2018 MAZDA MODEL CX-3 dashboard

30 MAZDAUSA.COM
Pull to
flash
high
beams Push for
high beams
LIGHTING / TURN \fIG\.NAL\f
LIGHTING CONTROL / TURN SIGNAL LEVER
NOTE:
The Daytime Running Lights (DRL) automatically turn on when the ig\.nition is
switched ON. To disable/enable this feature, see your Authorized Mazda Dealer.
NOTE: You can adjust the timing of the Auto Headlights OFF and the sensitivity of the
Auto Light \bontrol. \fee MAZDA \bONNE\bT \fettings (p. 10).
(IF EQUIPPED)
The light sensor automatically determines when to turn the headlights on or off.
Turns tail, parking, dashboard, and headlights on.
THREE-FLASH SIGNAL
To signal a lane ch\.ange, push the turn signal lever up or down halfway and
release. The turn signal indicator will only flash \.three
times. \fee "Personalization
Features" to activate.
Turns fog lights on only when headlights are on.
Turns tail, parking, and dashboard lights on.
Lighting
control/turn signal lever
2940109_18b CX-3 SSG_060817.indd 306/8/17 2:39 PM

38 MAZDAUSA.COM
AUTOMATI\b \bLIMATE \bONTROL
TEMPERATURE CONTROL DIAL
Rotate the dial for temperature control.

Push to manually turn air conditioning on or \.off.
FAN CONTROL DIAL
Rotate the dial to set desired fan speed.
Rotate dial to increase fan speed.
ORotate dial to turn the climate control system off.

Push to recirculate cabin air.
AUTO
\fet the fan selector dial in the AUTO position. The airflow mode and amount will
be automatically controlled in accordance with the set temperature.
MODE SELECTOR DIAL
Rotate the dial to set airflow mode.
Dashboard vents

Dashboard and floor vents
Floor vents

Defroster and floor vents

Push to defrost the windshield.
Push to defrost the rear window.
AUTO
\fet the mode selector dial in the AUTO position. The airflow mode and amount will be automatically controlled in accordance with the set temperature.
NOTE: Refer to Owner’s Manual for Manual \blimate \bontrol system operation.
Temperature control dial Mode selector dial
Fan control dial
2940109_18b CX-3 SSG_060817.indd 386/8/17 2:40 PM

40 MAZDAUSA.COM
GLOSSARY OF WARNING AND INDICATOR LIGHTS

Lane Departure Warning System
(LDW\f) On (Amber)/
Lane Detected (Green) (p. 24)

Lane Departure Warning System
(LDW\f) OFF
Traction Control System (T\b\f)/
Dynamic Stability Control (D\f\b)
On: T\b\f/D\f\b malfunction
Flashing: T\b\f/D\f\b operating
Traction Control System (TCS) OFF
SPORT Mode ON
Lights ON (Exterior) (p. 30)
Headlight High Beams ON
Airbag/Front Seat Belt
Pretensioner System Malfunction
Seat Belt Unbuckled/Malfun\Xction
Turn Signals/Hazard Warning
Tire Pressure Monitoring System
(TPM\f) Warning (p. 6)
On/Warning Beep: Low tire pressure in one or more tires
Flashing: TPM\f malf\.unction
Cruise Main ON (Amber)/
Cruise Set ON (Green)
Shift Position
Smart Brake Support (\fB\f) and
Smart City Brake Support (\f\bB\f)
Flashing Red: \fB\f and \f\bB\f
are operating
LED Headlight
High Beam Control ON
Smart Brake Support (\fB\f) and
Smart City Brake Support (\f\bB\f)
Amber: \fB\f and/or \f\bB\f OFF
Check Engine
Security
Brake Warning
Parking brake on/
low brake fluid/malfunction
Master Warning
Low Fuel Level
Low Engine Oil Pressure
Power Steering Malfunction
Automatic Transaxle Warning
Charging System Malfunction
Door/Tailgate Ajar
Low Washer Fluid Level
Advanced Key Detected
Advanced Key Not Detected (p. 4)
Check Fuel Cap
Perform Maintenance
Blind Spot Monitoring
(B\fM) OFF
Mazda Radar Cruise Control
On (Amber) Set (Green
4WD AWD Warning
IN\fTRUMENT \bLU\fTER
Speedometer
Shift
positionOdometer/
trip meter
Fuel gauge
Dashboard
illumination/
dimmer
1/
trip meter2
Information display/
trip computer
2940109_18b CX-3 SSG_060817.indd 406/8/17 2:40 PM

m{zd{ c x-3 41
IN\fTRUMENT \bLU\fTER
\fee your Owner’s Manual for more details and explanations. 1 Rotate the knob to adjust the brightness of the instrument cluster and other dashboard illuminations.
2 Push to toggle between trip meter (A & B). When a trip meter is selected, push and hold \.to reset to zero.
Push the knob for 1.5 seconds or more to change the speed\. units between mph.
ENGINE COOLANT TEMPERATURE LIGHTS
Since this vehicle does not use an engine coolant temperature gauge, red and blue
engine coolant temperature lights are used to indicate high and low coolant temperature.
Red Coolant Temperature
FLA\fHING: Engine is starting to run hot.
Drive slowly to reduce engine load.
ON: Engine is overheating. \fafely pull
over to the side of the road and turn the
engine off. Refer to the Owner’s Manual for more information. Blue Coolant Temperature
ON: Engine coolant is cold and no warm air is available for heater/defroster.
OFF: Engine coolant is warm and warm air is available for heater/defroster. The light
may stay on for a few minutes after start- up when the engine\. is cold, but the vehicle
can be driven with the light on or off.
TRIP COMPUTER
The following information can be selected by pushing the or of the INFO button on
the steering wheel.
• Approximate distance you can travel on the available fuel (RANGE)
•
Average fuel economy •
\burrent fuel economy • Average vehicle speed

To reset, push and hold th\.e INFO button for more than 1.5 seconds.
OUTSIDE TEMPERATURE DISPLAY
The outside temperature unit can be switched between °\b and °F using\. \fystem \fettings
in the Infotainment \fystem.
IMPORTANT: When your MAZDA \bONNE\bT display setting is set on “AUTO”, the
instrument cluster and display may become dimmer when th\.e headlights are on. If the
display and instrument cluster become too dim or too bright when the headlights are on, simply rotate the dimmer knob \.located on your instrument cluster to adjust the brightness.
TPMS NOTE: Low ambient temperature and/or high altitude may cause tire pressures to
change and turn the TPM\f warning light on. If the warning light comes on, see p. 6.
2940109_18b CX-3 SSG_060817.indd 416/8/17 2:40 PM