2018 NISSAN VERSA NOTE warning

[x] Cancel search: warning

Page 460 of 878

NISSAN VERSA NOTE 2018  Owner´s Manual ARMREST (if so equipped for
driver’s side only)
To use the armrest, pull it down as shown.
AStowed position
BResting position
WARNING
Head restraints/headrests supplement
the other vehicle safety

Page 465 of 878

NISSAN VERSA NOTE 2018  Owner´s Manual WARNING
∙ Every person who drives or rides inthis vehicle should use a seat belt at
all times. Children should be in the
rear seats and in an appropriate
restraint.
WARNING
∙ The seat belt should

Page 466 of 878

NISSAN VERSA NOTE 2018  Owner´s Manual WARNING
∙ Always route the shoulder belt overyour shoulder and across your chest.
Never put the belt behind your back,
under your arm or across your neck.
The belt should be away from your
face and

Page 467 of 878

NISSAN VERSA NOTE 2018  Owner´s Manual SEAT BELT WARNING LIGHT
Both the driver’s and passenger’s front
seats are equipped with a seat belt warn-
ing light. The warning light, located on the
instrument panel, will show the status of
the

Page 469 of 878

NISSAN VERSA NOTE 2018  Owner´s Manual 3. Position the lap belt portionlow and
snug on the hips
Bas shown.
4. Pull the shoulder belt portion toward the retractor to take up extra slack
C.
Be sure the shoulder belt is routed over
your sho

Page 471 of 878

NISSAN VERSA NOTE 2018  Owner´s Manual WARNING
∙ Always fasten the connector tongueand the seat belt in the order shown.
∙ Always make sure both the connector tongue and the seat belt tongue are
secured when using the seat belt or
inst

Page 472 of 878

NISSAN VERSA NOTE 2018  Owner´s Manual Attaching the center seat belt
Always be sure the center seat belt con-
nector tongue and connector buckle are
attached. Disconnect only when folding
down the rear seat.To connect the buckle:
1. Pull

Page 473 of 878

NISSAN VERSA NOTE 2018  Owner´s Manual ∙ Make sure to wear the rear center seatbelt with the seat belt passing
through the path
A.
Shoulder belt height adjustment
(front seats)
The shoulder belt anchor height should be
adjusted to the p