2018 HONDA ACCORD SEDAN lock

uuMaintenance Under the Hood uCooling System
584
Maintenance
1. Make sure the engine and radiator are
cool.
2. Turn the radiator cap 1/8 turn counter-
clockwise to relieve any pressure in the
cooling system.
3. Push down and turn the radiator cap
counter-clockwise to remove it.
4. The coolant level should be up to the base
of the filler neck. Add coolant if it is low.
5. Put the radiator cap back on, and tighten it
fully.
■Radiator1Radiator
NOTICE
Pour the fluid slowly and ca refully so you do not spill
any. Clean up any spills immediately; they can
damage components in the engine compartment.
Radiator Cap
18 ACCORD HYBRID-31TWA6000.book 584 ページ ２０１８年１月３０日　火曜日　午後７時３８分

uuReplacing Light Bulbs uHeadlight Bulbs
590
Maintenance
1. Remove the hose and the holding clip using
a flat-tip screwdriver, then remove the
upper part of the window washer reservoir.
u Check the amount of window washer
fluid is below the upper part of the
window washer reservoir and remove it.
2. Push the tab to remove the coupler.
3. Rotate the old bulb counter-clockwise to
remove.
4. Insert a new bulb into the headlight
assembly and turn it clockwise.
5. Insert the coupler into the connector of the
bulb.
Low beam headlights are LED type. Have an authorized Honda dealer inspect and
replace the light assembly.
■High Beam Headlights1 High Beam Headlights
High beam headlights ar e LED type. Have an
authorized Honda dealer in spect and replace the light
assembly.
When removing the clip, insert a flat-tip screwdriver,
then lift and remove the clip.
Insert the clip with the pin raised, and push until it is
flat.
Models with LED high beam headlights
Push until the pin
is flat.
Models with halogen high beam headlights
Holding
clip
Hose
Passenger side
Tab
Coupler
BulbBoth sides
■Low Beam Headlights
18 ACCORD HYBRID-31TWA6000.book 590 ページ ２０１８年１月３０日　火曜日　午後７時３８分

593
uuReplacing Light Bulbs uBrake Lights, Taillights, Rear Side Marker Lights, and Rear Turn Signal Light Bulbs
Maintenance
4. Turn the socket counter-clockwise and
remove it.
5. Push and turn the old bulb clockwise and
remove it, and insert a new bulb.
Bulb
Socket
18 ACCORD HYBRID-31TWA6000.book 593 ページ ２０１８年１月３０日　火曜日　午後７時３８分

594
uuReplacing Light Bulbs uTaillights, Brake Lights*, and Back-Up Light Bulbs
Maintenance
Taillights, Brake Lights*, and Back-Up Light Bulbs
When replacing, use the following bulbs.
1.Remove the holding clips using a flat-tip
screwdriver, then pull the lining back.
2. Turn the socket counter-clockwise and
remove it.
3. Remove the old bulb and insert a new bulb.
Taillight: LED
Brake Light*: LED
Back-Up Light: 16 W
1 Taillights, Brake Lights*, and Back-Up Light Bulbs
Taillights a nd brake lights
* are LED type. Have an
authorized Honda dealer in spect and replace the light
assembly.
When removing the clip, insert a flat-tip screwdriver,
then lift and remove the clip.
Insert the clip with the pin raised, and push until it is
flat.
Clip
Push until the
pin is flat.
Holding Clip
Bulb
Socket
Driver side
* Not available on all models
18 ACCORD HYBRID-31TWA6000.book 594 ページ ２０１８年１月３０日　火曜日　午後７時３８分

599
uuChecking and Maintaining Wiper Blades uChanging the Wiper Blade Rubber
Maintenance
7. Insert the flat side of the new wiper blade
onto the bottom part of the holder. Insert
the blade all the way.
8. Install the end of the wiper blade into the
cap.
9. Slide the holder onto the wiper arm until it
locks.
10. Lower the passenger side wiper arm first,
then the driver side.
11. Set the power mode to ON and hold the
wiper switch in the MIST position until
both wiper arms return to the standard
position.
Holder Blade
Cap
18 ACCORD HYBRID-31TWA6000.book 599 ページ ２０１８年１月３０日　火曜日　午後７時３８分

609
Maintenance
12-Volt Battery
Checking the 12-Volt Battery
The condition of the battery is monitored by a
sensor located on the negative terminal of the
battery. If there is a problem with this sensor,
the driver information interface will display a
warning message. If this happens, have you
vehicle inspected by a dealer.
Check the battery terminals for corrosion
monthly.
If your vehicle’s battery is disconnected or goes dead:
• The audio system is disabled.
2 Reactivating the audio system P. 241
•The clock resets.
2 Clock P. 164
•The immobilizer system needs to be reset.
2 Immobilizer System Indicator P. 98
112-Volt Battery
WARNING: Battery post, terminals,
and related accessories contain lead
and lead compounds.
Wash your hands after handling.
3WARNING
The battery gives off explosive hydrogen
gas during normal operation.
A spark or flame can cause the battery to
explode with enough force to kill or
seriously hurt you.
When conducting any battery
maintenance, wear prot ective clothing and
a face shield, or have a skilled technician do
it.
Canadian models
18 ACCORD HYBRID-31TWA6000.book 609 ページ ２０１８年１月３０日　火曜日　午後７時３８分

uuCleaning uInterior Care
614
Maintenance
The driver’s floor mat hooks over the floor
anchors, which keep the mat from sliding
forward. To remove a mat for cleaning, turn
the anchor knobs to the unlock position.
When reinstalling the mat after cleaning, turn
the knobs to the lock position.
Do not put additional floor mats on top of
the anchored mat.
To properly clean leather:
1. Use a vacuum or soft dry cloth first to remove any dirt or dust.
2. Clean the leather with a soft cloth dampen ed with a solution comprised of 90%
water and 10% neutral soap.
3. Wipe away any soap residu e with a clean damp cloth.
4. Wipe away residual water and allow leather to air dry in the shade.
■Floor Mats1Floor Mats
If you use any floor mats that were not originally
provided with your vehicle, make sure they are
designed for your specific ve hicle, fit correctly, and
are securely anchored by the floor anchors.
Position the rear seat floor mats properly. If they are
not properly positioned, the floor mats can interfere
with the front seat functions.
Lock
Unlock
■Maintaining Genuine Leather*1
Maintaining Genuine Leather*
It is important to clean or wipe away dirt or dust as
soon as possible. Spills can soak into leather resulting
in stains. Dirt or dust ca n cause abrasions in the
leather. In addition, pl ease note that some dark
colored clothing can rub onto the leather seats
resulting in discol oration or stains.
* Not available on all models
18 ACCORD HYBRID-31TWA6000.book 614 ページ ２０１８年１月３０日　火曜日　午後７時３８分

621
Handling the Unexpected
This chapter explains how to handle unexpected troubles.
ToolsTypes of Tools .................................. 622
If a Tire Goes Flat Temporarily Repairi ng a Flat Tire....... 623
Handling of the Jack ......................... 635
Power System Won’t Start Checking the Procedure ................... 636
If the Smart Entry Remote Battery is Weak .. 637
Emergency Power System Off........... 638
Jump Starting .................................... 639
Overheating How to Handle Overheating ............. 641 Indicator, Coming On/Blinking
If the Low Oil Pressure Symbol Appears ... 644If the 12-Volt Battery Charging System
Indicator Comes On ....................... 644
If the Malfunction Indicator Lamp Comes On or Blinks ................................... 645
If the Brake System Indicator (Red) Comes On or Blinks ................................... 646
If the Brake System Indicator (Red) Comes On or Blinks at the Same Time When the
Brake System Indicator (Amber) Comes
On ................................................. 647
If the Electric Power Steering (EPS) System
Indicator Comes On ....................... 648 If the Low Tire Pressure/TPMS Indicator
Comes On or Blinks ....................... 649
If the Transmission System Indicator Blinks
along with the Warning Message... 650
Fuses Fuse Locations ................................. 651
Inspecting and Changing Fuses ........ 654
Emergency Towing ........................... 655
When You Cannot Unlock the Fuel Fill
Door ................................................. 656
When You Cannot Open the Trunk.....657RefuelingRefueling From a Portable Fuel Container .... 658
18 ACCORD HYBRID-31TWA6000.book 621 ページ ２０１８年１月３０日　火曜日　午後７時３８分