2018 KIA STONIC coolant level

Normal Maintenance Schedule - For Diesel Engine [Except Europe (Including Russia)]
The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for
all vehicle emission services to protect your warranty. Where both mileage and time are shown, the frequency of service is determined by whichever occurs first.
NO.ITEMREMARK
*1 Engine oil and engine oil filter Check the engine oil level and leak every 500 km (350 miles) or before start‐ ing a long trip.
*2 Engine oil and engine oil filter (For
Diesel Engine) • The engine oil level should be checked regularly and maintained properly.
Operating with an insufficient amount oil can damage the engine, and suchdamage is not covered by warranty.
• This maintenance schedule depends on fuel quality. It is applicable only when using a qualified fuel <"EN590 or equivalent">. If the diesel fuel speci‐fications don't meet the EN590, it must be replaced according to the severe
maintenance schedule.
*3 Coolant (Engine) When adding coolant, use only deionized water or soft water for your vehicle
and never mix hard water in the coolant filled at the factory. An improper
coolant mixture can result in serious malfunction or engine damage.
*4 Drive belts (Engine) • Adjust alternator, water pump and air conditioner (if equipped) drive belt.
Inspect and if necessary repair or replace.
• Inspect drive belt tensioner, idler and alternator pulley and if necessary cor‐ rect or replace.
*5 Manual transaxle fluid Manual transaxle fluid should be changed anytime it has been submerged in
water.
Maintenance

8-34

ENGINE COOLANT
The high-pressure cooling system has
a reservoir filled with year round anti‐
freeze coolant. The reservoir is filled at the factory.
Check the antifreeze protection and
coolant level at least once a year, at the
beginning of the winter season, and be‐ fore traveling to a colder climate.
CAUTION
•When the engine overheats fromlow engine coolant, suddenly add‐ing engine coolant may causecracks in the engine. To preventdamage, add engine coolant slowlyin small quantities.
•Do not drive with no engine cool‐ant. It may cause water pump fail‐ure and engine seizure, etc.
Checking the coolant level
WARNING
Removing radiator cap
•Never attempt to remove the radi‐ator cap while the engine is oper‐ating or hot. Doing so might leadto cooling system and engine dam‐age. Also, hot coolant or steamcould cause serious personal in‐jury.
•Turn the engine off and wait untilit cools down. Use extreme carewhen removing the radiator cap.Wrap a thick towel around it, andturn it counterclockwise slowly tothe first stop. Step back while thepressure is released from the cool‐ing system.When you are sure all the pressurehas been released, press down onthe cap, using a thick towel, andcontinue turning counterclockwiseto remove it.
(Continued)
(Continued)
•Even if the engine is not operating,do not remove the radiator cap orthe drain plug while the engine andradiator are hot. Hot coolant andsteam may still blow out underpressure, causing serious injury.
WARNING
The electric motor (cool‐ing fan) is controlled byengine coolant tempera‐ture, refrigerant pressureand vehicle speed.
It may sometimes operate evenwhen the engine is not running. Useextreme caution when working nearthe blades of the cooling fan so thatyou are not injured by a rotating fanblades. As the engine coolant tem‐perature decreases, the electric mo‐tor will automatically shut off. Thisis a normal condition.
Maintenance
8-48

¥
,BQQB
-
5(%*
&OHJOF
(BTPMJOF

¥
,BQQB
--
.1*
&OHJOF
(BTPMJOF

0:##
6**
-
&OHJOF
%JFTFM

Check the condition and connections of
all cooling system hoses and heater ho‐ ses. Replace any swollen or deteriora‐
ted hoses.
The coolant level should be filled be‐
tween MAX and MIN (F and L) marks on the side of the coolant reservoir when
the engine is cool.
If the coolant level is low, add enough
distilled (deionized) or soft water. Bring the level to MAX (F), but do not overfill.
If frequent additions are required, have
the system inspected by a professional
workshop. Kia recommends to visit an authorized Kia dealer/service partner.
Recommended engine coolant
• When adding coolant, use only deion‐ ized water or soft water for your ve‐
hicle and never mix hard water in the
coolant filled at the factory. An im‐
proper coolant mixture can result in serious malfunction or engine dam‐
age.
• The engine in your vehicle has alumi‐ num engine parts and must be pro‐
tected by an ethylene-glycol with
phosphate based coolant to prevent corrosion and freezing.
• DO NOT USE alcohol or methanol coolant or mix them with the speci‐
fied coolant.
• Do not use a solution that contains more than 60% antifreeze or lessthan 35% antifreeze, which would re‐
duce the effectiveness of the solu‐
tion.
For mixture percentage, refer to the
following table.
AmbientTempera‐ture
Mixture Percentage(volume)
AntifreezeWater
-15°C (5°F) 35 65

8-49
8
Maintenance

WASHER FLUID
Checking the washer fluid level
The reservoir is translucent so that you
can check the level with a quick visual inspection.
Check the fluid level in the washer fluid
reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available. However, use washer
solvent with antifreeze characteristics
in cold climates to prevent freezing.
WARNING
nCoolant
•Do not use radiator coolant or an‐tifreeze in the washer fluid reser‐voir.
•Radiator coolant can severely ob‐scure visibility when sprayed onthe windshield and may cause lossof vehicle control or damage topaint and body trim.
•Windshield Washer fluid agentscontain some amounts of alcoholand can be flammable under cer‐tain circumstances. Do not allowsparks or flame to contact thewasher fluid or the washer fluidreservoir. Damage to the vehicle oroccupants could occur.
•Windshield washer fluid is poison‐ous to humans and animals. Donot drink and avoid contactingwindshield washer fluid. Seriousinjury or death could occur.

8-55
8
Maintenance