4
Instrument Panel
1 Multi-function touch-screen/RearView Monitor display/Around View® Monitor display
2 Infiniti multi-function controller
3 Audio system
4 Climate control panel
5 Shift lever
6 Lower center console switch panel
• 2nd row seat release buttons
• Climate-controlled seat switches (if so equipped)
• Front passenger air bag status light
7 Parking brake
8 Switch panel
• Power liftgate button
• Safety Shield OFF switch
• Blind Spo t/RCTA OFF switch (if so equipped)
• Power Liftgate ON/OFF switch
• Steering wheel heater
3059068_18a_QX80_US_pQRG_101717.indd 410/17/17 1:15 PM
12
Clock Set/Adjustment
2 3
SYSTEM OPERATING TIPS
• The interior of the vehicle should be as quiet as possible.
• Speak naturally. Speaking too fast, too slow, too soft, or
too loud makes voice recognition more difficult.
• Confirm that the correct voice commands are being used. Glance at the screen to see the currently
available commands.
USING THE VOICE RECOGNITION SYSTEM
• Press the button 1 on the steering wheel, and a list of
commands will appear on the screen.
• After the tone sounds, speak the command.
• To skip the voice prompt and give the command immediately, press the
button 1 on the steering wheel
to interrupt the system. Speak the next command after the
tone sounds.
• To cancel the command, press and hold the button 1 on
the steering wheel.
Please see your Owner’s Manual for important safety information, system
limitations, and additional operating and feature information.
Voice Recognition
1
To adjust the time and the appearance of the clock on the display:
Pr
ess the SETTING button on the control panel.
Locate and touch the “Clock” key to adjust “On-Screen Clock”, “Daylight
Savings Time”, “Clock Format (24h)”, and “Time Zone” on the display.
The time can be adjusted through “Offset Adjustment”
1 by adjusting the
minutes and/or hours forward or backward. The current clock time can be
set up to a difference of 12 hours and 59 minutes.
ANALOG CLOCK
To set the clock forward, press the button
2.
To set the clock backward, press the button
3.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.
1
3059068_18a_QX80_US_pQRG_101717.indd 1210/17/17 1:16 PM
15
• To slide the seat forward or backward, push the switch 1 forward
or backward.
• To recline the seatback, push the switch 2 forward or backward.
SEAT LIFTER
• To adjust the angle of the front portion or height of the seat, push the front or rear end of the
switch 1 up or down.
LUMBAR SUPPORT
• Push each side o f the adjusting switch 3 to adjust the seat lumbar area
until the desired position is achieved.
SEAT/STEERING POSITIONING ON EXIT
• The shift le ver must be in P (PARK) position with the
ignition switch in the OFF position.
• The entry/exit function can be activated or canceled by pushing and holding the SET switch
4, located on the
driver’s side door, for more than 10 seconds.
Please see your Owner’s Manual for important safety information, system limitations, and additional operating
and feature information.
Seat Adjustments
2
3
1
4
Head Restraint Adjustment
To raise the head restraint: Pull the head restraint up.
To lower the head restraint: Push and hold the lock
knob
1 and push the head restraint down.
Make sure the head restraint is fully engaged in
position after any adjustment.
Please see your Owner’s Manual for important safety information,
system limitations, and additional operating and feature information.
1
3059068_18a_QX80_US_pQRG_101717.indd 1510/17/17 1:17 PM
