2018 Lexus LC500 audio

249
4
-$@-$I@0.@0.&@ &&

4-5. Using the driving support systems
Driving
Multi-information display
The BSM function/RCTA function can be
turned on/off.
The RCTA function is available when the
BSM function is on.
Outside rear view mirror indicators
BSM function:
When a vehicle is detected in a blind spot
of the outside rear view mirrors or
approaching rapidly from behind into a
blind spot, the outside rear view mirror
indicator on the detected side will illumi-
nate. If the turn signal lever is operated
toward the detected side, the outside rear
view mirror indicator will flash.
RCTA function:
When a vehicle approaching from the right
or left at the rear of the vehicle is detected,
both outside rear view mirror indicators
will flash.
BSM indicator/RCTA indicator
When the BSM function/RCTA function is
turned on, the indicator comes on.
Monitor screen display (RCTA
function only)
If a vehicle approaching from the right or
left at the rear of the vehicle is detected,
the RCTA icon ( P.256) for the detected
side will be displayed on the monitor
screen. This illustrat ion shows an example
of a vehicle approaching from the left at the
rear of the vehicle.
RCTA buzzer (RCTA function only)
If a vehicle approaching from the right or
left at the rear of the vehicle is detected, a
buzzer will sound. The buzzer also sounds
for approximately 1 second immediately
after the BSM function is operated to turn
the system on.
1 Press or of the meter con-
trol switches, select .
2 Press or of the meter con-
trol switches, select “BSM”, and
press “OK”.
3 Press or of the meter con-
trol switches, select “BSM” or
“RCTA”, and press “OK”.
■Outside rear view mirror indicator visi-
bility
In strong sunlight, the outside rear view mir-
ror indicator may be difficult to see.
■Hearing the RCTA buzzer
The RCTA buzzer may be difficult to hear
over loud noises, such as if the audio system volume is high.
■When “Blind Spot Monitor Unavailable” is shown on the mu lti-information dis-
play
Water, snow, mud, etc., may be built up in
the vicinity of the sensor area of the bumper. ( P.253) Removing the water, snow, mud, etc., from the vicinity of the sensor area of
the bumper should return it to normal.
Also, the sensor may not function normally
when used in extremely hot or cold weather.
■When “Blind Spot Monitor System Mal- function” is shown on the multi-informa- tion display
There may be a sensor malfunction or volt- age abnormality. Have the vehicle
inspected at any authorized Lexus retailer or Lexus authorized repairer, or any reliable repairer.
■Customization
Some functions can be customized. (Customizable features: P.423)
A
B
C
D
E
Turning the BSM function/RCTA
function on/off

277
5
-$@-$I@0.@0.&@ &&

5-1. Remote Touch
Interior features
■Main display
For details about the functions and
operation of the main display, refer to
the respective section and “NAVIGA-
TION SYSTEM OWNER’S MAN-
UAL”.
■Side display
The following functions can be dis-
played and operated on the side dis-
play.
Select or to display the desired
screen.
Navigation system*
Audio*
Vehicle information ( P.108)
Air conditioning system ( P.284)
Show/hide the side display
*: Refer to the “NAVIGATION SYSTEM
OWNER’S MANUAL”.
■Screen display during low temperatures
When the ambient temperature is
extremely low, screen response may be delayed even if the Remote Touch is oper-ated.
A
B
C
D
E

308
-$@-$I@0.@0.&@ &&

6-1. Maintenance and care
■CFRP (Carbon Fiber Reinforced Plas- tic) parts (if equipped)
CFRP is used for the scuff plates. When cleaning the scuff plates, remove dirt using a water-dampened soft cloth or synthetic
chamois, and then wipe the surface with a dry soft cloth to remove any remaining moisture.
WARNING
■Water in the vehicle
●LC500: Do not splash or spill liquid in the vehicle.Doing so may cause electrical compo-
nents etc. to malfunction or catch fire. LC500h: Do not splash or spill liquid in the vehicle, such as on the floor, on
the rear seats, in the hybrid battery (traction battery) air vents or in the trunk. ( P.68)
Doing so may cause the hybrid battery, electrical components, etc. to mal-function or catch fire.
●Do not get any of the SRS components
or wiring in the vehicle interior wet. ( P.35) An electrical malfunction may cause
the airbags to deploy or not function properly, resulting in death or serious injury.
■Cleaning the interior (especially
instrument panel)
Do not use polish wax or polish cleaner.
The instrument panel may reflect off the windshield, obstructing the driver’s view and leading to an accident, resulting in
death or serious injury.
NOTICE
■Cleaning detergents
●Do not use the following types of
detergent, as they may discolor the vehicle interior or cause streaks or damage to painted surfaces:
• Non-seat portions: Organic sub- stances such as benzene or gasoline,
alkaline or acidic solutions, dye, and bleach
• Seats: Alkaline or acidic solutions, such as thinner, benzene, and alcohol
●Do not use polish wax or polish cleaner. The instrument panel’s or
other interior part’s painted surface may be damaged.
■Preventing damage to leather sur-faces
Observe the following precautions to avoid damage to and deterioration of
leather surfaces:
●Remove any dust or dirt from leather surfaces immediately.
●Do not expose the vehicle to direct sunlight for extended periods of time.
Park the vehicle in the shade, espe- cially during summer.
●Do not place items made of vinyl, plas-tic, or containing wax on the uphol-
stery, as they may stick to the leather surface if the vehicle interior heats up significantly.
■Water on the floor
Do not wash the vehicle floor with water. Vehicle systems such as the audio system
may be damaged if water comes into contact with electrical components such as the audio system above or under the
floor of the vehicle. Water may also cause the body to rust.

376
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
■Conditions that the tire pressure warning system may not function properly
 P.330
■If the tire pressure warning light frequently comes on after blinking for 1 minute
If the tire pressure warning lig ht frequently comes on after blinking for 1 minute when the engine switch is turned to IGNITION ON mode , have it
checked by any authorized Lexus retailer or Lexus authorized repairer, or any reliable repairer.
■Warning buzzer
In some cases, the buzzer may not be heard due to being in a noisy location or audio sound.
WARNING
■If both the ABS and the brake system warning lights remain on
Stop your vehicle in a safe place immediately and contact any authorized Lexus retailer
or Lexus authorized repairer, or any reliabl e repairer. The vehicle will become extremely unstable during braking, and the ABS system may fail, which could cause an accident resulting in death or serious injury.
■When the electric power steering system warning light comes on
When the light comes on yellow, the assist to the power steering is restricted. When the
light comes on red, the assist to the power st eering is lost and handling operations of the steering wheel become extremely heavy. When steering wheel operations are heavier than usual, grip the steering wheel firmly and operate it using more force than usual.
■If the tire pressure warning light comes on
Be sure to observe the following precautions. Failure to do so could cause a loss of vehi-
cle control and result in death or serious injury.
●Decelerate to the lowest appropriate speed as soon as possible. Do not drive over 80 km/h (50 mph).
●Check and adjust the tire inflation pressure immediately.
●If the tire pressure warning light comes on ev en after tire inflation pressure adjustment, it is probable that you have a flat tire. Have the flat tire replaced by nearest authorized
Lexus retailer or Lexus authorized repairer, or any reliable repairer.
●Avoid abrupt maneuvering and braking. If the vehicle tires deteriorate, you could lose control of the steering wheel or the brakes.
■If a blowout or sudden air leakage should occur
The tire pressure warning system may not activate immediately.

382
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
• “Shift system malfunction” • “P switch malfunction”• “Shift system unavailable”
●If any of the following messages is shown on the multi-information display, it may indicate a malfunction in a system or part. Immediately have the vehicle inspected by any autho-
rized Lexus retailer or Lexus authorized repairer, or any reliable repairer. • “Hybrid System Malfunction” (LC500h)•“Check Engine”
• “Hybrid Battery System Malfunction” (LC500h) • “Accelerator System Malfunction”
●If any of the following messages is shown on the multi-information display, it may indicate a malfunction. Immediately stop the vehicle and contact any authorized Lexus retailer or Lexus authorized repairer, or any reliable repairer.
•“Braking Power Low” • “Charging System Malfunction”• “Oil Pressure Low”
●LC500h: If “Aux Battery Low” is shown, observe the following.
• If the message disappears in a few minutes*
Keep the hybrid system operating for more than approximately 15 minutes to charge the 12-volt battery.
• If the message does not disappear Refer to “If the 12-volt battery is discharged” ( P.392) to start the hybrid system*: It is displayed for approximately 6 seconds.
●If “Battery low” is shown, the 12-volt battery charge is insufficient. Recharge or replace the 12-volt battery.
●LC500h: If “Maintenance Required for Traction battery Cooling Parts” is shown, the fil- ters may be clogged, the air intake vents may be blocked, or there may be a gap in the
duct. Therefore, perform the following correction procedure. • If the air intake vents and filters of the hybrid battery (traction battery) are dirty, perform the procedure on P.309 to clean them.
• If the warning message is shown when the air in take vents and filters of the hybrid battery (traction battery) are not dirty, have the vehicle inspected by any authorized Lexus retailer or Lexus authorized repairer, or any reliable repairer.
■If a message that indicates the need for visi ting your any authorized Lexus retailer or
Lexus authorized repairer, or any reliable repairer is shown
The system or part shown on th e multi-information display is malfunctioning. Have the vehi-
cle inspected by any authorized Lexus retailer or Lexus authorized repairer, or any reliable repairer immediately.
■Warning buzzer
In some cases, the buzzer may not be heard due to being in a noisy location or audio sound.
NOTICE
■While the engine oil level warning message is displayed
Continued engine operation with low engine oil will damage the engine.

397
7
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
When trouble arises
LC500h (Right-hand drive vehicles)
Exclusive jump starting terminal (your vehicle)
Positive (+) battery terminal (second vehicle)
Negative (-) battery terminal (second vehicle)
Solid, stationary, unpainted metallic point away from the exclusive jump starting
terminal and any moving parts as shown in the illustration
5 Start the engine of the second vehi-
cle. Increase the engine speed
slightly and maintain at that level for
approximately 5 minutes to
recharge the 12-volt battery of your
vehicle.
6 Open and close any of the door of
your vehicle with the engine switch
off.
7 Maintain the engine speed of the
second vehicle and start the engine
of your vehicle by
turning the engine switch switch> to IGNITION ON mode
.
8 Once the vehicle’s engine system> has started, remove the
jumper cables in the exact reverse
order from which they were con-
nected.
9 Close the exclusive jump starting
terminal cover, and reinstall the fuse
box cover to tits original position.
Once the engine starts, have the vehicle inspected at any autho-rized Lexus retailer or Lexus authorized
repairer, or any reliable repairer as soon as possible.
■Starting the engine when the 12-volt battery is discharged
The engine cannot be started by push-starting.
■To prevent 12-volt battery discharge
●Turn off the headlights and the audio sys-tem while the engine is
stopped.
●Turn off any unnecessary electrical com-
A
B
C
D

426
-$@-$I@0.@0.&@ &&

8-2. Customization
■Speed warning (P.89)
■HUD (Head-up Display)*1 (P.99)
*1: If equipped
*2:LC500
*3:LC500h
■LKA (Lane-Keeping Assist)* (P.218)
FunctionDefault settingCustomized setting
Speed warningOffOn—O—
Speed setting30 km/h
(20 MPH)
30 to 260 km/h
(20 to 160 MPH)—O—
FunctionDefault settingCustomized setting
Gauge informationTachometer
Eco Driving Indica-
tor Light*2
—O—Hybrid System Indi-
cator*3
No display
Driving support display (Naviga-
tion system*1)OnOff—O—
Driving support display (Lane dis-
play*1)OnOff—O—
Driving support display (Driving
assist*1)OnOff—O—
Driving support display (Com-
pass*1)OnOff—O—
Driving support display (Audio*3)OnOff—O—
FunctionDefault settingCustomized setting
Lane centering functionOffOn—O—
Steering assistOnOff—O—
Alert sensitivityStandardHigh—O—
ABC
ABC
ABC

435
8
-$@-$I@0.@0.&@ &&

8-2. Customization
Vehicle specifications
■Vehicle customization
●When the speed-detecting automatic door lock and shift-linked automatic door
lock are both on, the door lock operates as follows.• When shifting the shift position to any
position other than P, both side the doors will be locked.• If the vehicle is started with both side
doors locked, the speed-detecting auto- matic door lock will not operate.
• If the vehicle is started with any door unlocked, the speed-detecting auto-matic door lock will operate.
●When the smart entry & start system is off, the entry unlock function cannot be
customized.
●When the doors remain closed after
unlocking the doors and the timer acti- vated automatic door lock function acti-vates, signals will be generated in
accordance with the operational signal (Emergency flashers) function setting.
●Some settings can be changed using a switch or the audio system screen. If a setting is changed using a switch, the
changed setting will not be reflected on the audio system screen until the engine switch is turned off and
then to IGNITION ON mode .
Chassis control in custom modeNormalSportO——Comfort
Air conditioning operation in cus-
tom modeNormalEcoO——
FunctionDefault settingCustomized settingABC