2018 MINI Convertible Owner's Manual

'

do not change this position while using the ve~hicle jack. '

4.Hand-tighten the remaining lug bolts and
tighten all lug bolts well in a crosswise pat~
tern.5.Turn the vehicle jack crank counterclock~
wise to retract the vehicle jack and lower
the vehicle.6.Remove the vehicle jack and stow it se~ curely.
After
the
wheel
change
1.Tighten the lug bolts crosswise. The tight~
ening torque is 101 lb ft/140 Nm.2.Stow the nonworking wheel in the cargo
area, if necessary.
The nonworking wheel cannot be stored
under the cargo floor panel because of its
size.3.Check tire inflation pressure at the next op~
portunity and correct as needed.4.Reinitialize the run-flat tires.
Reset the Tire Pressure Monitor TPM.5.Check to make sure the lug bolts are tight with a calibrated torque wrench.6.Have the damaged tire replaced at the
nearest dealer

3.Screw wheel lug wrench onto the thread
and hold in place with one hand.4.Unlock the locking hexagon of the emer~ gency wheel well using the hexagon at~tached to retaining plate.5.Lower the emergency wheel with the wheel
wrench.6.Unscrewing the wheel wrench7.Pull out the well with emergency wheel un~
der the vehicle toward the rear.8.Remove the spacer and emergency wheel
from the well.9.Stow the well and spacer in the vehicle.
Replacing
the
tires
1.Have the damaged tire replaced.2.Replace the emergency wheel with the new wheel.
Installing
the
emergency
wheel
Have the emergency wheel installed back into
the vehicle by a dealer

Engine
compartmentVehicle
features
and
op

WARNING
The engine compartment accommodates
moving components. Certain components in the engine compartment can also move with
the vehicle switched off, for instance the radia~
tor fan. There is a risk of injury. Do not reach
into the area of moving parts. Keep articles of
clothing and hair away from moving parts. '

Engine
oilVehicle
features
and
op

Displaying
the
engine
oil
level
Via the Central Information Display (CID):1. "Vehicle info"2."Vehicle status"3. "Engine oil level"
The engine oil level is displayed.
System
limits
When making frequent short-distance trips or using a dynamic driving style, it may not be
possible to calculate a measured value. In this
case, the measured value for the last, suffi~
ciently long trip is displayed.
Detailed
measurement
Concept
The engine oil level is checked when the vehi~ cle is stationary and displayed via a scale.
If the engine oil level is outside its permissibleoperating range, a Check Control message is
displayed.
General
information
During the measurement, the idle speed is in~
creased somewhat.
Functional
requirements
'