Page 50 of 324

48
For vehicles that are fitted with it, interior 
volumetric monitoring is incompatible with 
programmed thermal preconditioning.
Anti-tilt monitoring
(On GT and GTi versions)
The system checks for any change in the 
attitude of the vehicle.Self-protection function
The system checks for the putting out of 
ser vice of its components.
The alarm is triggered if the siren's 
battery, button or wiring is disconnected or 
damaged.
For all work on the alarm system, contact 
a PEUGEOT dealer or a qualified 
workshop.
Locking the vehicle with full 
alarm system
Activation
F Switch off the ignition and get out of the vehicle.
F Lock the vehicle using the remote 
control.
or
F
 
L
ock the vehicle using the "
 K
 eyless Entry 
and Starting" system. interior volumetric monitoring after 45
  seconds.
If an access (door, boot, bonnet, etc.) is not 
properly closed, the vehicle is not locked but 
monitoring will be activated after 45   seconds.
Deactivation
F Press this unlocking button on the 
remote control.
or
F
 
U
nlock the vehicle using the "
 K
 eyless Entry 
and Starting" system.
The monitoring system is deactivated: the 
indicator lamp in the button goes off and the 
direction indicators flash for about 2
  seconds.
Where the vehicle locks itself again 
automatically (occurs 30
  seconds after 
unlocking, if a door or the boot is not 
opened), the monitoring system is not 
reactivated automatically.
To reactivate it, the vehicle must be 
unlocked and locked again, using the 
remote control key or the "
 K
eyless Entry 
and Starting" system.
Alarm
This system protects and provides a deterrent 
against theft and break-ins.
It provides the following types of monitoring:
Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a 
door, the boot or the bonnet.
Interior volumetric
The system checks for any variation in the 
volume of the passenger compartment.
The alarm is triggered if anyone breaks a 
window, enters the passenger compartment or 
moves inside the vehicle.
The monitoring system is active: the indicator 
lamp in this button flashes once per second 
and the direction indicators come on for about 
2
 
seconds.
After an instruction to lock the vehicle using 
the remote control or the "
 K
eyless Entry 
and Starting" system, the exterior perimeter 
monitoring is activated after 5
  seconds, the 
The alarm is triggered if the vehicle is lifted, 
moved or knocked. 
Access  
     
        
        Page 178 of 324

176
Trailers with LED lamps are not 
compatible with the wiring harness of this 
device.
To know the Technical data , and, in 
particular, the towable weights for your 
vehicle, refer to the corresponding section.
To ensure complete safety while driving 
with a To w b a r  d e v i c e , refer to the 
corresponding section.
Fitting the towball
A. Locked  position (the green  marks are 
opposite each other); the locking wheel is 
in contact with the towball (no gap).
B. Unlocked  position (red mark opposite the 
green  mark); the locking wheel is no longer 
in contact with the towball (gap of around 
5
 
m m). F
 
B
 elow the rear bumper, remove the 
protective plug 2 from the towball carrier 1 .
F
 
I
 nsert the end of towball 5 into carrier 1 and 
push it upwards; the locking will take place 
automatically. F
 T he locking wheel 6 turns a quarter of a 
turn anti-clockwise; take care to keep your 
hands clear!
F
 
C
 heck that the mechanism has correctly 
locked in to place (position A ).
F
 
C
 lose the lock 7 using the key. 
Practical information  
     
        
        Page 193 of 324

191
Access to the AdBlue® tank 
via the boot
Filling the AdBlue® tank is an operation 
included in every routine ser vice on your 
vehicle by a PEUGEOT dealer or a qualified 
workshop.
Nevertheless, given the capacity of the tank, it 
may be necessary to top up the fluid between 
ser vices, as soon as an alert (warning lamps 
and a message) indicates it.
You can go to a PEUGEOT dealer or a qualified 
workshop.
If you intend to do the topping-up yourself, 
read the following procedure carefully.
The supply in a non-drip bottle simplifies 
topping up.
F
 
S
witch off the ignition and remove the key. F
 
W
 orking inside the boot, lift the carpet and 
then, depending on the equipment, lift out 
the spare wheel and/or the storage well.
F
 
W
 ithout pressing, turn the black cap a 
quarter turn anti-clockwise and lift it off.
F
 
T
 urn the blue cap anti-clockwise.
F
 
O
 btain non-drip bottles of AdBlue
®. After 
first checking the use-by date, carefully 
read the instructions for use on the label 
before pouring the contents of the bottle into 
your vehicle's AdBlue
® tank.
F
 A
fter filling, per form the same operations in 
reverse order.
With subwoofer
- Carefully disengage the wiring harness from  its housing to give a little more free cable 
length.
-
 
U
 ndo the central nut and remove the 
fastener (nut and bolt).
F
 
P
 lace the subwoofer to the side of the boot.
7 
Practical information