2018 Peugeot 301 boot

2
.
.
Instrument panel 8
W arning and indicator lamps 9
I
ndicators

19
AdBlue
® fluid range indicators 2 1
Distance recorders 2 4
Date and time adjustment

2
4
Trip computer

2
6Remote control

2
9
Alarm
3
2
Doors

33
Boot
3
4
Locking from the inside
3
5
Window controls
3
6
Instruments and controls
4
F
ront seats
3
7
Rear bench seat
3
9
Steering wheel adjustment
4
0
Mirrors
4
0
Heating/Ventilation
4
1
Manual air conditioning (without display
screen) 4 2
Electronic air conditioning (with display
screen)
4

4
Front demist – defrost

4
5
Rear screen demist – defrost

4
6
Fittings
4

8Lighting control stalk

5
1
Direction indicators
5
3
Headlamp adjustment
5
4
Wiper control stalk
5
4
Courtesy lamps
5
5
General safety recommendations
5
7
Hazard warning lamps
5
8
Horn

58
Emergency or assistance call
5
8
Electronic stability control (ESC)
6
0
Seat belts 6 2
Airbags 6 5
Child seats

6
8
Deactivating the passenger's front airbag
7

0
ISOFIX mountings and child seats
7

5
Child lock

7
9
InstrumentsAccess
Over view
Ease of use and comfort Lighting and visibility
Safety
Eco-driving
Eco-driving 6
Contents

7
Limit the causes of excess
consumption
Spread loads throughout the vehicle; place
the heaviest items in the bottom of the boot,
as close as possible to the rear seats.
Limit the loads carried in the vehicle and
reduce wind resistance (roof bars, roof rack,
bicycle carrier, trailer, etc.). Preferably, use a
roof box.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and
refit your summer tyres.
Observe the recommendations
on maintenance
Check the tyre pressures regularly, when cold,
referring to the label in the door aperture,
driver's side.
Carry out this check in particular:
-
b
efore a long journey,
-

a
t each change of season,
-

a
fter a long period out of use. Have your vehicle ser viced regularly (engine
oil, oil filter, air filter, cabin filter, etc.) and
obser ve the schedule of operations in the
manufacturer's service schedule. Do not forget the spare wheel and the tyres on
any trailer or caravan.
With a BlueHDi Diesel engine, if the SCR
system is faulty, your vehicle becomes
polluting. Visit a PEUGEOT dealer or a
qualified workshop as soon as possible to
make your vehicle’s level of nitrogen oxide
emissions compliant to the standard.
When filling the tank, do not continue after the
3
rd cut-off of the nozzle to avoid over flow.
At the wheel of your new vehicle, it is only
after the first 1,900
miles (3,000 kilometres)
that you will see the fuel consumption settle
down to a consistent average.
.
Eco-driving

11
Door(s) open/
Boot openFixed, if the speed is
below 6 mph (10 km/h).A door or the electric opening boot is
still open. Close the door or boot.
Fixed, accompanied by an
audible signal if the speed
is above 6
mph (10 km/h).
Engine fault Fixed red. The engine has a major fault causing
a breakdown. You must stop as soon as it is safe to do so.
Park, switch off the ignition and call a PEUGEOT
dealer or a qualified workshop.
Battery charge
Fixed. The battery charging circuit has a
fault (dirty or loose terminals, slack
or cut alternator belt etc.). The warning lamp should go off when the engine is
started.
If it does not go off, contact a PEUGEOT dealer or a
qualified workshop.
Engine oil
pressure Fixed.
There is a fault with the engine
lubrication system. You must stop as soon as it is safe to do so.
Park, switch off the ignition and contact a PEUGEOT
dealer or a qualified workshop.
Maximum
coolant
temperature Fixed red.
The temperature of the cooling
system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up to the required level, if necessary.
If the problem persists, contact a PEUGEOT dealer or
a qualified workshop.
Warning/indicator lamp
StateCause Action/Observations
1
Instruments

29
Remote control
System which permits central unlocking or
locking of the vehicle using the door lock or
from a distance.
It also ensures locates and starts the vehicle,
as well as providing theft protection.
Unfolding/Folding the key
Complete unlocking
With the key
F Turn the key towards the front of the vehicle.
With the remote control
F Press this button to unlock the vehicle .
Unlocking is confirmed by rapid flashing
of the direction indicators for around two
seconds.
Selective unlocking
Complete unlocking is activated by default. With the touch screen, it is possible
to activate or deactivate the selective
unlocking from the Driving/Vehicle
menu.
With the remote control
F To unlock the driver's door o n l y,
press this button once.
F

T
o unlock the other doors and
the boot , press this button again. Unlocking is confirmed by rapid flashing
of the direction indicators for around two
seconds.
Normal locking
With the key
F Turn the key in the driver's door lock
towards the rear of the vehicle to lock it.
Check that the doors and boot are fully
closed.
With the remote control
F Press this button to lock the vehicle.
F

P

ress this button to unfold or fold the key.
With the audio system, the complete
or selective boot unlocking parameter
is set via the Personalisation-
configuration
menu. F
P
ress this button for more than
one second to unlock the boot.
The boot opens slightly.
This action unlocks the vehicle first.
Unlocking and partial
opening of the boot
2
Access

30
Locking is confirmed by continuous lighting of
the direction indicators for approximately two
seconds.If one of the doors or the boot is still open,
the central locking does not work; the
vehicle locks, then immediately unlocks,
identifiable by the locks making a rebound
sound.
When the vehicle is locked, if it is
unlocked inadvertently, it will lock again
automatically after thirty seconds unless a
door or the boot is open.
Locating your vehicle
This function allows you to identify your vehicle
from a distance, particularly in poor light. Your
vehicle must be locked. F

P
ress the closed padlock button
on the remote control.
This will switch on the courtesy lamps and the
direction indicators will flash for a few seconds.
Fault with the remote
control
In the event of a malfunction of the remote
control, you can no longer unlock, lock or
locate your vehicle.
F

F
irst of all, use the key in the door lock to
unlock or lock your vehicle.
F

T
hen reinitialise the remote control.
Reinitialisation
F Switch off the ignition and remove the key from the switch.
F

P
ress the closed padlock button for a few
seconds.
F

R
eturn the key to position 2 ( ignition on).
F

S
witch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Changing the battery
Battery type: CR2032/3 volts.
If the battery is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen. F

U
nclip the cover by inserting a small
screwdriver in the slot.
F
R
emove the cover.
F
R
emove the flat battery from its
compartment.
F
F
it the new battery into its compartment
observing the original fitting direction.
F
C
lip the cover onto the casing.
Access

32
Alarm
System which protects and provides a deterrent
against theft and break-ins. It provides
perimeter protection and a self-protection
function.
Perimeter protection
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet, etc.Self-protection function
The system checks for the putting out of
ser vice of its components.
The alarm is triggered if the battery, the
central control or the siren wiring are put
out of ser vice or damaged.
For all work on the alarm system, contact
a PEUGEOT dealer or a qualified
workshop.
Locking the vehicle with
alarm
Activation
F Press the locking button on the remote control.
The alarm is activated: an indicator
lamp in the switch panel to the left of
the steering wheel flashes once per
second.
Deactivation
F Press the unlocking button on the remote control.
The alarm is deactivated: the
indicator lamp goes off.
Triggering of the alarm
F Turn the vehicle off and exit.
The perimeter protection is activated 5
seconds
after pressing the locking button on the remote
control.
If an opening (door, boot, etc.) is not closed
fully, the vehicle will not be locked, but the
alarm will be activated. When the vehicle is unlocked using
the remote control, rapid flashing of
the indicator lamp informs you that
the alarm was triggered during your
absence. Upon ignition, this flashing
stops immediately.
This is indicated by sounding of the siren and
flashing of the direction indicators for thirty
seconds.
Locking the vehicle without
activating the alarm
F Lock the vehicle using the key.
Failure of the remote control
To deactivate the monitoring functions:
F
U nlock the vehicle using the key.
F

O
pen the door; this sets off the alarm.
F

S
witch on the ignition; this stops the alarm.
Operating fault
When the ignition is switched on, continuous illumination
of the indicator lamp indicates a fault with the system.
Have it checked by a PEUGEOT dealer or a qualified
workshop.
Access

33
Doors
Opening
From outside
From inside
Closing
When a door is not closed correctly:-
w
hen the engine is running ,
this warning lamp comes on,
accompanied by a message in
the multifunction screen for a few
seconds,
-

w
hen the vehicle is moving
(speed higher than 6
mph
(10
km/h)), this warning lamp
comes on, accompanied by an
audible signal and a message in
the multifunction screen for a few
seconds.
Emergency release
For mechanically locking and unlocking the
doors in the event of a fault with the central
locking system or a battery failure.
Driver's door
Insert the key in the door lock to lock or unlock
the door.
Passenger doors
F On the rear doors, check that the child lock is not on.
F

A

fter unlocking the vehicle using the remote
control or the key, pull the door handle.
F

P

ull the interior opening control of a door;
this unlocks the whole vehicle. F

R
emove the black cap on the edge of the
door, using the key.
F

I
nsert the key in the socket without forcing
it, then without turning it, move the latch
sideways towards the inside of the door.
F

R
emove the key and refit the cap.
In the event of a fault with the central
locking system, it is essential to
disconnect the battery to lock the boot and
so ensure complete locking of the vehicle.
2
Access

34
Boot
Opening
Unlocking and releasing the boot
using the remote control
F Hold the centre button on the remote control down for more
than one second.
The tailgate is released and opens slightly.
Releasing the boot from the
inside
F Press the boot opening button located on the left of the dashboard.
The tailgate is released and opens slightly.
Opening the boot
F Raise the tailgate to its fully open position.
Closing
F Lower the tailgate using one of the interior grab handles.
F

T
hen press the tailgate to close it.
-

w
hen the engine is running ,
this warning lamp comes on,
accompanied by a message in
the multifunction screen for a few
seconds,
-

w
hen the vehicle is moving
(speed higher than 6
mph
(10
km/h)), this warning lamp
comes on, accompanied by an
audible signal and a message in
the multifunction screen for a few
seconds.
Back-up release
System for mechanically unlocking the boot in
the event of a battery or central locking fault.
UnlockingIf the tailgate is not fully closed:
F
F
old the rear seats to gain access to the
lock from inside the boot.
If your vehicle is fitted with a fixed bench
seat, contact a PEUGEOT dealer or a
qualified workshop.
F

I
nsert a small screwdriver into hole A of the
lock to unlock the boot.
In the event of a fault or difficulties felt in
manoeuvring the tailgate when opening
or closing it, have it checked quickly by a
PEUGEOT dealer or a qualified workshop
to stop this issue getting worse and so
causing the tailgate to drop, and serious
injuries.
Access