2018 Lexus LC500 check engine

382
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
• “Shift system malfunction” • “P switch malfunction”• “Shift system unavailable”
●If any of the following messages is shown on the multi-information display, it may indicate a malfunction in a system or part. Immediately have the vehicle inspected by any autho-
rized Lexus retailer or Lexus authorized repairer, or any reliable repairer. • “Hybrid System Malfunction” (LC500h)•“Check Engine”
• “Hybrid Battery System Malfunction” (LC500h) • “Accelerator System Malfunction”
●If any of the following messages is shown on the multi-information display, it may indicate a malfunction. Immediately stop the vehicle and contact any authorized Lexus retailer or Lexus authorized repairer, or any reliable repairer.
•“Braking Power Low” • “Charging System Malfunction”• “Oil Pressure Low”
●LC500h: If “Aux Battery Low” is shown, observe the following.
• If the message disappears in a few minutes*
Keep the hybrid system operating for more than approximately 15 minutes to charge the 12-volt battery.
• If the message does not disappear Refer to “If the 12-volt battery is discharged” ( P.392) to start the hybrid system*: It is displayed for approximately 6 seconds.
●If “Battery low” is shown, the 12-volt battery charge is insufficient. Recharge or replace the 12-volt battery.
●LC500h: If “Maintenance Required for Traction battery Cooling Parts” is shown, the fil- ters may be clogged, the air intake vents may be blocked, or there may be a gap in the
duct. Therefore, perform the following correction procedure. • If the air intake vents and filters of the hybrid battery (traction battery) are dirty, perform the procedure on P.309 to clean them.
• If the warning message is shown when the air in take vents and filters of the hybrid battery (traction battery) are not dirty, have the vehicle inspected by any authorized Lexus retailer or Lexus authorized repairer, or any reliable repairer.
■If a message that indicates the need for visi ting your any authorized Lexus retailer or
Lexus authorized repairer, or any reliable repairer is shown
The system or part shown on th e multi-information display is malfunctioning. Have the vehi-
cle inspected by any authorized Lexus retailer or Lexus authorized repairer, or any reliable repairer immediately.
■Warning buzzer
In some cases, the buzzer may not be heard due to being in a noisy location or audio sound.
NOTICE
■While the engine oil level warning message is displayed
Continued engine operation with low engine oil will damage the engine.

386
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
steering lock system.
Contact any authorized Lexus retailer or
Lexus authorized repairer, or any reliable
repairer if the problem cannot be repaired,
or if repair procedures are unknown.
When the engine does not start, the
following steps can be used as an
interim measure to start the engine if
the engine switch is functioning nor-
mally. Do not use this starting proce-
dure except in cases of emergency.
1 Press the parking brake switch to
check that the parking brake is set.
( P.187)
Parking brake indicator will come on.
2Turn the engine switch to ACCES-
SORY mode.
3 Press and hold the engine switch
for about 15 seconds while
depressing the brake pedal firmly.
Even if the engine can be started using
the above steps, the system may be
malfunctioning. Have the vehicle
inspected by any authorized Lexus
retailer or Lexus authorized repairer,
or any reliable repairer.
One of the following may be the cause
of the problem:
 The electronic key may not be func-
tioning properly. ( P.390)
 There may not be sufficient fuel in
the vehicle’s tank.
Refuel the vehicle. ( P.201)
 There may be a malfunction in the
immobilizer system. ( P.70)
 There may be a malfunction in the
shift control system.* ( P.170)
 There may be a malfunction in the
steering lock system.
 The hybrid system may be malfunc-
tioning due to an electrical problem
such as electronic key battery
depletion or a blown fuse. However,
depending on the type of malfunc-
tion, an interim measure is available
to start the hybrid system.
*: It may not be possible to shift the shift
position from P.
Starting the engine in an emer-
gency
If the hybrid system will not
start (LC500h)
Reasons for the hybrid system not
starting vary depending on the situ-
ation. Check the following and per-
form the appropriate procedure:
The hybrid system will not start
even though the correct starting
procedure is being followed.
( P.167)

389
7
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
When trouble arises
■When the electronic key does not work properly
●Make sure that the smart entry & start system has not been deactivated using the Remote Touch or at any authorized
Lexus retailer or Lexus authorized repairer, or any reliable repairer. If it is off, turn the function on.
●Check if battery-saving mode is set. If it is set, cancel the function. ( P.124)
Use the mechanical key (P.113) in
NOTICE
●Install the tab so that it does not cover
the clip installation position . Fail-
ure to do so may cause damage to the clip and make it impossible to install
the cover.
A
If the electronic key does not
operate properly
If communication between the
electronic key and vehicle is inter-
rupted ( P.124) or the electronic
key cannot be used because the
battery is depleted, the smart entry
& start system and wireless remote
control cannot be used. In such
cases, the doors and trunk can be
opened and the engine tem> can be started by following
the procedure below.
NOTICE
■In case of a smart entry & start system malfunction or other key-related
problems
Take your vehicle with all the electronic keys provided with your vehicle, to any authorized Lexus retailer or Lexus
authorized repairer, or any reliable repairer as soon as possible.
Locking and unlocking the
doors, opening the trunk and
using the key li nked functions

390
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
order to perform the following opera-
tions:
■Locking and unlocking the door
1 Push in the depression on the front
edge of the driver’s door handle.
2 Insert the mechanical key while
pulling on the driver’s door handle.
3 Turn the key in order to perform the
following operations.
Locks both side doors
Closes the windows (turn and
hold)*
Unlocks both side doors
Opens the windows (turn and
hold)*
*: These settings must be customized at
any authorized Lexus retailer or Lexus
authorized repairer, or any reliable
repairer.
■Opening the trunk
Unlock the doors, and press the trunk
opener switch.
1 Depress the brake pedal.
2 Touch the Lexus emblem side of the
electronic key to the engine switch
.
When the electronic key is detected, a buzzer sounds and the engine switch
will turn to IGNITION ON mode .
When the smart entry & start system is deactivated in customization setting, the engine switch will turn to
A
B
C
D
WARNING
■When using the mechanical key and operating the power windows
Operate the power window after check- ing to make sure that there is no possibil-
ity of any passenger having any of their body parts caught in the window.Also, do not allow children to operate the
mechanical key. It is possible for children and other passengers to get caught in the power window.
Starting the engine tem>

391
7
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
When trouble arises
ACCESSORY mode.
3Firmly depress the brake pedal and
check that is shown on the
multi-information display.
4 Press the engine switch switch>.
In the event that the engine tem> still cannot be started, contact
any authorized Lexus retailer or Lexus
authorized repairer, or any reliable
repairer.
■Stopping the engine
Set the parking brake, shift the shift position to P and press the engine switch as you normally do when stopping
the engine .
■Electronic key battery
As the above procedure is a temporary
measure, it is recommended that the elec- tronic key battery be replaced immediately when the battery is depleted. ( P.349)
■Alarm (if equipped)
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set, the alarm may be triggered.
■Changing engine switch
modes
Release the brake pedal and press the
engine switch in step 3
above. The engine does not start and modes will be changed each time the
switch is pressed. ( P.165, 170)

401
7
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
When trouble arises
radiator core (radiator) for any
leaks.
Radiator
Cooling fan
If a large amount of coolant leaks, immedi-
ately contact any authorized Lexus retailer
or Lexus authorized repairer, or any reli-
able repairer.
4 The coolant level is satisfactory if it
is between the “F” and “L” lines on
the reservoir.
Reservoir
“F” line
“L” line
Coolant inlet cap
5 Add coolant if necessary.
Water can be used in an emergency if
coolant is unavailable.
6 Start the engine and turn the air
conditioning system on to check
that the radiator cooling fan oper-
ates and to check for coolant leaks
from the radiator or hoses.
The fan operates when the air conditioning
system is turned on immediately after a cold start. Confirm that the fan is operating by checking the fan sound and air flow. If it
is difficult to check these, turn the air con- ditioning system on and off repeatedly. (The fan may not operate in freezing tem-
peratures.)
7 If the fan is not operating:
Stop the engine immediately and
contact any authorized Lexus
retailer or Lexus authorized
repairer, or any reliable repairer.
If the fan is operating:
Have the vehicle inspected at the
nearest authorized Lexus retailer
or Lexus authorized repairer, or any
reliable repairer.
■When adding coolant
Add coolant in accordance with the follow- ing procedure.
1 Remove the service cover.
A
B
A
B
C
D

404
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
engine coolant is unavailable.
6 Start the hybrid system and turn the
air conditioning system on to check
that the radiator cooling fan oper-
ates and to check for coolant leaks
from the radiator or hoses.
The fan operates when the air conditioning system is turned on immediately after a
cold start. Confirm that the fan is operating by checking the fan sound and air flow. If it is difficult to check these, turn the air con-
ditioning system on and off repeatedly. (The fan may not operate in freezing tem-peratures.)
7 If the fan is not operating:
Stop the hybrid system immediately
and contact any authorized Lexus
retailer or Lexus authorized
repairer, or any reliable repairer.
If the fan is operating:
Have the vehicle inspected at the
nearest any authorized Lexus
retailer or Lexus authorized
repairer, or any reliable repairer.
If “Hybrid System Overheated
Reduced Output Power” is shown
on the multi-information display
1 Stop the vehicle in a safe place.
2 Stop the hybrid system and care-
fully lift the hood.
3 After the hybrid system has cooled
down, inspect the hoses and radia-
tor core (radiator) for any leaks.
Radiator
Cooling fan
If a large amount of coolant leaks, immedi-
ately contact any authorized Lexus retailer
or Lexus authorized repairer, or any reli-
able repairer.
4 The coolant level is satisfactory if it
is between the “F”/“FULL” and
“L”/“LOW” lines on the reservoir.
Reservoir
A
B
A

405
7
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
When trouble arises
“F”/“FULL” line
“L”/“LOW” line
5 Add coolant if necessary.
Water can be used in an emergency if
power control unit coolant is unavailable.
6 After stopping the hybrid system
and waiting for 5 minutes or more,
start the hybrid system again and
check if “Hybrid System Over-
heated Reduced Output Power” is
shown on the multi-information dis-
play.
If the message does not disappear:
Stop the hybrid system and contact any authorized Lexus retailer or Lexus autho-rized repairer, or any reliable repairer.
If the message is not displayed:
The hybrid system temperature has dropped and the vehicle may be driven normally.
However, if the message appears again fre-
quently, contact any authorized Lexus retailer or Lexus authorized repairer, or any reliable repairer.
■When adding engine coolant
Add coolant in accordance with the follow- ing procedure.
1 Remove the service cover.
2 Remove the engine cover.
3 Remove caps and .
4 Add coolant through the inlet of the cap
up to the “F” line , and then
replace the cap .
5 Add coolant through the inlet of cap
until it is full, and then replace the
cap .
B
C
AB
AC
A
B
B