20
Indicators
Service indicator
The ser vice indicator is displayed in the
instrument panel. Depending on the vehicle
version:
-
t
he distance recorder display line indicates
the distance remaining before the next
ser vice is due, or the distance travelled
since it was due preceded by the "-" sign.
Warning/indicator
lamp State
CauseActions/
Observations
Ser vice
spanner Lights up temporarily
when the ignition is
switched on.
Between 620 and
1 ,860 miles (1,000 and
3,000
km) remain before
the next ser vice is due.
Fixed, when the
ignition is switched on. The ser vice is due in
less than 620
miles
(1,000
km).Have your vehicle
serviced very soon.
+ Ser vice
spanner
flashing
Flashing then fixed,
when the ignition is
switched on.
(For BlueHDi Diesel
versions, associated
with the Ser vice
warning lamp). The servicing interval
has been exceeded.
Have your vehicle
ser viced as soon as
possible.
The distance indicated (in miles or
kilometres) is calculated according to the
distance covered and the time elapsed
since the last ser vice.
The alert may also be triggered close to
a
due date.
-
a
n alert message indicates the distance
remaining, as well as the period before
the next ser vice is due or how long it is
overdue.
Resetting the service indicator
The ser vice indicator must be reset after each
service.
If you have carried out the ser vice on your
vehicle yourself:
F
s
witch off the ignition,
If you have to disconnect the battery
following this operation, lock the vehicle
and wait at least 5
minutes for the reset to
be registered.
F
p
ress and hold the trip distance recorder
reset button,
F
s
witch on the ignition; the distance recorder
display begins a
countdown,
F
r
elease the button when " =0" is displayed;
the spanner disappears.
Instruments
87
Hill start assist
System that holds your vehicle for around
2 seconds, the time it takes to move your foot
from the brake pedal to the accelerator pedal.
The hill start assist function cannot be
deactivated. However, use of the parking
brake to immobilise the vehicle interrupts
its function. Hill start assist is only available when:
-
y
our foot on the brake pedal fully
immobilises the vehicle,
-
c
ertain slope conditions are met,
-
t
he driver's door is closed.Do not leave the vehicle while it is being
held temporarily by hill start assist.
If you need to leave the vehicle with the
engine running, apply the parking brake
manually. Then ensure that the parking
brake warning lamp is on fixed in the
instrument panel.
Malfunction
If a fault in the system occurs, these warning
l amps come on. Contact a PEUGEOT dealer
or a
qualified workshop to have the system
checked.
Uphill, with the vehicle stationar y, the
vehicle is held for a
shor t time when you
release the brake pedal.
With an automatic gearbox, if you are in
position D . Downhill, with the vehicle stationary and
reverse gear engaged, the vehicle is held
for a
shor t time when you release the brake
pedal.
Stop & Start
The system puts the engine temporarily into
standby – STOP mode – during stops in the
traffic (red lights, traffic jams, etc.). The engine
restarts automatically – START mode – as
soon as you wish to move off again. Restarting
occurs instantaneously, quickly and silently.
Per fect for urban use, the Stop & Start system
reduces fuel consumption and exhaust
emissions as well as the noise level when
stationary.
STOP mode
This indicator lamp comes on in the
instrument panel and the engine
goes into standby.
With BlueHDi Diesel and manual gearbox :
- A s soon as the vehicle stops or the speed is less
than 2
mph (3 km/h) (with 1.5 BlueHDi engine).
-
W
ith gear lever in neutral and clutch pedal
released.
6
Driving
