2018 Peugeot 208 seat adjustment

2
.
.
Instrument panels 8
W arning and indicator lamps 1 0
Indicators
20
Trip computer

2
4
Setting the time and date

2
6
Lighting dimmer

2
7Remote control key

2
8
Central locking
3
0
Back-up procedures
3
0
Boot

32
Alarm

33
Electric windows
3
4
PEUGEOT i- Cockpit
3
6
Steering wheel adjustment
3

6
Mirrors
36
F

ront seats
3
8
One-piece bench seat
4

0
2/3 -1/3
split rear bench seat
4
0
Head restraints

4
1
Advice on heating and air conditioning

4
1
Heating


42
Manual air conditioning
4

3
Dual-zone automatic air conditioning
4

3
Recirculation of interior air

4
5
Front demisting – defrosting

4
5
Rear screen demisting - defrosting

4
6
Courtesy lamp

4
6
Interior ambient lighting
4

7
Sunroof blind

4
7
Interior fittings

4
8
Boot fittings

4
9
Rear shelf
5

0Lighting control stalk

5
1
Headlamp beam height adjustment
5
4
Cornering lighting
5
5
Wiper control stalk
5
5
Changing a wiper blade
5
7
General safety recommendations
5
8
Hazard warning lamps
5

8
Emergency or assistance call

5
9
Electronic stability control (ESC)

6
0
Seat belts
6

2
Airbags


65
Child seats

6
8
Deactivating the front passenger airbag
6

8
ISOFIX mountings and child seats
7

4
Child lock

7
9
InstrumentsAccess
Over view
Ease of use and comfort Lighting and visibility
Safety
Eco-driving
Instruments and controls 4
Contents

36
PEUGEOT i-Cockpit
Once these adjustments have been made,
make sure that the "head-up" instrument
panel can be viewed correctly over the
smaller diameter steering wheel.
Steering wheel adjustment
For safety reasons, these adjustments
must only be made with the vehicle
stationary.
Mirrors
Door mirrors
As a safety measure, the mirrors should
b e adjusted to reduce the "blind spot".
Manual adjustments
F Operate the lever in the four directions to adjust the angle of the mirror glass.
Folding
F

F
old the mirror manually to protect it when
the vehicle is parked.
F

U
nfold it before moving off again.
They do not have automatic defrosting.
F

W

ith the vehicle stationary
, pull the
control lever to release the steering wheel.
F

A

djust the height and reach to suit your
driving position.
F

P

ush the control lever to lock the adjustment
mechanism.
Before taking to the road and in order to take
advantage of the specific ergonomics of the
PEUGEOT i-Cockpit, adjust it in the following order:
-

t
he height of the head restraint,
-

t
he seat backrest angle,
-
t

he seat cushion height,
-

t
he longitudinal position of the seat,
-
t

he depth and then the height of the steering
wheel,
-

t
he rear view mirror and door mirrors.
Ease of use and comfort

38
Seat backrest angle
F Press the control backwards.
Head restraints
F To raise a head restraint, pull it upwards.
F T o remove it, press the lug A and pull upwards.
F

T
o refit the head restraint back in place,
engage the head restraint rods in the openings
keeping them in line with the seat backrest.
F

T
o lower a head restraint, press the lug A and
push down on the head restraint at the same
time.
The head restraint has a frame with
n otches which prevents it from lowering;
this is a
safety device in case of impact.
The adjustment is correct when the
upper edge of the head restraint is
level with the top of the head.
Never drive with the head restraints
removed; they must be fitted and correctly
adjusted.
In order to ensure optimum visibility during
your manoeuvres, the mirror lightens
automatically when reverse gear is
engaged.
Front seats
Before moving the seat backwards,
ensure that there is nothing that might
prevent the full travel of the seat.
There is a
risk of trapping or pinching
passengers if present in the rear seats
or jamming the seat if large objects are
placed on the floor behind the seat.
Standard seats
Longitudinal adjustment
F Raise the control and slide the seat forwards or backwards.
Height adjustment
F Pull the control upwards to raise or push it downwards to lower, as many times as
necessary to obtain the position required.
Ease of use and comfort

54
Headlamp beam height
adjustment
To avoid causing a nuisance to other road
u sers, the height of the headlamp beams
should be adjusted according to the load in the
vehicle.
0. 1
or 2 people in the front seats.
-. Intermediate setting.
1. 5


people.
-. 5
people + maximum authorised load.
2. Driver + maximum authorised load.
The initial setting is position " 0".
Vehicle side marking by illumination of the
sidelamps on the traffic side only.
F

W

ithin one minute after switching off the
ignition, operate the lighting control stalk up
or down, depending on the traffic side (for
example, when parked on the left, move the
lighting control stalk upwards; the right-hand
sidelamps come on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the middle position or
switch on the ignition.
Parking lamps Daytime running lamps/
Sidelamps
The front and rear lamps light up automatically
when the engine starts.
They provide the following functions:
-

D
aytime running lamps (lighting control
stalk at position " 0" or " AUTO " with
adequate light level).
-

S
idelamps (lighting control stalk at " AUTO"
position with low light levels or "Sidelamps
only" or "Dipped/main beam headlamps").
The LEDs are brighter when operating as
daytime running lamps.
Lighting and visibility

63
Fastening
F Pull the strap then insert the tongue in the buckle.
F

C
heck that the seat belt is fastened
correctly by pulling the strap.
Unfastening
F Press the red button on the buckle.
F G uide the seat belt as it reels in.
Height adjustment
F To raise the attachment point, slide the control A upwards.
Warning lamp
Not fastened/unfastened.
When the ignition is switched on,
this warning lamp comes on in the
instrument panel.
It remains on for a certain time if the front
p assenger has not fastened their seat belt. Once
this period has elapsed, the warning lamp goes off
if the driver's seat belt is fastened.
From approximately 12
mph (20 km/h) this warning
lamp flashes for 2


minutes accompanied by an
audible signal of increasing volume if the driver
and/or the front passenger have not fastened their
seat belt. Once these 2
minutes have elapsed, this
warning lamp remains on until the driver and/or
the front passenger fastens their seat belt.
At the rear
Fastening
F Pull the strap then insert the tongue in the buckle.
F

C
heck that the seat belt is fastened
correctly by pulling the strap.
Unfastening
F Press the red button on the buckle.
F G uide the seat belt as it reels in.
F

O
n the outer seat belts, raise the bar to the
top of the backrest to prevent the tongue
from knocking against the side trim.
F

T

o lower the attachment point, squeeze the
control A and slide it downwards. The rear seats are each fitted with a
three-point
seat belt equipped, for the outer seats, with
a

force limiter.
Warning lamp
Unfastened.
From approximately 12
mph
(20
km/h) and for 2 minutes, this
warning lamp flashes, accompanied
by an audible signal of increasing
volume, when one or more rear
passengers unfasten their seat belt.
Once these two minutes have elapsed, this
warning lamp remains on until one or more rear
passengers fasten their seat belt.
5
Safety

64
Advice
The driver must ensure that passengers
use the seat belts correctly and that they
are all fastened before setting off.
Wherever you are seated in the vehicle,
always fasten your seat belt, even for
short journeys.
Do not interchange the seat belt buckles
as they will not fulfil their role fully.
The seat belts are fitted with an inertia
reel permitting automatic adjustment of
the length of the strap to your size. The
seat belt is stowed automatically when not
in use.
The inertia reels have an automatic
locking device at the time of a collision,
during sudden braking or if the vehicle
turns over. You can release the device by
pulling the strap firmly and then releasing
it so that it reels in slightly.
Before and after use, ensure that the seat
belt is reeled in correctly.
After folding or moving a
seat or rear
bench seat, ensure that the seat belt is
positioned and reeled in correctly. Installation
The lower part of the strap must be
positioned as low as possible on the
pelvis.
The upper part must be positioned in the
hollow of the shoulder.
In order to be effective, a seat belt must:
-

b
e tightened as close to the body as
possible,
-

b
e pulled in front of you with a smooth
movement, checking that it does not
twist,
-

b
e used to restrain only one person,
-

n
ot show any signs of cuts or fraying,
-

n
ot be converted or modified to avoid
affecting its performance.
Recommendations for children
Use a
suitable child seat if the passenger
is less than 12
years old or shorter than
one and a
half metres.
Never use the same seat belt to secure
more than one child.
Never allow a
child to travel on your lap.
For more information on Child seats , refer
to the corresponding section. Maintenance
In accordance with current safety
regulations, for all repairs on your
vehicle's seat belts, go to a
qualified
workshop with the skills and equipment
needed, which a
PEUGEOT dealer is able
to provide.
Have your seat belts checked regularly
by a
PEUGEOT dealer or a qualified
workshop, particularly if the straps show
signs of damage.
Clean the seat belt straps with soapy
water or a
textile cleaning product, sold by
PEUGEOT dealers.
In the event of an impact
Depending on the nature and
seriousness of the impact , the
pyrotechnic pretensioner may be deployed
before and independently of the airbags.
Deployment of the pretensioners is
accompanied by a
slight discharge of
harmless smoke and a
noise, due to the
activation of the pyrotechnic cartridge
incorporated in the system.
In all cases, the airbag warning lamp
comes on.
Following an impact, have the seat
belts system checked and, if necessary,
replaced, by a
PEUGEOT dealer or
a


qualified workshop.
Safety

73
Weight of the child/indicative age
Seat position
Under 13 kg
(
groups 0 (b) and 0+)
Up to about 1
year
oldFrom 9 -18 kg
(g r o u p 1)
From about 1
to
3
years old From 15-25
kg
(group 2)
From about 3
to
6
years old From 22-36
kg
(group 3)
From about 6
to
10
years old
Front passenger seat ( c), ( e) With height
adjustment U(R)
U(R)U(R)U(R)
Without height adjustment U*
U* U* U*
Outer rear seats ( d) UUUU
Centre rear seat ( d) U (f) U (f) U U
U : seating position suitable for the installation
of a

child seat secured using the seat belt and
universally approved "rearward facing" and/or
"forward facing".
U(R) : same as U , with the vehicle seat adjusted
to the highest and rearmost longitudinal
position.
U* : same as U , with the backrest straightened. (
a ) Universal child seat: child seat that can be
installed in any vehicle using the seat belt.
( b ) Group 0: from birth to 10

kg. Carrycots and
"car" infant carriers cannot be installed on the
front passenger seat.
( c ) Refer to the legislation in force in your
country before installing your child on this seat.
( d ) When installing a

child seat on a

rear seat in
a "rear ward facing" or "for ward facing" position,
move the front seat for ward then straighten
the backrest to allow enough room for the child
seat and the child's legs. (
e ) When a "rear ward facing" child seat
is installed on the front passenger seat,
the passenger airbag must absolutely be
deactivated. Otherwise, the child would risk
being seriously injured or killed if the airbag
were deployed.
When a "for ward facing" child seat is installed
on the front passenger seat, the passenger
airbag must remain activated.
( f ) A child seat with support leg must never be
installed on this passenger seat.
5
Safety