616
Maintenance
Accessories and Modifications
Accessories
When installing accessories, check the following:
• Do not install accessories on the windshie ld. They can obstruct your view and
delay your reaction to driving conditions.
• Do not install any accessorie s over areas marked SRS Airbag, on the sides or backs
of the front seats, on front or side pillars, or near the side windows.
Accessories installed in these areas may interfere with proper operation of the
vehicle’s airbags or may be propelled into you or another occupant if the airbags
deploy.
• Be sure electronic accessories do not over load electrical circuits or interfere with
proper operation of your vehicle.
2 Fuses P. 644
•Before installing any electronic accessory, have the inst aller contact a dealer for
assistance. If possible, have a d ealer inspect the final installation.
Modifications
Do not modify your vehicle in a manner that may affect its handling, stability, or reliability,
or install non-genuine Honda parts or accessories that may have a similar effect.
Even minor modifications to vehicle systems can affect overall vehicle performance.
Always make sure all equipment is properly installed and maintained, and do not make any
modification to your vehicle or its systems that might cause your vehicle to no longer meet
federal, state, province, territory, and local regulations.
The on-board diagnostic port (OBD-II/SAE J1962 connector) installed on this vehicle
is intended to be used with automobile system diagnostic devices or with other
devices that Honda has approved. Use of any other type of device may adversely
affect the vehicle's electronic systems or allow them to be compromised, possibly
resulting in a system malfunction, drained battery, or other unexpected problems.
Do not modify or attempt to repair any of the electrical components.
1 Accessories and Modifications
Honda Genuine accessor ies are recommended to
ensure proper operati on on your vehicle.
3WARNING
Improper accessories or modifications can
affect your vehicle's handling, stability, and
performance, and cause a crash in which
you can be seriously hurt or killed.
Follow all instruction s in this owner's
manual regarding accessories and
modifications.
18 CR-V-31TLA6100.book 616 ページ ２０１７年９月７日 木曜日 午後３時５６分
645
uuFuses uFuse Locations
Continued
Handling the Unexpected
Circuit ProtectedAmps
12FI ECU*110 A
−*2−
13Front Wiper Deicer*315 A
−*4−
14Hazard10 A
15IG Coil15 A
16Transmission*115 A
−*2−
17−−
18Back Up10 A
19Audio15 A
20E-DPS*(20 A)
21Rear Seat Heater*5(20 A)
−*6−
22Front Fog Lights*/Lower
Shutter Grille(15 A)*7
15 A*8
23A/C Compressor/Upper Shutter Grille10 A
24Horn10 A
25Cooling Fan7.5 A
26−−
27−−
28−*1−
ST Magnetic Switch*2(7.5 A)
29−−
30−−
*1:Models with smart entry system
*2:Models without smart entry system
*3:Canadian models
*4:U.S. models
*5:Canadian models with rear seat heater
*6:Models without rear seat heater
*7:U.S. models and Canadian models with power seat
*8:Canadian models without power seat Located under the dashboard.
Fuse locations are shown on the label on
the steering colu
mn lower cover.
Locate the fuse in question by the fuse
number and label number.■Interior Fuse Box
Fuse Label
Fuse Box
* Not available on all models
18 CR-V-31TLA6100.book 645 ページ ２０１７年９月７日 木曜日 午後３時５６分
647
uuFuses uInspecting and Changing Fuses
Handling the Unexpected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK (0*1. Turn
headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine
compartment.
u If the fuse is blown, use a Phillips-head
screwdriver to remove the screw and
replace it with a new one.
4. Inspect the small fu ses in the engine
compartment and the vehicle interior.
u If there is a blown fuse, remove it with
the fuse puller, and replace it with a new
one.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Inspecting and Changing Fuses
NOTICE
Replacing a fuse with on e that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Use the charts to locate the fuse in question and
conform the specific amperage on the fuse label. 2 Fuse Locations P. 644
There is a fuse puller on the back of the engine
compartment fuse box cover.
Combined
Fuse Blown Fuse
Fuse Puller
18 CR-V-31TLA6100.book 647 ページ ２０１７年９月７日 木曜日 午後３時５６分
