2018 MERCEDES-BENZ S-CLASS COUPE check engine

Engine oil
Checkingthe engine oil le vel with an on-
board computer
The engine oil le vel is de term ined during driving.
The oil le vel display is only available af ter a driv‐
ing time of up to30 minutes and if the ignition is
switched on, depending on the driving profile.
It is not possible tocor rectly measure the oil
le ve l if:
Rtheve hicle is not le vel during the measure‐
ment process.
Rth e hood was pr eviously opened.
The engine must be restar ted and the engine oil
le ve l will be de term ined again when driving.
On-board computer:
,Service.Engine Oil Level
Yo u will see one of thefo llowing messa ges in
th e multifunction displa y:
#Measuring Engine Oil Level...: measurement
ofthe oil le vel is not yet possible. Repeat the
requ est af ter a maximum of 30 minutes' driv‐
ing.
#Engine Oil Level OK andthe bar display for
indicating the oil le vel in the multifunction
display is green and is between "min" and
"max": the oil le vel is cor rect.
#Engine Oil Level Add 1.0 l andthe bar display
fo r indicating the oil le vel in the multifunction
display is orange and is below "min": top up
with 1.1 US qt (1 l) of engine oil.
#Reduce Engine Oil Level andthe bar display
fo r indicating the oil le vel in the multifunction
display is orange and is abo ve"max ":drain
off theex cess engine oil. Consult a qualified
specialist workshop.
#For Engine Oil Level Switch Ignition On:
switch on the ignition tocheck the engine oil
le ve l.
#Engine Oil Level System Inoperative: sensor
defective or not connec ted. Consult a quali‐
fi ed specialist workshop.
#Engine Oil Level System Currently Unavail.:
close the hood. Ad
ding engine oil
&
WARNING Risk of burn s from hot com‐
ponent parts in the engine compartment
Cer tain component parts in the engine com‐
partment can be very hot, e.g. the engine,
th e cooler and parts of theex haust sy stem.
#Let the engine cool down and only
to uch the component parts described
as follo ws .
&
WARNING Risk offire and injury from
engine oil
If engine oil comes into con tact wi thhot
component parts in the engine compart‐
ment, it may ignite.
#Make sure that no engine oil is spilled
next tothefiller opening.
#Allow the engine tocool off and thor‐
oughly clean the engine oil from compo‐
nent parts before starting theve hicle.
Maintenance and care 327

*NO
TEEngine damage causedbyan
incor rect oil filter, incor rect oil or addi‐
tives
#Do not use engine oils or oil filters
which do not cor respond tothe specifi‐
cations explicitly prescribed forth e
service inter vals.
#Do not alter the engine oil or oil filter in
order toachie velonger change inter vals
th an prescri bed.
#Do not use additives.
#Follow the instructions in the service
inter val display rega rding the oil
ch ange.
* NO
TEDama gecaused bytopping up too
much engine oil
Ad ding too much engine oil can cause dam‐
age tothe engine or the catalytic con verter.
#Ha ve excess engine oil remo ved at a
qu alified specialist workshop.
#Tu rn cap 1counter-clockwise and remo ve
it.
#Ad d engine oil.
#Replace cap 1and turn it clockwise as far
as it will go.
#Check the oil le vel again (→page 327).
Checking coolant le vel
&
WARNING Risk of burn s from hot com‐
ponent parts in the engine compartment
Cer tain component parts in the engine com‐
partment can be very hot, e.g. the engine,
th e cooler and parts of theex haust sy stem.
#Let the engine cool down and only
to uch the component parts described
as follo ws .
&
WARNING Risk of scalding from hot
coolant
The engine cooling sy stem is pressurized,
particularly when the engine is warm. If you
open the cap, you could be scalded byhot
coolant spr aying out.
#Let the engine cool down before open‐
ing the cap.
#When opening the cap, wearglove s and
saf etygl asses.
#Open the cap slowly torelease pres‐
sure.
328 Maintenance and care

#Park theve hicle on a le vel sur face.
#Check the coolant temp erature display in the
instrument clus ter.
The coolant temp erature must be below
15 8 °F (70 °C).
#Slowly turn cap 1counter-clockwise to
re lease overpressure.
#Continue turning cap 1counter-clockwise
and remo veit.
The coolant le vel is cor rect:
Rifth e engine is cold, up tomar ker bar 2
Rifth e engine is warm, up to0.6 in (1.5 cm)
ov er mar ker bar 2
#If necessar y,top up with coolant that has
been appr ovedby Mercedes-Benz.
RFurther information on coolant (→page 399)
Ad ding washer fluid tothe windshield
wa sher sy stem
&
WARNING Risk of burn s from hot com‐
ponent parts in the engine compartment
Cer tain component parts in the engine com‐
partment can be very hot, e.g. the engine,
th e cooler and parts of theex haust sy stem.
#Let the engine cool down and only
to uch the component parts described
as follo ws .
&
WARNING Danger of burn s when open‐
ing the hood
If yo u open the hood when the engine has
ove rheated or during a fire inthe engine
compartment, you could come into contact
wit h hot gases or other escaping operating
fl uids.
#Before opening the hood, allow the
engine tocool down.
#Intheeve nt of a fire inthe engine com‐
partment, keep the hood closed and
call thefire service.
&
WARNING ‑ Risk of fire and injury from
windshield washer concentrate
Wi ndshield washer concentrate is highly
fl ammable. It could ignite if it comes into
con tact wi thhot engine component parts or
th eex haust sy stem.
#Make sure that no windshield washer
concentrate spills out next tothefiller
opening.
Maintenance and care 329

#Make surethat the positive term inal of
th e connected battery does not come
into conta ct withvehicle parts.
#Ne ver place me tal objects or tools on a
batter y.
#When connecting and disconnecting the
batter y,yo u must observ eth e descri‐
bed order forth e battery clamps.
#When giving starting assis tance, al ways
make sure that you only connect bat‐
te ry term inals with identical polarity.
#During starting assis tance, you must
observ eth e described order for con‐
necting and disconnecting the jumper
cables.
#Do not connect or disconnect the bat‐
te ry cla mp s while the engine is running.
&
WARNING Risk ofexplosion during
ch arging process and starting assis tance
During thech arging process and starting
assis tance, the battery may release an explo‐
sive gas mixture.
#Av oid fire , open flames, creating spar ks
and smoking.
#Make sure that there is suf ficient venti‐
lation du ring thech arging process and
during starting assis tance.
#Do not lean over a batter y.
Ifth e indicator/warning lamps in the instrument
clus ter do not light up at low temp eratures, it is
ve ry likely that the dischar ged battery has fro‐
zen.
& WARNING Risk ofexplosion from a fro‐
zen battery
A dischar ged battery may freeze at temp era‐
tures slightly abo veor below freezing point.
During starting assis tance or battery charg‐
ing, batte rygas may be released.
#Alw aysth aw a frozen batte ryout firs t
before charging it or per form ing start‐
ing assis tance.
The service li feof a battery that has been
th awe d may be dramatically shor tened. It is
recommended that you ha veathaw ed bat‐
te ry checked at a qualified specialist workshop.
All vehicles
* NO
TEDama gecaused bynumerous or
ex tended attem ptsto start the engine
Nume rous or extended attem ptsto start the
engine may damage the catalytic con verter
due tonon-combu sted fuel.
#Av oid numerous and extended attem pts
to start the engine.
Obser vethefo llowing points during starting
assis tance and when charging the battery:
ROnly use undamaged jumper/charging
cables with a suf ficient cross-section and
insula tedte rm inal clamps.
RNon- insulated parts of thete rm inal clamps
must not come into con tact wi thother me tal
parts while the jumper/charging cable is
connected tothe battery/jump-s tart connec‐
tion point.
350 Breakdown assis tance

Engine
Display messagesPossible causes/consequences and MSolutions
Check Coolant Level See
Operator's Manual *T
he coolant le vel is too lo w.
* NO
TEEngine damage duetoinsuf ficient coolant
#Av oid long journe yswith insuf ficient coolant.
#Ad d coolant .
?
Coolant Too Hot Stop Vehi-
cle Turn Engine Off *T
he coolant is too hot.
#Pull over and stop theve hicle safely and switch off the engine, paying attention toroad and traf fic conditions.
&
WARNING Danger of burn s when opening the hood
If yo u open the hood when the engine has overheated or during a fire inthe engine compartment, you could
come into contact with hot gases or other escaping operating fluids.
#Before opening the hood, allow the engine tocool down.
#Intheeve nt of a fire inthe engine compartment, keep the hood closed and call thefire service.
#Wa it until the engine has cooled down.
#Make sure that the air supply tothera diator is not obstructed.
#Av oiding high loads on the engine, drive on tothe nearest qualified specialist workshop. In doing so, ensure that
th e coolant temp erature display remains below 248 °F (120 °C).
426
Display message s andwarning/indicator lamps

Displaymessages
Possible causes/consequences and MSolutions
#
Stop Vehicle Leave Engine
Running*T
he battery charge leve l is too low and must be charge d.
#Pull over and stop theve hicle safely as soon as possible, paying attention toroad and traf fic conditions. Do not
continue driving under any circums tances.
#Lea veengine running.
#Wa it until the display message disappears before pulling away.
4
Check Engine Oil At Next
Refue ling *T
he engine oil le vel has dropped tothe minimum le vel.
* NO
TEEngine damage causedbydriving with insuf ficient engine oil#Av oid long journe yswith insuf ficient engine oil.
#Check the engine oil le vel when next refueling.
To p up the engine oil (
→page 327).
No tes on engine oil (
→page 397).
8
Gas Cap Loose *T
here has been pressure loss in the fuel sy stem. The fuel filler cap is not closed cor rectly or the fuel sy stem is
leaking.
#Close the fuel filler cap.
#If th e fuel filler cap was already proper lyclosed: consult a qualified specialist workshop.
428
Display messages and warning/indicator lamps

Displaymessages
Possible causes/consequences and MSolutions
Stop Vehicle Leave Engine
Running Wait Transmission
Cooling *T
he transmission has overheated. Pulling away can be temp orarily impaired or not possible.
#Pull over and stop theve hicle safely as soon as possible, paying attention toroad and traf fic conditions. Do not
continue driving under any circums tances.
#Lea veengine running.
#Wa it until the display message disappears before pulling away.
Auxiliary Battery Malfunc-
tion *T
he auxiliary batteryforth e transmission is no longer being charge d.
#Visit a qualified specialist workshop.
#Un tilthen, alw ays manually set the transmission toposition jbefore youswit choff the engine.
#Before leaving theve hicle, apply the electric parking brake.
Air Conditioning Malfunc-
tion See Operator's Manual *O
peration of the climate control sy stem is temp orarily restricted. Air flow and fresh air supply are set toautomatic
mode.
#Ha ve the climate control sy stem checked at a qualified specialist workshop.
Display messages and warning/indicator lamps 437

Warning/indicator lamp
Possible causes/consequences and MSolutions
!
ABSwarning lamp The
yellow ABS warning lamp is lit while the engine is running.
ABS is malfunctioning.
If th ere is an additional warning tone, EBD is malfunctioning.
Other driving and driving safe ty systems may also be faulty.
&
WARNING Thereisrisk of skidding if EBD or ABS is malfunctioning
If EBD or ABS is malfunctioning, the wheels could lock when braking
The steering capability and braking characteristics are thus se verely impaired .Th ebr aking dis tance in an emer‐
ge ncy braking situation can increase. In addition, other driving saf etysy stems are switched off.
#Drive on carefull y.
#Have the brake sy stem checked immediately at a qualified specialist workshop.
#Drive on carefully.
#Obser vethe messages in the multifunction displa y.
#Visit a qualified specialist workshop.
÷
ESP®wa rning lamp flashes The
yellow ESP
®wa rning lamp flashes while theve hicle is in motion.
ESP
®is inter vening.
#Ad apt your drivin gst yle to suit thero ad and weather conditions.
Display messages and warning/indicator lamps 451