2018 KIA RIO HATCHBACK open hood

Maintenance
80
8
Light bulb position (Side)
(1) Side repeater lamp (LED type)
(2) Side repeater lamp (bulb type)
Headlamp (Low/High beam)
bulb replacement
(Headlamp Type A)
1. Open the hood.
2. Remove the headlamp bulb cover
by turning it counterclockwise.
3. Disconnect the headlamp bulb socket-connector.
4. Unsnap the headlamp bulb retain- ing wire by pressing the end and
pushing it upward.
5. Remove the bulb from the head lamp assembly. 6. Install a new headlamp bulb and
snap the headlamp bulb retaining
wire into position by aligning the
wire with the groove on the bulb.
7. Connect the headlamp bulb sock- et-connector.
8. Install the headlamp bulb cover by turning it clockwise.
OYB076047
OYB076048
■Type A
■Type B
OYB076049

881
Maintenance
Headlamp bulb Always handle them carefully, andavoid scratches and abrasions. If
the bulbs are lit, avoid contact with
liquids. Never touch the glass with
bare hands. Residual oil may
cause the bulb to overheat and
burst when lit. A bulb should be
operated only when installed in a
headlamp.
If a bulb becomes damaged or cracked, replace it immediately
and carefully dispose of it.
Wear eye protection when chang- ing a bulb. Allow the bulb to cool
down before handling it.Front turn signal lamp bulb
replacement (Headlamp Type A)
1. Open the hood.
2. Remove the bulb-socket from the headlamp assembly by turning the
bulb-socket counterclockwise until
the tabs on the bulb-socket align
with the slots on the headlamp
assembly.
3. Remove the bulb from the bulb- socket by pressing it in and rotat-
ing it counterclockwise until the
tabs on the bulb align with the
slots in the bulb-socket. Pull the
bulb out of the bulb-socketWARNING- Halogen
bulbs
Handle halogen bulbs with care.
Halogen bulbs contain pres- surized gas that will produce
flying pieces of glass if bro-
ken.
OHD076046
OYB076051

Maintenance
82
8
4. Insert a new bulb by inserting it
into the bulb-socket and rotating it
until it locks into place.
5. Install the socket in the headlamp assembly by aligning the tabs on
the bulb-socket with the slots in
the assembly. Push the bulb-sock-
et into the headlamp assembly
and turn the socket clockwise.Headlamp (Low/High beam)
bulb replacement (Headlamp
Type B)
1. Open the hood.
2. Remove the headlamp bulb coverby turning it counterclockwise.
3. Disconnect the headlamp bulb socket-connector.
4. Remove the bulb-socket from the headlamp assembly by turning the
bulb-socket counterclockwise until
the tabs on the bulb-socket align
with the slots on the headlamp
assembly. 5. Install a new bulb-socket assem-
bly in the headlamp assembly by
aligning the tabs on the bulb-sock-
et with the slots in the headlamp
assembly. Push the bulb-socket
into the headlamp assembly and
turn the bulb-socket clockwise.
6. Install the headlamp bulb cover by turning it clockwise.
OYB076052

883
Maintenance
Headlamp bulb Always handle them carefully, andavoid scratches and abrasions. If
the bulbs are lit, avoid contact with
liquids. Never touch the glass with
bare hands. Residual oil may
cause the bulb to overheat and
burst when lit. A bulb should be
operated only when installed in a
headlamp.
If a bulb becomes damaged or cracked, replace it immediately
and carefully dispose of it.
Wear eye protection when chang- ing a bulb. Allow the bulb to cool
down before handling it.Front turn signal lamp bulb
replacement (Headlamp Type B)
1. Open the hood.
2. Remove the headlamp bulb cover by turning it counterclockwise.
3. Remove the bulb-socket from the headlamp assembly by turning the
bulb-socket counterclockwise until
the tabs on the bulb-socket align
with the slots on the headlamp
assembly.
OQL075058
WARNING- Halogen
bulbs
Handle halogen bulbs with care.
Halogen bulbs contain pres- surized gas that will produce
flying pieces of glass if bro-
ken.
OYB076054

Index
6I
Fuel filler lid ..................................................................4-38Opening the fuel filler lid ..........................................4-38
Closing the fuel filler lid ............................................4-38
Fuel gauge......................................................................4-\
55
Fuses ........................................................................\
......8-60 Inner panel fuse replacement ......................................8-62
Memory fuse ..............................................................8-63
Engine compartment fuse replacement ......................8-64
Fuse/relay panel description ......................................8-66
Gauges ........................................................................\
..4-54
Glove box ....................................................................4-12\
8
Glove box lamp............................................................4-101
Glove box lamp bulb replacement ................................8-99
Hazard warning flasher ....................................................7-2
Hazardous driving conditions ........................................6-57
Headlamp (Low/High beam) bulb replacement (Headlamp type B) ......................................................8-82
Headlamp (Low/High beam) bulb replacement (Headlamp Type A) ....................................................8-80
Headlight escort function ..............................................4-87
Headlight position..........................................................4-89
Headlight welcome function..........................................4-87 Headrest (Front) ..............................................................3-6
Heated steering wheel....................................................4-48
High - beam operation ..................................................4-90
High mounted stop lamp bulb replacement (4 door) ....8-96
High mounted stop lamp bulb replacement (5 door) ....8-91
Highway driving ............................................................6-60
Hill-start assist control (HAC) ......................................6-33
Hood ........................................................................\
......4-36
Opening the hood ........................................................4-36
Closing the hood ........................................................4-37
Hood open warning ....................................................4-37
Horn ........................................................................\
......4-47
Ignition switch position ..................................................6-6
Indicator lights ..............................................................4-82
Inside rearview mirror ..................................................4-49
Instrument cluster ..........................................................4-52 Instrument cluster control ..........................................4-53
LCD window control ..................................................4-53
Gauges ........................................................................\
4-54
Warning lights ............................................................4-74
Indicator lights ............................................................4-82
Interior care..................................................................8-106
Interior features............................................................4-131 Cup holder ................................................................4-131
Sunvisor ....................................................................4-13\
1
G
H
I