2018 NISSAN ROGUE HYBRID lock

1. Engine hood (P. 3-21)
2. Wiper and washer switch (P. 2-40)Wiper blades (P. 8-16)
3. Windshield (P. 8-16) Windshield-washer fluid (P. 8-12)
4. Power windows (P. 2-63)
5. Door locks (P. 3-4) NISSAN Intelligent Key® (P. 3-7)
Keys (P. 3-2)
6. Mirrors (P. 3-33) Side view camera (if so equipped)
(P. 4-11)
7. Tire pressure (P. 8-27) Flat tire (P. 6-3)
Tire chains (P. 8-27)
8. Fog light switch (if so equipped)
(P. 2-42)
Daytime Running Lights (DRL)
system (P. 2-42)
9. Headlight and turn signal switch
(P. 2-42)
Replacing bulbs (P. 8-23)
10. Front view camera (if so equipped)
(P. 4-11)
Refer to the page number indicated in
parentheses for operating details.
LII2540
EXTERIOR FRONT
Illustrated table of contents0-3

1. Wiper and washer switch (P. 2-40)
2. Child safety rear door lock (P. 3-4)
3. Fuel-filler door (P. 3-28)Fuel-filler cap (P. 3-28)
Fuel recommendation (P. 10-2)
4. Replacing bulbs (P. 8-23)
5. Rearview camera (P. 4-3, 4-11)
6. Lif tgate release (P. 3-22)
Refer to the page number indicated in
parentheses for operating details.
LII2541
EXTERIOR REAR
0-4Illustrated table of contents

15. Cruise control main/set switches(if so equipped) (P. 5-54)
Intelligent Cruise Control (ICC)
switches (if so equipped) (P. 5-56)
Bluetooth® Hands-Free Phone
System*
16. Driver supplemental air bag
(P. 1-45)
Horn (P. 2-49)
17. Tilt and telescopic steering (P. 3-31)
18. Control panel and vehicle informa-
tion display switches (P. 2-20)
19. Hood release (P. 3-21)
20. SPORT mode switch (P. 5-24) Fuel door release (P. 3-28)
ECO mode switch (P. 5-24)
Power lif tgate switch
(if so equipped) (P. 3-22)
Power lif tgate main switch
(if so equipped) (P. 3-22)
All-Wheel Drive (AWD) LOCK switch
(if so equipped) (P. 2-52)
Vehicle Dynamic Control (VDC) OFF
switch (P. 2-52)
Heated steering wheel switch
(if so equipped) (P. 2-50)
Dynamic driver assistance switch
(if so equipped) (P. 2-51) 21. Instrument brightness control
(P. 2-47)
Twin trip odometer reset switch
(P. 2-5)
*: Refer to the separate NissanConnect®
Owner’s Manual.
Refer to the page number indicated in
parentheses for operating details.
Illustrated table of contents0-7

Warninglight Name Page
12–volt battery
charge warning
light 2-11
or
Anti-lock Braking
System (ABS)
warning light2-11
Automatic Emer-
gency Braking
(AEB) system
warning light (if so
equipped)2-11
Automatic Emer-
gency Braking
(AEB) with Pedes-
trian Detection
system warning
light (if so
equipped)2-12
Warning
light Name Page
or
Brake warning
light 2-12
Electronically
controlled brake
warning light (yel-
low) 2-13
Low tire pressure
warning light
2-13
Master warning
light2-15
Power steering
warning light2-15
PURE DRIVE® Hy-
brid system
warning light2-16
Warning
light Name Page
Seat belt warning
light and chime 2-16
Supplemental air
bag warning light2-16
Indicator
light Name Page
All-Wheel Drive
(AWD) LOCK indi-
cator light (if so
equipped) 2-17
Approaching Ve-
hicle Sound for
Pedestrians (VSP)
OFF indicator
light2-17
EV indicator light 2-17
Front fog light in-
dicator light (if so
equipped)
2-17
WARNING AND INDICATOR LIGHTS
Illustrated table of contents0-9

WARNING
∙ Do not ride in a moving vehicle whenthe seatback is reclined. This can be
dangerous. The shoulder belt will not
be against your body. In an accident,
you could be thrown into it and re-
ceive neck or other serious injuries.
You could also slide under the lap belt
and receive serious internal injuries. ∙ For the most effective protection
when the vehicle is in motion, the seat
should be upright. Always sit well
back and upright in the seat with both
feet on the floor and adjust the seat
properly. For additional information,
refer to “Precautions on seat belt us-
age” in this section.
∙ Af ter adjustment, gently rock in the seat to make sure it is securely locked. ∙ Do not leave children unattended in-
side the vehicle. They could unknow-
ingly activate switches or controls or
make the vehicle move. Unattended
children could become involved in se-
rious accidents.
∙ To help avoid risk of injury or death through unintended operation of the
vehicle and/or its systems, do not
leave children, people who require the
assistance of others or pets unat-
tended in your vehicle. Additionally,
the temperature inside a closed ve-
hicle on a warm day can quickly be-
come high enough to cause a signifi-
cant risk of injury or death to people
and pets.
∙ Do not adjust the driver’s seat while driving so full attention may be given
to vehicle operation. The seat may
move suddenly and could cause loss
of control of the vehicle.
∙ The seatback should not be reclined any more than needed for comfort.
Seat belts are most effective when the
passenger sits well back and straight
up in the seat. If the seatback is re-
clined, the risk of sliding under the lap
belt and being injured is increased.
ARS1152
SEATS
1-2Safety—Seats, seat belts and supplemental restraint system

CAUTION
When adjusting the seat positions, be
sure not to contact any moving parts to
avoid possible injuries and/or damage.
FRONT MANUAL SEAT
ADJUSTMENT (for passenger’s
seat)
Your vehicle seats can be adjusted manu-
ally. For additional information about ad-
justing the seats, refer to the steps outlined
in this section.
Forward and backward
Pull the center of the bar up and hold it
while you slide the seat forward or back-
ward to the desired position. Release the
bar to lock the seat in position.
Reclining
To recline the seatback, pull the lever up
and lean back. To bring the seatback for-
ward, pull the lever up and lean your body
forward. Release the lever to lock the seat-
back in position.
The reclining feature allows adjustment of
the seatback for occupants of different
sizes for added comfort and to help obtain
proper seat belt fit. For additional informa-
tion, refer to “Precautions on seat belt us-
age” in this section. Also, the seatback can
be reclined to allow occupants to rest
when the vehicle is stopped and the shif t
lever is in the P (Park) position.
LRS3029LRS3030
Safety—Seats, seat belts and supplemental restraint system1-3

Seat lif ter
Move the switch as shown to achieve de-
sired seat height.
Lumbar support
The lumbar support feature provides ad-
justable lower back support to the driver.
Move the switch as shown to adjust the
seatback lumbar area.
ARMRESTS
The rear bench center armrest is locked in
the up position. To lower the armrest, pull
the armrest down as shown.
To return the armrest to the up position,
push up on the armrest until it is in the full
up position.
LRS2784LRS2270LRS3031
Safety—Seats, seat belts and supplemental restraint system1-5

FLEXIBLE SEATING
WARNING
∙ Never allow anyone to ride in thecargo area or on the rear seats when
they are in the fold-down position. In a
collision, people riding in these areas
without proper restraints are more
likely to be seriously injured or killed.
∙ Do not allow people to ride in any area of your vehicle that is not equipped
with seats and seat belts. Be sure ev-
eryone in your vehicle is in a seat and
using a seat belt properly.
∙ Do not allow more than one person to use the same seat belt.
∙ Do not fold down the rear seats when occupants are in the rear seat area or
any luggage is on the rear seats.
– Make sure that the seat path is clear before moving the seat.
– Be careful not to allow hands or feet to get caught or pinched in the
seat. ∙ Head restraints/headrests should be
adjusted properly as they may pro-
vide significant protection against in-
jury in an accident. Always replace
and adjust them properly if they have
been removed for any reason.
∙ If the head restraints/headrests are removed for any reason, they should
be securely stored to prevent them
from causing injury to passengers or
damage to the vehicle in case of sud-
den braking or an accident.
∙ When returning the seatbacks to the upright position, be certain they are
completely secured in the latched po-
sition. If they are not completely se-
cured, passengers may be injured in
an accident or sudden stop.
∙ Properly secure all cargo to help pre- vent it from sliding or shif ting. Do not
place cargo higher than the seat-
backs. In a sudden stop or collision,
unsecured cargo could cause per-
sonal injury.
Folding the rear bench seat
To fold the rear bench seat flat for maxi-
mum cargo hauling:
1. Make sure that the head restraints are lowered or removed. To remove the
head restraints, push and hold the lock
knob while moving the head restraints
in an upward direction. Store the head
restraints properly so they are not loose
in the vehicle.
LRS2820
1-6Safety—Seats, seat belts and supplemental restraint system