2018 Peugeot 208 radio

3
.
bit.ly/helpPSA
.
Driving advice 80
Starting – Switching off the engine 8 1
Parking brake

8
2
Manual gearbox
8

3
Automatic gearbox (EAT6)

8
4
Gear shift indicator

8
6
Hill start assist

87
S

top & Start
87
U

nder-inflation detection
8
9
Speed limiter

9
1
Cruise control

9
3
Memorising speeds

9
5
Active City Brake

9
6
Parking sensors

9
8
Reversing camera
1

00
Park Assist

1
00Compatibility of fuels 1
06
Fuel tank 1 07
Misfuel prevention (Diesel)
1

08
Snow chains

1
08
Towing device

1
09
Load reduction mode

1
09
Energy economy mode
1

10
Fitting roof bars

1
10
B o n n e t


111
Engine


112
Checking levels

1
12
C h e c k s


114
AdBlue
® (BlueHDi engines) 1 17
Warning triangle
1
21
Running out of fuel (Diesel)

1
21
Temporary puncture repair kit
1

22
Spare wheel

1
25
Changing a
bulb
1
29
Changing a


fuse
1
33
12

V battery
1
37
To w i n g


14 0Engine technical data and towed loads

1
42
Engines and towed loads - PETROL
1
43
Engines and towed loads - DIESEL
1
45
Dimensions
1
47
Identification markings
1
48
Driving
Practical information
In the event of a breakdown Technical data
Alphabetical index
Access to additional videos
Audio equipment and telematics
Audio system
Bluetooth audio system
PEUGEOT Connect Radio
PEUGEOT Connect Nav
.
Contents

26
This function is only displayed from
19 mph (30 km/h).
Average fuel consumption
(mpg or l/100 km or km/l)
C alculated since the last trip computer
reset.
Distance travelled
(miles or km)
Calculated since the last trip computer
reset.
Average speed
(mph or km/h) Calculated since the last trip
computer reset.
Total time in stop mode
(minutes/seconds or hours/minutes)
If your vehicle is fitted with Stop & Start, a time
counter adds up the time spent in STOP mode
during a

journey.
It resets to zero every time the ignition is
switched on.
Setting the time and date
Instrument panel
F Each press of this button toggles between the following settings:
-


h o u r,
-


minutes,
-

1
2 or 24 hour format.
With PEUGEOT Connect
Radio
F Select the Settings menu in
the upper banner of the touch
screen.
F

Sel

ect " System configuration ".
F

Sel
ect "Date and time ".
F

Sel

ect " Date " or "Time ".
F

C

hoose the display formats.
F

C

hange the date and/or time using the
numeric keypad.
F

C

onfirm with " OK".
With PEUGEOT Connect
Nav
Setting of the time and date is only available if
synchronisation with the GPS is deactivated.
F

Sel
ect the "Settings " menu.
F

P
ress the " OPTIONS " button to go to the
secondary page.
F

Sel
ect "Setting the time- date".
F

Sel
ect the " Date" or " Time" tab.
F

A
djust the date and time using the numeric
keypad and confirm.
F

I
n the selected tab, press this
key to confirm.
Additional settings
You can choose:
- T o change the date format (DD/MM/ Y Y Y Y,
YYYY/MM/DD, etc.)
-

T
o change the time format (12h/24h).
-

T
o change the time zone.
-

T
o activate or deactivate synchronisation
with the GPS (UTC).
Instruments

49
12 V accessory socket
F To connect a 12 V accessory (maximum
power: 120 watts), lift the cover and plug in
the correct adapter.
Do not exceed the maximum power rating
of the socket (risk of damage to your
accessory).
USB socket
The USB socket allows the connection of
a portable device, such as an iPod®-type digital
audio player, or a

USB memory stick.
The USB reader reads your audio files, which
are then transmitted to your audio system and
played via the vehicle's speakers.
These files are managed via the steering wheel
controls or from the audio system.
When connected to the USB socket,
the portable device can be charged
automatically.
While charging, a message is displayed
if the power consumption of the portable
device exceeds the amperage supplied by
the vehicle.
Boot fittings
1.Rear shelf
2. Hooks
3. Boot lamp
4. Stowing rings (depending on version)
The connection of an electrical device
not approved by PEUGEOT, such as
a

USB charger, may adversely affect the
operation of vehicle electrical systems,
causing faults such as poor radio
reception or inter ference with displays in
the screens.
For more detail on the Audio equipment and
telematics, and particularly the USB socket,
refer to the corresponding part of the audio
equipment section. The USB socket also allows a
smartphone to
be connected by MirrorLink
TM, Android Auto®
or CarPlay®, so that certain applications on the
smartphone can be used on the touch screen.
3
Ease of use and comfort

58
General safety
recommendations
Labels are affixed in different locations on
your vehicle. They include safety warnings
and vehicle identification information. Do
not remove them: they are an integral part
of your vehicle.
For any work on your vehicle, use
a qualified workshop that has the technical
information, skills and equipment required,
all of which a
PEUGEOT dealer is able to
provide.
Depending on country regulations, some
safety equipment may be compulsory:
high visibility safety vests, warning
triangles, breathalysers, spare bulbs,
spare fuses, fire extinguisher, first aid kit,
mud flaps at the rear of the vehicle, etc. We draw your attention to the following
points:
-

T
he fitting of electrical equipment
or accessories not approved by
PEUGEOT may cause excessive
current consumption and faults and
failures with the electrical system of
your vehicle. Contact a
PEUGEOT
dealer for information on the range of
recommended accessories.
-

A
s a safety measure, access to
the diagnostic socket, used for the
vehicle's electronic systems, is
reser ved strictly for PEUGEOT dealers
or qualified workshop, equipped
with the special tools required (risk
of malfunctions of the vehicle's
electronic systems that could cause
breakdowns or serious accidents).
The manufacturer cannot be held
responsible if this advice is not
followed.
-

A
ny modification or adaptation not
intended or authorised by PEUGEOT
or carried out without meeting the
technical requirements defined by
the manufacturer will result in the
suspension of the legal and contractual
warranties. Installation of accessory radio
communication transmitters
Before installing a


radio communication
transmitter, you must contact a PEUGEOT
dealer for the specifications of compatible
transmitters (frequency, maximum power,
aerial position, specific installation
requirements), in line with the Vehicle
Electromagnetic Compatibility Directive
(2004/104/EC).
Hazard warning lamps
F When you press this red button, all four direction indicators flash.
They can operate with the ignition off.
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on
the deceleration, the hazard warning lamps
come on automatically.
Safety

140
Quick-release terminal clamp
Disconnecting the (+) terminalReconnecting the (+) terminal
Do not force the lever as locking will not
be possible if the clamp is not positioned
correctly; start the procedure again.
Before disconnecting
Wait 2 minutes after switching off the ignition
b efore disconnecting the battery.
Close the windows and the doors before
disconnecting the battery.
Following reconnection
After each time that the battery has been
reconnected, switch on the ignition and wait
1
minute before starting the engine, to allow
the electronic systems to initialise. However,
if minor problems persist after this procedure,
contact a
PEUGEOT dealer or a qualified
workshop.
Referring to the corresponding section, you
must yourself reinitialise:
-

t
he remote control key,
-

t
he date and time,
-

t
he radio preset stations.
F

Ra

ise the lever A fully to release the
clamp B .
F

R

emove the clamp B by lifting it off. F

Ra

ise the lever A fully.
F

R

efit the open clamp B on the (+) terminal.
F

P

ush the clamp B fully down.
F

L

ower the lever A to lock the clamp B .
To w i n g
Procedure for having your vehicle towed or for
towing another vehicle using the towing eye.
F

s

witch off all electrical consumers (audio
system, wipers, lighting, etc.),
F

s

witch off the ignition and wait for 4

m

inutes.
At the battery, it is only necessary to
disconnect the (+) terminal.
In the event of a breakdown

1
Audio system
Contents
First steps
1
S

teering mounted controls
2
R

adio
2
M

edia
3
A

udio settings
5
F

requently asked questions
5
F

or safety reasons, the vehicle must
always be stationary for the driver to
perform operations that require close
attention.
When the engine is switched off and to
prevent discharging of the battery, the
system switches off after activation of
energy economy mode.First steps
On/Off, volume adjustment.
Select the source:
FM1, FM2, AM, CD, AUX.
Adjust audio settings:
sound ambience, treble, bass,
loudness, left/right balance,
automatic volume.
Automatic search for a
lower radio
frequency.
Select the previous CD track.
Scroll in a
list.
Press and hold: rewind. Display the list of stations received,
the CD/MP3
tracks or folders.
Press and hold: update the list of
stations received.
Manual search step by step for
a

higher radio frequency.
Select the next MP3 folder.
Scroll in a list.
Manual search step by step for
a lower radio frequency.
Select the previous MP3 folder.
Scroll in a list.
Cancel the current operation.
Go up one level (menu or folder).
Automatic search for a
higher radio
frequency.
Select the next CD track.
Scroll in a
list.
Press and hold: fast for ward.
Access to the main menu.
Select a


preset radio station.
Radio, press and hold: store
a


station.
Eject CD.
.
Audio system

2
Steering mounted controls
Radio: select the previous/next
preset radio station.
Select the previous/next item in
a menu.
Radio: automatic search for a
higher
frequency.
CD/MP3: select the next track.
CD: press and hold: fast for ward.
Change the audio source.
Confirm a


selection.
Radio: automatic search for a
lower
frequency.
CD/MP3: select the previous track.
CD: press and hold: rewind.
Increase volume.
Decrease volume.
Mute on: cut the sound by
simultaneously pressing the volume
up and down buttons.
Mute off: press one of the two
volume buttons.
Radio
Presetting a station
Press the SRC/BAND button
repeatedly to select the FM1, FM2 or
AM waveband.
Press and hold a
button to preset
the station being listened to. The
name of the station is displayed and
an audible signal confirms that it has
been preset.
The external environment (hills, buildings,
tunnels, basement car parks, etc.) may
block reception, including in RDS tracking
mode. This is a
normal effect of the way
in which radio waves are transmitted and
does not indicate any failure of the audio
equipment.
Selecting a station
Press a button to listen to the
c orresponding preset station.
Managing the list
Press LIST to display the list of
stations received in alphabetical
o r d e r. Select the desired radio station by
pressing one of the buttons.
Confirm with OK.
Briefly press one of the buttons to
change to the next or previous letter.
Press and hold LIST
to build or
update the list of stations; audio
reception is cut momentarily.
Press MENU .
Select " Radio".
Confirm with OK.
Select " RDS".
RDS
RDS, if displayed, allows you to continue
listening to the same station by automatically
retuning to alternative frequencies. However,
in certain conditions, coverage of an RDS
station may not be assured throughout the
entire country as radio stations do not cover
100% of the territory. This explains the loss
of reception of a
station during a journey.
Audio system

3
Confirm with OK.
Select "On" or " Off" to switch RDS
on or off.
Confirm with OK.
Receiving TA messages
The TA (Traffic Announcement) function
gives priority to TA alert messages.
To operate, this function needs good
reception of a
radio station transmitting
this type of message. When a
traffic
report is transmitted, the current audio
source (radio, CD, etc.) is interrupted
automatically to play the TA message.
Normal playback resumes at the end of
the transmission of the message.
Press MENU .
Select "Radio ".
Confirm with OK.
Select " Traffic TA ".
Confirm with OK. Select "
On" or " Off" to activate or
deactivate the reception of traffic
messages.
Confirm with OK.
Displaying RADIO TEXT
Radio Text is information transmitted by
the radio station related to the current
programme or song.
Press MENU .
Select " Radio".
Confirm with OK.
Select " INFO TEXT ".
Confirm with OK.
Select " On" or " Off" to switch Radio
Text on or off.
Confirm with OK.
Media
Auxiliary socket (AUX)
Connect a portable device (MP3 player, etc.) to
t he auxiliary Jack socket using an audio cable
(not supplied).
Press the SRC/BAND button
repeatedly until the " AUX" source is
displayed.
First adjust the volume on your portable device
(to a
high level). Then adjust the volume of your
audio system. Management of the controls is
via the portable device.
CD player
Insert a CD in the player; play begins
au tomatically.
Insert an MP3
compilation in the CD player.
The audio system searches for all of the music
tracks, which may take anything between a
few
seconds and several tens of seconds, before
play begins.
.
Audio system