CHECKING BRAKE PEDAL
With the engine running, check the distanceA
between the upper surface of the pedal and
the metal floor. If it is out of the range shown,
it is recommended that you visit an INFINITI
retailer for service.
Distance A: Under depression force of
490 N (110 lbs)
90 mm (3 1/2 in) or more
Self-adjusting brakes
Your vehicle is equipped with self-adjusting
brakes. The front and rear disc-type brakes self-
adjust every time the brake pedal is applied.
WARNING
Have your brake system checked if the
brake pedal height does not return to nor-
mal. It is recommended that you visit an
INFINITI retailer for this service.
Brake pad wear indicators
The disc brake pads on your vehicle have
audible wear indicators. When a brake pad
requires replacement, a high pitched scraping
or screeching sound will be heard when the
vehicle is in motion. The noise will be heard
whether or not the brake pedal is depressed.
Have the brakes checked as soon as possible
if the wear indicator sound is heard.
Under some driving or climate conditions, oc-
casional brake squeak, squeal or other noise
may be heard. Occasional brake noise during
light to moderate stops is normal and does
not affect the function or performance of the
brake system.
Proper brake inspection intervals should be
followed.
For additional information regard-
ing brake inspections, refer to the appropri-
ate maintenance schedule information in the
“INFINITI Service and Maintenance Guide”.
BRAKE BOOSTER
Check the brake booster function as follows:
1. With the engine off, press and release the brake pedal several times. When
brake pedal movement (distance of
travel) remains the same from one pedal
application to the next, continue on to
the next step.
2. While depressing the brake pedal, start the engine. The pedal height should drop
a little.
3. With the brake pedal depressed, stop the engine. Keep the pedal depressed for
about 30 seconds. The pedal height
should not change.
4. Run the engine for one minute without depressing the brake pedal, then turn it
off. Depress the brake pedal several
times. The pedal travel distance will de-
crease gradually with each depression as
the vacuum is released from the booster.
If the brakes do not operate properly, have
the brakes checked. It is recommended that
you visit an INFINITI retailer for this service.
WDI0229
Maintenance and do-it-yourself8-23
ENGINE COMPARTMENT
CAUTION
Never use a fuse of higher or lower amper-
age rating than that specified on the fuse
box cover.
If any electrical equipment does not come on,
check for an open fuse. 1. Be sure the ignition switch and the head- light switch are OFF.
2. Open the engine hood. 3. Remove the fuse box cover by pushing
the tab and lifting the cover up.
4. Remove the fuse with the fuse puller. The fuse puller is located in the fuse
block in the passenger compartment. 5. If the fuse is open
A, replace it with a
new fuse
B.
6. If a new fuse also opens, have the elec- trical system checked and repaired by an
INFINITI retailer.
Fusible links
If the electrical equipment does not operate
and fuses are in good condition, check the
fusible links. If any of these fusible links are
melted, replace with only Genuine NISSAN
parts.
LDI2267LDI0456
FUSES
8-24Maintenance and do-it-yourself
9 Technical and consumer information
Recommended fluids/lubricants and capacities....9-2
Fuel Information ..............................9-4
Recommended SAE viscosity number ..........9-4
Air conditioner system refrigerant and
oil recommendations ..........................9-5
Specifications ....................................9-6
Engine ........................................9-6
Wheels and tires ..............................9-7
Dimensions and weights .......................9-7
When traveling or registering in another
country ..........................................9-8
Vehicle identification .............................9-8
Vehicle Identification Number (VIN) plate ......9-8
Vehicle identification number
(chassis number) ..............................9-8 Engine serial number
..........................9-9
Certification plate
(For Gulf standard models) ....................9-9
Tire placard ................................. 9-10
Air conditioner specification label ............9-10
Installing front license plate .....................9-10
Vehicle loading information .....................9-12
Terms ...................................... 9-12
Vehicle load capacity ........................ 9-12
Securing the load ............................ 9-14
Loading tips ................................ 9-15
Measurement of weights ....................9-15
Uniform tire quality grading .....................9-15
The following are approximate capacities. The actual refill capacities may be slightly different. When refilling, follow the procedure described
in the “Maintenance and do-it-yourself” section to determine the proper refill capacity.
Fluid typeCapacity (approximate) Recommended Fluids/Lubricants
Metric
Measure US
Measure Imperial
Measure
Fuel 74 L 19-1/2 gal 16-1/4 gal • For additional information, refer to “Fuel Information” in this section.
Engine oil*1
Drain and refill
*1: For additional information,
refer to “Engine oil” in the
“Maintenance and do-it-
yourself” section of this manual. With oil
filter change 4.8 L 5-1/8 qt 4-1/4 qt For Mexico
• Genuine “Nissan Motor Oil Ester 5W-30 SN” is recommended.
Except for Mexico
• Genuine “Nissan Motor Oil 0W-20 SN” is recommended.
• If above motor oil is not available, use “NISSAN Motor Oil”
equivalent that matches the following grade and viscosity.
• Oil grade: API SM or SN, ILSAC GF-4 or GF-5
• SAE Viscosity: For additional information, refer to “Recommended
SAE viscosity number” in this section.
Without oil
filter change 4.5 L 4-3/4 qt 4 qt
Engine coolant
(with reservoir) 9.6 L 2-1/2 gal 2-1/8 gal• Genuine NISSAN Engine Coolant (blue) or equivalent.
• Use Genuine NISSAN Engine Coolant or equivalent in tis quality, in
order to avoid possible aluminum corrosion within the engine cooling
system caused by the use of non-genuine engine coolant. Note that
any repairs for the incidents within the engine cooling system while
using non-genuine engine coolant may not be covered the warranty
even if such incidents occurred during the warranty period.
Continuously Variable Transmission (CVT) fluid ———• Genuine NISSAN CVT Fluid NS-3
• Use only Genuine NISSAN CVT Fluid NS-3. Using transmission fluid
other than Genuine NISSAN CVT Fluid NS-3 will damage the CVT,
which is not covered by the warranty.
RECOMMENDED FLUIDS/
LUBRICANTS AND CAPACITIES
9-2Technical and consumer information
ENGINE
ModelVQ35DE/VQ35DD
Type Gasoline, 4-cycle, DOHC
Cylinder arrangement 6-cylinder, V-block, Slanted at 60°
Bore x Stroke mm (in) 95.5 x 81.4 (3.760 x 3.205)
Displacement cm
3(cu in) 3,498 (213.45)
Firing order 1–2–3–4–5–6
Idle speed
No adjustment is necessary.
CVT (in “N” position)
Ignition timing (degree B.T.D.C. at idle speed)
CO%atidle
Spark plug
FXE22HR-11
Spark plug gap (Nominal) mm (in) 1.1 (0.043)
Camshaft operation Timing chain
Maximum vehicle speed (for Gulf Standard Models) km/h (mph) 190 (118)
Maximum vehicle speed:
Gulf Standard regulation requires automobile manufacturers to indicate the maximum vehicle speed for applicable models. The maximum vehicle speed, listed above,
is the measured speed under certain testing conditions. The actual value may differ according to the vehicle usage and road and environmental conditions.
INFINITI recommends you to ALWAYS observe posted speed limits and never drive too fast for conditions.
SPECIFICATIONS
9-6Technical and consumer information
When planning to drive your INFINITI ve-
hicle in another country,you should first find
out if the fuel available is suitable for your
vehicle's engine.
Using fuel with an octane rating that is too
low may cause engine damage. All gasoline
vehicles must be operated with unleaded
gasoline. Therefore, avoid taking your vehicle
to areas where appropriate fuel is not avail-
able.
When transferring the registration of your
vehicle to another country, state, province
or district, it may be necessary to modify the
vehicle to meet local laws and regulations.
The laws and regulations for motor vehicle
emission control and safety standards vary
according to the country, state, province or
district; therefore, vehicle specifications may
differ.
When any vehicle is to be taken into another
country, state, province or district and reg-
istered, its modifications, transportation,
and registration are the responsibility of the
user. INFINITI is not responsible for any in-
convenience that may result.
VEHICLE IDENTIFICATION
NUMBER (VIN) PLATE
The VIN plate is located as shown. This num-
ber is the identification for your vehicle and is
used in the vehicle registration.
The VIN number is also available through the
center display screen. For additional informa-
tion, refer to your “INFINITI InTouch™ Own-
er’s Manual”.
VEHICLE IDENTIFICATION
NUMBER (chassis number)
The vehicle identification number is located
as shown.
TI1050MLTI2028
WHEN TRAVELING OR
REGISTERING IN ANOTHER
COUNTRY VEHICLE IDENTIFICATION
9-8Technical and consumer information
ENGINE SERIAL NUMBER
The number is stamped on the engine as
shown.
CERTIFICATION PLATE
(For Gulf standard models)VQ35DE engine
LTI2133
VQ35DD engine
LTI2255WTI0172
Technical and consumer information9-9
10 Index
2nd row bench seat adjustment....1-5,1-7
A
Air bag (See supplemental restraint
system).....................1-47
Air bag system Front (See supplemental front impact
airbagsystem)..............1-54
Air bag warning labels ............1-65
Airbagwarninglight.........1-65,2-13
Air bag warning light,
supplemental ..............1-65,2-13
Air cleaner ...................8-20
Air cleaner housing filter ..........8-20
Air conditioner Air conditioner operation ........4-34
Air conditioner specification label . . .9-10
Air conditioner system refrigerant
and oil recommendations .........9-5
Filter ....................8-20
Heater and air conditioner (automatic)
(if so equipped) ..............4-33
Heater and air conditioner controls . .4-34
Servicing air conditioner .........4-42
Alarm system (See
vehicle security system) ...........2-32
Anchor point locations ............1-31
Antenna ....................4-42
Antifreeze ..................5-151
Anti-lock brake warning light .........2-9
Anti-lock Braking System (ABS) .....5-141Armrests.....................1-8
Around View® Monitor
............4-3
Audible reminders ...............2-15
Autolight switch ...............2-40
Automatic Automatic drive positioner . . .3-37, 3-39
Automatic power window switch . . .2-64
Automatic anti-glare inside mirror .....3-33
Automatic door locks .............3-6
Automatic drive positioner .....3-37,3-39
B
Backup Collision Intervention (BCI) ....5-60
Battery ................5- 151, 8-16
Charge warning light ...........2-10
Battery replacement .............8-25
INFINITI Intelligent Key .........8-26
Keyfob...................8-25
Before starting the engine ..........5-17
Belt (See drive belt) ..............8-18
Blind Spot Intervention® (BSI) .......5-48
Blind Spot Warning (BSW) .........5-38
Boosterseats.................1-43
Brake Anti-lock Braking System (ABS) . . .5-141
Brake booster ...............8-23
Brakefluid.................8-14
Brakelight(Seestoplight) .......8-29
Brakepedal ............8-22,8-23
Brake system ...............5-141
Brakewarninglight ............2-9 Brake wear indicators
......2-15,8-23
Parking brake check ...........8-22
Parking brake operation .........5-23
Self-adjusting brakes ..........8-23
Brakeassist .................5-142
Brakefluid...................8-14
Brake system .................5-141
Break-in schedule ..............5-132
Brightness control Instrument panel .............2-44
Bulb check/instrument panel .........2-8
Bulb replacement ...............8-29
C
C
apacities and recommended
fuel/lubricants .................9-2
Cargoareastoragebin ...........2-61
Cargolight................... 2-73
Cargo (See vehicle loading information). .9-12
Car phone or CB radio ............4-42
Check engine indicator light (See
malfunction indicator lamp) .........2-14
Check tire pressure ..............2-28
Child restraints .....1-19,1-20,1-26,1-28
LATCH (Lower Anchors and Tethers
for CHildren) System ...........1-28
Precautions on child
restraints ......1-26,1-33,1-38,1-43
Top tether strap anchor point
locations..................1-31
Child restraint with top tether strap ....1-30