed
above 6
mph (10 km/h)), this
warning lamp comes on,
accompanied by an audible signal
and an alert message for a few
seconds.
For more information on the Key, Remote
control or

K
eyless Entr y and Star ting ,
and in particular unlocking the vehicle,
refer to the corresponding section.
Manual sliding side
d o o r (s)
From outside
F After unlocking the vehicle (using the key, remote control or K eyless Entry and
Starting, depending on equipment), pull the
door handle.
For more information on the Key, Remote
control or

K
eyless Entr y and Star ting ,
and in particular unlocking the vehicle,
refer to the corresponding section.From inside
To hold the sliding side door in the open
position, open the door fully to engage the
latch (located at the bottom of the door).
Take care not to block the guide space
on the floor to allow the door to slide
c o r r e c t l y.
As a safety measure and for functional
reasons, do not drive with the sliding side
door open.
Access

66
From inside
F Push the handle for ward to close the door, and, if necessary, lock the vehicle. For more information on the Key, Remote
control or

K
eyless Entr y and Star ting
,
and in particular unlocking the vehicle,
refer to the corresponding section.
If a sliding side door is not fully closed:
-
w
ith the vehicle stationary and the
engine running, this warning lamp
comes on, accompanied by an
alert message for a few seconds,
-
w
ith the vehicle moving (speed
above 6 mph (10 km/h)), this
warning lamp comes on,
accompanied by an audible signal
and an alert message for a few
seconds.
Electric sliding side
d o o r (s)
The exterior and interior door handles and the
interior buttons allow the electrically powered
movement of the door to be started.
Opening and closing of the doors is
accompanied by an audible signal.
Opening
From outside
Using the remote control
F With the door unlocked, press and hold this button until the
corresponding sliding side door
has opened.
Access

67
F Press this button again to reverse the movement of the
d o o r.
The remote controls buttons are not active
with the ignition switched on.
Using the handle
F With the door unlocked, pull and release the handle to start the electrically powered
opening of the door.
F

P
ull the handle again to reverse the
movement of the door.
From inside
Using the handle
Vehicle locked
Cab and loading area selectivity
deactivated.
F

P

ull the handle toward the rear to fully
unlock the vehicle and start the electrically
powered opening of the door.
Vehicle unlocked
Child lock deactivated.
From inside, total unlocking
then opening
Cab and loading area selectivity
activated.
F

P

ull the handle toward the rear to unlock
the loading area and start the electrically
powered opening of the door. Cab
and loading area selectivity
deactivated.
For more information on the Key, Remote
control or K eyless Entr y and Star ting
,
and in particular the total or selective
unlocking, refer to the corresponding
section.
F

P
ull the handle toward the rear to start the
electrically powered opening of the door.
2
Access

68
Using the button(s) at the front
F To unlock the vehicle and start the
electrically powered opening of a door,
press the button for the corresponding door.
F

P
ressing the button again reverses the
movement of the door.
The button is not operational and pressing
it results in an audible signal, if:
-

t
he vehicle is moving,
-

t
he vehicle has been locked or
deadlocked from outside (using
the key, remote control or Keyless
Entry and Starting, depending on
equipment).
Depending on the equipment you have,
the button for the left-hand door is not
operational and pressing it results in an
audible signal if the fuel filler flap is open.
From inside, selective
unlocking then opening
Using the button(s) at the front
F To unlock only the loading area and start
the electrically powered opening of a door,
press the button for the corresponding door.
F

P
ressing the button again reverses the
movement of the door. The button is not operational and pressing
it results in an audible signal, if:
-

t
he vehicle is moving,
-
t
he vehicle has been locked or
deadlocked from outside (using
the key, remote control or Keyless
Entry and Starting, depending on
equipment).
Depending on the equipment you have,
the button for the left-hand door is not
operational and pressing it results in an
audible signal if the fuel filler flap is open.
From inside, unlocking then
opening
For more information on the Child lock ,
refer to the corresponding section.
Cab
and loading area selectivity
activated.
For more information on the Key, Remote
control or

K

eyless Entr y and Star ting
,
and in particular the total or selective
unlocking, refer to the corresponding
section.
Access