2018 MITSUBISHI L200 Fuel system

Exterior - front E085004020551. Fuel tank filler door p. 2-032. Locking and unlocking p. 3-15 Keyless entry system p. 3-04
3. Outside rear-view mirrors p. 6-09
4. Side turn-signal lamps p. 5-20, 10-23
5. Headlamp washer* p. 5-26
6. Headlamps p. 5-17, 10-23, 10-24
7. Front turn-signal lamps p. 5-20, 10-23, 10-26
8. Position lamps p. 5-17, 10-23, 10-26
9. Front fog lamps* p. 5-22, 10-23, 10-26 Daytime running lamp p. 5-19, 10-23, 10-26
10. Bonnet p. 10-04 Engine compartment p. 10-02, 11-17
11. Wiper and washers p. 5-23, 10-15
12. Antenna p. 7-75
Exterior - front
1-09OKTE18E1Overview/Quick guide1Single cab

1. Fuel tank filler door* p. 2-03
2. Keyless entry system* p. 3-04 Keyless operation system* p. 3-07
Locking and unlocking p. 3-15
3. Side turn-signal lamps (on outside rear-view mirror)* p. 5-20, 10-23
4. Outside rear-view mirrors p. 6-09
5. Side turn-signal lamps (on fender)* p. 5-20, 10-23
6. Headlamp washer* p. 5-26
7. Headlamps p. 5-17, 10-23
8. Daytime running lamp p. 5-19, 10-22 Position lamps p. 5-17, 10-23
9. Front turn-signal lamps p. 5-20, 10-23, 10-26
10. Front fog lamps p. 5-22, 10-23, 10-26
11. Front fog lamps* p. 5-22, 10-23, 10-26 Daytime running lamp p. 5-19, 10-23, 10-26
12. Position lamps p. 5-17, 10-23, 10-26
13. Front turn-signal lamps p. 5-20, 10-23, 10-26
14. Headlamps p. 5-17, 10-23, 10-24
15. Bonnet p. 10-04 Engine compartment p. 10-02, 11-17
16. Wiper and washers p. 5-23, 10-15
17. Antenna p. 7-75
Exterior - front
1-10OKTE18E1Overview/Quick guide1Club cabExcept for high intensity discharge
headlamp type High intensity discharge headlamp type

1. Fuel tank filler door* p. 2-03
2. Keyless entry system* p. 3-04 Keyless operation system* p. 3-07
Locking and unlocking p. 3-15
3. Side turn-signal lamps (on outside rear-view mirror)* p. 5-20, 10-23
4. Outside rear-view mirrors p. 6-09
5. Side turn-signal lamps (on fender)* p. 5-20, 10-23
6. Headlamp washer* p. 5-26
7. Headlamps p. 5-17, 10-23
8. Daytime running lamp p. 5-19, 10-22 Position lamps p. 5-17, 10-23
9. Front turn-signal lamps p. 5-20, 10-23, 10-26
10. Front fog lamps p. 5-22, 10-23, 10-26
11. Front fog lamps* p. 5-22, 10-23, 10-26 Daytime running lamp p. 5-19, 10-23, 10-26
12. Position lamps p. 5-17, 10-23, 10-26
13. Front turn-signal lamps p. 5-20, 10-23, 10-26
14. Headlamps p. 5-17, 10-23, 10-24
15. Bonnet p. 10-04 Engine compartment p. 10-02, 11-17
16. Wiper and washers p. 5-23, 10-15
17. Antenna p. 7-75
Exterior - front
1-11OKTE18E1Overview/Quick guide1Double cabExcept for high intensity discharge
headlamp type High intensity discharge headlamps
type

Fuel selection...................................................................................... 2-02Filling the fuel tank............................................................................. 2-03Entering or leaving the vehicle........................................................... 2-05Installation of accessories................................................................... 2-05
Modification/alterations to the electrical or fuel systems................... 2-06
Genuine parts...................................................................................... 2-06
Safety and disposal information for used engine oil........................... 2-06
Disposal information for used batteries.............................................. 2-07General information
OKTE18E12

Fuel selectionE00200105096Recommended fuel
Cetane number (EN
590) 51 or higherCAUTIONlYour vehicle is designed to use only diesel
fuel that meets the EN590 standard.
Use of any other type of diesel fuel (bio die-
sel, methylester, etc.) would adversely affect
the engine’s performance and durability.
l If proper “winter” fuel is not used in winter,
the diesel preheat indication lamp may blink and the engine speed may not rise above theidling speed because of fuel freezing. In this
case, keep the engine idling for approxi- mately 10 minutes, then turn off the ignition
switch or put the operation mode in OFF and immediately turn it on or put in ON again to
confirm that the diesel preheat indication lamp is off. (Refer to “Diesel preheat indica-
tion lamp” on page 5-14)NOTEl For diesel fuel, due to the separation of par-
affin, the fluidity of the fuel decreases con- siderably as the temperature falls.
Because of this fact there are two kinds of
fuel: “summer” and “winter”.
This must be considered in winter use.
Select either of the two kinds of fuel in ac- cordance with ambient temperature. Above -5 °C: “Summer” diesel
Below -5 °C: “Winter” diesel
When travelling abroad, find out in advance
about the fuels served in local service sta- tions.
l Poor-quality diesel fuel can cause deposits to
form in the injector, resulting in black smoke and rough idling.
If these problems occur, you are advised to
add a cleaning additive to the diesel fuel when you refuel the vehicle.
The additive will break up and remove the
deposits, thereby returning the engine to a normal condition.
Be sure to use a MITSUBISHI MOTORS
GENUINE DIESEL FUEL SYSTEM
CLEANER. Using an unsuitable additive could make the engine malfunction. For de-
tails, please contact your MITSUBISHI
MOTORS Authorized Service Point.Graphical expression for con-
sumer information
B7: Diesel fuel containing up to 7.0 % (V/V) Fatty Acid Methyl Esters - Eg. EN 590 com-pliant diesel
The diesel engine are compatible with B7
type diesel (containing 7 % fatty acid methyl
esters) conforming to European standards EN590.
CAUTIONl Do not use more than 7 % concentration of
fatty acid methyl esters (bio diesel) by vol-
ume.
Use of more than 7 % concentration would adversely affect the engine’s performance
and durability.
Fuel selection
2-02OKTE18E1General information2

1- Remove
2- Close

[Vehicles for Type 3]
Open the cover (1). Insert the key in the
fuel cap (2) and unlock it.
Turn the fuel cap and remove it.
CAUTIONl Since the fuel system may be under pressure,
remove the fuel cap slowly. This relieves any pressure or vacuum that might have
built up in the fuel tank. If you hear a hissing sound, wait until it stops before removing the fuel cap. Otherwise, fuel may spray out,
injuring you or others.NOTEl While filling with fuel, hang the fuel cap on
the hook (A) located on the inside of the fuel
tank filler door.4. Insert the gun in the tank port as far as it
goes.CAUTIONl Do not tilt the gun.
5.
When the gun stops automatically, do
not fill with fuel any more.

6. [Vehicles for Type 1, 2] To close, turn the fuel cap slowly clock-
wise until you hear clicking sounds, then
gently push the fuel tank filler door
closed.
[Vehicles for Type 3]
To close, turn the fuel cap slowly clock-
wise until you hear clicking sounds, then turn the key clockwise to lock the fuelcap.
Filling the fuel tank
2-04OKTE18E1General information2Type 2 Type 3 Type 1 Type 2

Entering or leaving the
vehicle E00205800022CAUTIONlTo avoid slipping and damaging the painted
surface, do not step on the cover of the side
step (A).Installation of accessories
E00200302606
We recommend you to consult yourMITSUBISHI MOTORS Authorized Service
Point.
CAUTIONl Your vehicle is equipped with a diagnosis
connector for checking and servicing theelectronic control system.
Do not connect a device other than a diagno-
sis tool for inspections and service to this
connector.
Otherwise, the battery could be discharged,
the electronic devices of the vehicle could malfunction, or other unexpected problems could result.
In addition, malfunctions caused by connect-
ing a device other than a diagnosis tool may not be covered under warranty.
l The installation of accessories, optional
parts, etc., should only be carried out
within the limits prescribed by law in your country, and in accordance with the
guidelines and warnings contained with-
in the documents accompanying this ve- hicle.
l Improper installation of electrical parts
could cause fire, please refer to the Mod-
ification/ alteration to the electrical or fuel systems section within this owner’smanual.
l When installing the radio, for the re-
quired information (frequency, transmis-
sion output, installing procedure), con-
sult a MITSUBISHI MOTORS Author-
ized Service Point.
If the frequency, transmission output and
installing condition are not appropriate, it can adversely affect the electronic de-vices and could lead to unsafe vehicle
operation.
l Using a cellular phone or radio set inside
the vehicle without an external antenna
may cause electrical system interference,
which could lead to unsafe vehicle oper- ation.
l Tyres and wheels which do not meet
specifications must not be used.
Refer to the “Specifications” section for information regarding wheel and tyre
sizes.
Important points!
Due to a large number of accessories and re-
placement parts of different manufactures available in the market, it is not possible, not
only for MITSUBISHI MOTORS , but also
for a MITSUBISHI MOTORS Authorized
Service Point, to check whether the attach- ment or installation of such parts affects the
overall safety of your vehicle.

Entering or leaving the vehicle
2-05OKTE18E1General information2

Even when such parts are officially Author-ized, for example by a “general operators
permit” (an appraisal for the part) or through the execution of the part in an officially ap- proved manner of construction, or when a
single operation permit following the attach- ment or installation of such parts, it cannot be
deduced from that alone, that the driving safety of your vehicles has not been affected.

Consider also that there basically exists no li- ability on the part of the appraiser or the offi-
cial. Maximum safety can only be ensured
with parts recommended, sold and fitted or installed by a MITSUBISHI MOTORS Au-
thorized Service Point ( MITSUBISHI
MOTORS GENUINE replacement parts and
MITSUBISHI MOTORS accessories). The
same also pertains to modifications of vehi- cles with respect to the production specifica- tions. For safety reasons, do not attempt any
modifications other than those that follow the recommendations of a MITSUBISHI
MOTORS Authorized Service Point.Modification/alterations to
the electrical or fuel systems E00200401525
MITSUBISHI MOTORS has always manu-
factured safe, high quality vehicles. In order to maintain this safety and quality, it is im-
portant that any accessory that is to be fitted, or any modifications carried out which in-
volve the electrical or fuel systems, should be carried out in accordance with MITSUBISHI
MOTORS guidelines.CAUTIONl If the wires interferes with the vehicle body
or improper installation methods are used (protective fuses not included, etc.), elec-
tronic devices may be adversely affected, re-
sulting in a fire or other accident.Genuine parts
E00200501715
MITSUBISHI MOTORS has gone to great
lengths to bring you a superbly crafted vehi-
cle offering the highest quality and dependa- bility.
Use MITSUBISHI MOTORS GENUINE
Parts, designed and manufactured to maintain your MITSUBISHI MOTORS vehicle at top
performance. MITSUBISHI MOTORS GEN- UINE Parts are identified by this mark and
are available at all MITSUBISHI MOTORS
Authorized Service Points.Safety and disposal
information for used engine
oil E00200601426WARNINGlProlonged and repeated contact may
cause serious skin disorders, including
dermatitis and cancer.
l Avoid contact with the skin as far as pos-
sible and wash thoroughly after any con- tact.
l Keep used engine oils out of reach of chil-
dren.
Modification/alterations to the electrical or fuel systems
2-06OKTE18E1General information2