2018 Peugeot 301 tow

3
.
.
Driving recommendations 80
Starting/switching off the engine 8 1
Parking brake

8
3
Manual gearbox
8

4
Automatic gearbox (EAT6)

8
4
Gear shift indicator

8
8
Stop & Start

8
8
Under-inflation detection
9

1
Speed limiter
9

3
Cruise control

9
5
Rear parking sensors
9

7
Reversing camera
9

9Fuel 1
0 0
Misfuel prevention (Diesel)
1

01
Compatibility of fuels

1
02
AdBlue
® (BlueHDi engines) 1 03
Snow chains 1 06
Load reduction mode

1
07
Energy economy mode
1

07
Changing a wiper blade
1

08
Towing a trailer

1
08
Very cold climate screen(s)

1
09
Advice on care and maintenance
1

09
Roof bars

1
10
B o n n e t
11

2
Engines
1

13
Checking levels

1
13
C h e c k s
11

6
Running out of fuel (Diesel)

1
18
Temporary puncture repair kit
1

18
Spare wheel

1
22
Changing a bulb

1
26
Changing a fuse
1

31
12

V battery
1
35
Towing the vehicle

1
39Characteristics of the engines and towed
loads

1
41
Petrol engines
1
42
Diesel engines 1 43
Dimensions 1 44
Identification markings
1

45
DrivingPractical information
In the event of a breakdown Technical data
Alphabetical index
Audio equipment and telematics
PEUGEOT Connect Nav
PEUGEOT Connect Radio
Audio system Bluetooth
Audio system
.
Contents

6
Eco- driving
Optimise the use of your
gearbox
With a manual gearbox, move off gently
and change up without waiting. During
acceleration, change up early.
With an automatic gearbox, give preference
to automatic mode and avoid pressing the
accelerator pedal heavily or suddenly.
Drive smoothly
Maintain a safe distance between vehicles,
use engine braking rather than the
brake pedal, and press the accelerator
progressively. These practices contribute
towards a reduction in fuel consumption and
CO
2 emissions and also help reduce the
background traffic noise.
Control the use of your electrical
equipment
Before moving off, if the passenger
compartment is too warm, ventilate it by
opening the windows and air vents before
using the air conditioning.
Above 30
mph (50 km/h), close the windows
and leave the air vents open.
Consider using equipment that can help keep
the temperature in the passenger compartment
down (sunroof blind and window blinds, etc.).
Unless it has automatic regulation, switch off
the air conditioning as soon as the desired
temperature has been reached.
Switch off the headlamps and front foglamps
when the ambient light level does not require
their use.
Avoid running the engine before moving off,
particularly in winter; your vehicle will warm up
much faster while driving.
As a passenger, if you avoid connecting your
multimedia devices (film, music, video game
etc.), you will contribute towards limiting the
consumption of electrical energy, and so of
fuel.
Disconnect your portable devices before
leaving the vehicle.
The gear shift indicator invites you to engage
the most suitable gear: as soon as the
indication is displayed in the instrument panel,
follow it straight away.
For vehicles fitted with an automatic gearbox,
this indicator appears only in manual mode. If your vehicle has cruise control, make use of
the system at speeds above 25

mph (40

km/h)
when the traffic is flowing well.
Switch off the demisting and defrosting
controls, if these are not automatically
managed.
Switch off the heated seat as soon as possible.
Eco-driving is a range of everyday practices
that allow the motorist to optimise their fuel
consumption and CO
2 emissions.
Eco-driving

18
Warning/indicator lampStateCause Action/Observations
Front foglamps Fixed. The front foglamps have been
switched on using the ring on the
lighting control stalk. Turn the ring on the lighting control stalk rear wards
once to switch off the front foglamps.
Left-hand
direction
indicator Flashing with audible
signal.
The lighting control stalk has been
moved down.
Right-hand
direction indicatorFlashing with audible
signal.The lighting control stalk has been
moved up.
Dipped beam
headlamps Fixed.
The lighting control stalk is in the
"Dipped beam headlamps" position.
Main beam
headlamps Fixed.
The lighting control stalk has been
pulled towards you. Pull the stalk to return to dipped beam headlamps.
Foot on the
clutch Fixed.
In STOP mode of Stop & Start, the
transition to START mode has been
rejected because the clutch pedal is
not fully pressed down. With a manual gearbox, you must depress the clutch
pedal fully to allow the change to engine START
mode.
Foot on the
brake Fixed.
With an automatic gearbox, you have
forgotten to press the brake pedal to
move out of position P.With the engine running, before releasing the parking
brake you must press the brake pedal to unlock the
automatic gear selector lever and move out of the
position P
.
Instruments

29
Remote control
System which permits central unlocking or
locking of the vehicle using the door lock or
from a distance.
It also ensures locates and starts the vehicle,
as well as providing theft protection.
Unfolding/Folding the key
Complete unlocking
With the key
F Turn the key towards the front of the vehicle.
With the remote control
F Press this button to unlock the vehicle .
Unlocking is confirmed by rapid flashing
of the direction indicators for around two
seconds.
Selective unlocking
Complete unlocking is activated by default. With the touch screen, it is possible
to activate or deactivate the selective
unlocking from the Driving/Vehicle
menu.
With the remote control
F To unlock the driver's door o n l y,
press this button once.
F

T
o unlock the other doors and
the boot , press this button again. Unlocking is confirmed by rapid flashing
of the direction indicators for around two
seconds.
Normal locking
With the key
F Turn the key in the driver's door lock
towards the rear of the vehicle to lock it.
Check that the doors and boot are fully
closed.
With the remote control
F Press this button to lock the vehicle.
F

P

ress this button to unfold or fold the key.
With the audio system, the complete
or selective boot unlocking parameter
is set via the Personalisation-
configuration
menu. F
P
ress this button for more than
one second to unlock the boot.
The boot opens slightly.
This action unlocks the vehicle first.
Unlocking and partial
opening of the boot
2
Access

33
Doors
Opening
From outside
From inside
Closing
When a door is not closed correctly:-
w
hen the engine is running ,
this warning lamp comes on,
accompanied by a message in
the multifunction screen for a few
seconds,
-

w
hen the vehicle is moving
(speed higher than 6
mph
(10
km/h)), this warning lamp
comes on, accompanied by an
audible signal and a message in
the multifunction screen for a few
seconds.
Emergency release
For mechanically locking and unlocking the
doors in the event of a fault with the central
locking system or a battery failure.
Driver's door
Insert the key in the door lock to lock or unlock
the door.
Passenger doors
F On the rear doors, check that the child lock is not on.
F

A

fter unlocking the vehicle using the remote
control or the key, pull the door handle.
F

P

ull the interior opening control of a door;
this unlocks the whole vehicle. F

R
emove the black cap on the edge of the
door, using the key.
F

I
nsert the key in the socket without forcing
it, then without turning it, move the latch
sideways towards the inside of the door.
F

R
emove the key and refit the cap.
In the event of a fault with the central
locking system, it is essential to
disconnect the battery to lock the boot and
so ensure complete locking of the vehicle.
2
Access

39
Rear bench seat
Depending on the version, your vehicle is
equipped with one of these three bench seats:
-
F
ixed bench seat.
-

B
ench seat with fixed one-piece cushion
and split folding backrest (2/3 -1/3) with
fixed head restraints.
-

B
ench seat with fixed one-piece cushion
and split folding backrest (2/3 -1/3) with
adjustable head restraints.
To remove and refit the fixed bench seat,
contact a PEUGEOT dealer or a qualified
workshop.
Folding the backrest
F If necessary, move the corresponding front seat forward.
Returning the backrest to the
normal position
When repositioning the seat backrest,
take care not to trap the seat belts.
Ensure that the backrest has latched
properly into place.
Adjustable head restraints
These have one position for use (up) and a
stowed position (down).
They can be removed and are interchangeable
side to side.
To remove a head restraint:
Never drive with the head restraints
removed; they must be fitted and correctly
adjusted.
F

P
ull the head restraint upwards to the stop.
F

P
ress on lug A .
F

S

traighten the seat backrest 2 and secure it.
F

U

nfasten and reposition the seat belt on the
side of the backrest.
F Position the corresponding seat belt against the backrest and fasten it. F

P
ull the strap 1 to release the seat backrest 2
.
F
F
old the seat backrest 2 on to the cushion.
3
Ease of use and comfort

41
Electric model
Adjustment
F Move control A to the right or to the left to select the corresponding mirror.
F

M
ove the control in all four directions to
adjust.
F

R
eturn the control to the central position.
Manual folding
You can manually fold the mirrors (parking
obstruction, narrow garage, etc.)
F
T
urn the mirror towards the vehicle.
Rear view mirror
Equipped with an anti-dazzle system, which
darkens the mirror glass and reduces the
nuisance to the driver caused by the sun,
headlamps from other vehicles, etc.
Adjustment
F Adjust the mirror so that the mirror is directed correctly in the "day" position.
Day/night position
F Pull the lever to change to the "night" anti-dazzle position.
F

P
ush the lever to change to the normal
"day" position.
Heating/Ventilation
This system operates only with the engine
running.
1 Temperature.
2 A ir f low.
3 Air distribution.
4 Air intake/Air recirculation.
Temperature
F Turn the thumb wheel from
blue (cold) to red (hot) to
modulate the temperature to
your liking.
Air flow
F Turn the thumb wheel to obtain a comfortable air flow.
3
Ease of use and comfort

45
Air distribution
F Press this button repeatedly to direct the air flow towards:
-

w
indscreen and side windows
(demisting or defrosting),
-

w
indscreen, side windows and
air vents,
-

w
indscreen, side windows, air
vents and foot wells,
-

w
indscreen, side windows and
foot wells,
-

f
oot wells,
-

a
ir vents and foot wells,
-

a
ir vents.
Air flow
F Press this button to increase air
f low.
Deactivating the system
F Press this button (for the air flow) until all the bars in the
display are off.
F

P
ress this button to decrease

air f low.
The air flow bars come on progressively. The air flow bars go off progressively.
This action deactivates all functions of the air
conditioning system.
The thermal comfort is no longer controlled. A
slight flow of air can still be felt, resulting from
the for ward movement of the vehicle.
Pressing the button (for the air flow)
again reactivates the system.
Avoid driving for long periods with the
system deactivated (risk of misting and
deterioration of air quality).
Front demist – defrost
These markings on the control panel
indicate the control positions for
rapid demisting or defrosting of the
windscreen and side windows.
With the heating/ventilation
system
F Put the temperature and air flow controls to the appropriately
marked position.
F

P
ut the air intake control to the
"Exterior air intake" position
(manual control moved to the
right).
F

P
ut the air distribution control to
the "Windscreen" position.
3
Ease of use and comfort