2018 Peugeot 208 spare wheel

126
Wheel with trim
When refitting the wheel, refit the trim
starting by placing its notch facing the
valve and press around its edge with the
palm of your hand.
All of these tools are specific to your
vehicle and may vary depending on
equipment.
Do not use them for any other purposes.
The jack must only be used to change
a wheel with a damaged or punctured tyre.
Do not use any jack other than the one
supplied with this vehicle.
If the vehicle does not have its original jack,
contact a
PEUGEOT dealer or a qualified
workshop to obtain the correct jack for it.
The jack meets European standards,
as defined in the Machinery Directive
2006/42/CE.
The jack does not require any
maintenance.
Access to the spare wheel
Removing the wheel
F Raise the spare wheel towards you from the r e a r.
F

T
ake the wheel out of the boot.
Putting the wheel back in place
F Put the wheel back in its housing.
F

S
lacken the nut on the bolt by a few turns.
F

P
osition the fixing device (nut and bolt) in
the middle of the wheel.
F

T
ighten fully until the central nut clicks, to
retain the wheel correctly.
F

P
ut the carrier box back in place in the
centre of the wheel and clip it.
If there is no wheel in the well, the fixing
device (nut and bolt) cannot be put back
in place.
The spare wheel is installed in the boot under
t h e f l o o r.
According to country, the spare wheel may be
steel, alloy or of the "space-saver" type.
F

Sl

acken the central nut.
F

R

emove the fixing device (nut and bolt).
In the event of a breakdown

127
Removing a wheel
Parking the vehicle
Immobilise the vehicle where it does not
block traffic: the ground must be level,
stable and non-slippery.
Apply the parking brake.
Switch off the ignition.
With a

manual gearbox, engage first gear
to block the wheels.
With an automatic gearbox, place the
lever in position P to block the wheels.
Check for the fixed illumination of the
parking brake indicator lamps in the
instrument panel.
The occupants must get out of the vehicle
and wait where they are safe.
Never go underneath a
vehicle raised
using a
jack; use an axle stand.
List of operations
F Place the foot of the jack 2 on the ground
and ensure that it is directly below the front
A or rear B jacking point provided on the
underbody, whichever is closest to the
wheel to be changed.
F Remove the bolt cover from each of the bolts using the tool 3 (depending on equipment).
F

F
it the security socket 4 on the wheelbrace
1
to slacken the security bolt (depending on
equipment).
F

S
lacken the other bolts using the
wheelbrace 1
o n l y.
Ensure that the jack is stable on a sur face
t hat is not loose or slippery and positioned
strictly at jacking points A or B under the
vehicle, making sure that the jack head is
centred at the contact point on the vehicle.
Other wise, there is a
risk of damage to
the vehicle and/or of the jack collapsing or
slipping – risk of injury!
F Extend the jack 2 until its head comes
into contact with the jacking point A or B ,
whichever is used; the contact area A or B
on the vehicle must be correctly inserted into
the central part of the head of the jack.
F

Ra
ise the vehicle until there is sufficient
space between the wheel and the ground to
admit the spare (not punctured) wheel easily.
F Remove the bolts and store them in a clean
place.
F

R
emove the wheel.
8
In the event of a breakdown

128
Fitting the wheelList of operations
Fitting a steel or "s pace-saver" spare
wheel
If your vehicle is fitted with alloy wheels,
when tightening the bolts on fitting it is
normal to notice that the washers do not
come into contact with the steel or "space-
saver" spare wheel. The wheel is secured
by the conical contact of each bolt.
F Put the wheel in place on the hub.
F S crew in the bolts by hand as far as possible.
F

P
re-tighten the security bolt using
wheelbrace 1
fitted with security socket
4
(depending on equipment).
F

P
re-tighten the other bolts using wheelbrace
1
o n l y.
F Lower the vehicle again fully.
F F old jack 2 and remove it. F

T
ighten the security bolt using wheelbrace
1 fitted with security socket 4 (depending on
equipment).
F
T
ighten the other bolts using wheelbrace
1 o n l y.
F
R
efit the bolt covers on each of the bolts
(depending on equipment).
F
S
tore the tools in the carrier box.
In the event of a breakdown

129
After changing a wheel
To store the punctured wheel in the boot
correctly, first remove the central cover.
If your vehicle has a "standard" 15 -inch
spare wheel, do not exceed 50
mph
(80


km/h).
If your vehicle is fitted with 16
or 17-inch
wheels, use the "space-saver" type
spare wheel and do not exceed 50
mph
(80


km/h).
Visit a
PEUGEOT dealer or a qualified
workshop as soon as possible to have the
tightness of the bolts and the pressure of
the spare wheel checked.
Have the punctured tyre examined. After
inspection, the technician will advise you
on whether the tyre can be repaired or if it
must be replaced.Changing a bulb
The lamps have polycarbonate lenses with
a
protective coating:
F

d
o not clean them using a dr y or
abrasive cloth, nor with a
detergent
or solvent product,
F

u
se a sponge and soapy water or a pH
neutral product,
F

w
hen using a high-pressure washer
on persistent marks, do not keep the
lance directed towards the lamps or
their edges for too long, so as not to
damage their protective coating and
seals.
Changing a


bulb must only be done with
the ignition off and after the lamp has
been switched off for several minutes –
Risk of serious burns!
F

D
o not touch the bulb directly with your
fingers, use a
lint-free cloth.
It is essential only to use anti-ultraviolet
(UV) type bulbs, so as not to damage the
headlamp.
Always replace a
failed bulb with a new
bulb with the same type and specification. In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps is
normal; it disappears after the lamps have
been on for a
few minutes.
Light-emitting diodes (LED)
For the replacement of this type of bulb,
you must contact a
PEUGEOT dealer or
a


qualified workshop.
Halogen bulbs
To ensure good quality lighting, check
that the bulb is correctly positioned in its
housing.
8
In the event of a breakdown

152
Socket, auxiliary ..........................................9 , 23
Socket, Jack .................................................... 23
Socket, USB


.............................. 49, 3, 3, 5, 9, 23
Sockets, audio
.................................................. 3
S

ockets, auxiliary
...............................
...............3
Speed limiter
.................................. 9

1-93, 95 -96
Starting a


Diesel engine
............................... 10

6
Starting the engine
................................... 81

- 82
Starting the vehicle
........................ 8

0-81, 84-85
Starting using another battery


......................13 8
Station, radio
.............................. 2

, 2, 6 -7, 21-22
Stay, bonnet


.................................................. 111
Steering lock
...............................

....................82
Steering mounted controls, audio
................ 3

, 3
Steering wheel, adjustment
............................ 36
S

TOP (warning lamp)

...................................... 11
Stopping the vehicle


...........................8 0 - 81, 8 5
Stop & Start


...................... 19, 26, 42, 46, 87- 89,
100, 107, 111, 115, 137
Storage


...................................................... 39, 48
Stowing rings


.................................................. 49
Sunroof


....................................................... 47- 4 8
Sunshine sensor


............................................. 41
Switching off the engine


...........................81- 82
Synchronising the remote control
...................32
Tables of fuses
....................................... 13 3 -13 6
Ta n k , f u e l


................................................ 107-108
Telephone
..............................

........13 -15, 25 -29
Temperature, coolant


................................11, 2 1
Third brake lamp


........................................... 13 3
Three flashes (direction indicators)
................ 52
T

ime (setting)

...................................... 26, 17, 31
TMC (Traffic info)

............................................ 13
T

o o l s

................................ 125 -12 6 , 13 3 -13 6 , 141
Touch screen ..................................... 49, 91, 1, 1
Towed loads


.................................................. 142Towing another vehicle
..........................140 -141
Towing device
...................................80 - 81, 109
Traction control (ASR)


........................14, 6 0 - 62
Traffic information (TA)


.....................................3
Traffic information (TMC)


................................13
Tr a i l e r
...............

.................................80 - 81, 109
Triangle, warning ........................................... 121
Trip computer


............................................24-26
Ty r e s


..........................................................6 , 11 6
Tyre under-inflation detection


.....15, 89, 91, 125
Under-inflation (detection)


..........15, 89, 91, 125
Unlocking


........................................................28
Unlocking from the inside
...............................30
Unlocking the boot

...............................
.....28, 32
Unlocking the doors
........................... 2

8, 30, 33
Updating the date
................................ 2

6, 17, 31
Updating the time
...............................

.26, 17, 31
USB


...............................................3, 3, 9, 23 -24Wiper, rear
....................................................... 57
Wiper blades (changing)
.................................57
Wipers


.................................................19, 55 -56
Wipers, automatic rain sensitive


.....................56
Warning and indicator lamps
.......................... 10
W

arning lamp, airbag
......................................15
W

arning lamp, braking system

.......................12
Warning lamp, Diesel engine pre-heater


.......13
Warning lamp, low fuel level
...........................14
Warning lamp, parking brake


..........................12
Warning lamp, Service ....................................13
Warning lamp, STOP


......................................11
Weights
...............

...........................142-143, 145
Wheel, spare
...............................

...116, 125 -126
Window controls


.............................................34
Ventilation


.............................................6, 41, 45
Voice commands


.........................................5 -10
T
U
W
V
Alphabetical index