Page 134 of 224

IN AN EMERGENCY
132
❒ insert the electrical connector
6 fig. 108 into the 12V socket on
the vehicle and start the engine;
❒ turn on the compressor by pressing
the ON-OFF button 5 fig. 107.
When the pressure shown in the
"Wheels" paragraph in the
“Technical data” chapter or on the
specific label appears on the
pressure gauge 7, stop the
compressor by pressing the
ON-OFF button 5 again;
107DVDF0S0232
❒ disconnect the cartridge 1 from the
compressor by pressing the
release button 8 and lifting the
cartridge 1 up fig. 109.
108DVDF0S0231
109DVDF0S0233
If the pressure gauge 7 fig. 107 shows
a pressure less than 1.8 bar / 26 psi
15 minutes after turning on the
compressor, switch off the
compressor, disconnect the sealant
hose 4 from the tyre valve and remove
the cartridge 1 from the compressor
fig. 105.
Move the vehicle about 10m to
distribute the sealant; stop the vehicle
safely, engage the handbrake and
restore the pressure using the black
inflation hose 9 fig. 110 until the
required pressure is reached. If also in
this case, the pressure is lower than
1.8 bar / 26 psi 15 minutes after
turning on, do not resume driving but
contact a Fiat Dealership.
110DVDF0S0235
Page 146 of 224

IN AN EMERGENCY
144
IF THE BATTERY IS
FLAT36)
IMPORTANT The battery recharging
procedure is provided for information
purposes only. You are advised to
contact a Fiat Dealership to have this
operation carried out.
IMPORTANT After turning the ignition
key to STOP and having closed the
driver’s side door, wait at least one
minute before disconnecting the battery
and then reconnecting the electrical
supply to the battery.
Charging should be slow at a low
ampere rating for approximately 24
hours. Charging for a longer time may
damage the battery.
Versions without Start&Stop
(for versions/markets, where provided)
To recharge, proceed as follows:
❒ disconnect the terminal from the
negative battery pole;
❒ connect the charger cables to the
battery terminals, making sure that
polarities are correct;
❒ turn on the charger;
❒ when you have finished, turn the
charger off before disconnecting the
battery;
❒ reconnect the terminal to the
negative battery pole.
Versions with Start&Stop
(for versions/markets, where provided)
To recharge, proceed as follows:
❒ disconnect the connector A fig. 132
(pressing the button B) from the
sensor C monitoring the battery
charge status, on the negative pole
D of the battery;
132DVDF0S0127c
❒ connect the positive cable of the
battery charger to the positive
battery pole E fig. 133 and the
negative cable to the terminal of
sensor D;
❒ turn on the charger. At the end of
the charging process, switch the
battery charger off;
❒ after having disconnected the
battery charger, reconnect
connector A to the sensor C as
shown in fig. 132.
133DVDF0S0128c
Page 161 of 224

159
Proceed as follows: detach the
connector A fig. 142 (by pressing
button B) from sensor C for monitoring
the status of the battery installed on
the negative battery pole D. This
sensor should never be disconnected
from the battery pole except if the
battery is replaced.
IMPORTANT After turning the ignition
key to STOP and having closed the
driver’s side door, wait at least one
minute before disconnecting the
battery and then reconnecting the
electrical supply to the battery.
142DVDF0S0157c
BATTERY
39) 24) 3)
The car is fitted with a
low-maintenance battery: no
electrolyte top-ups with distilled water
are needed in standard conditions
of use.
INSPECTING THE
CHARGE AND THE
ELECTROLYTE LEVEL
The operations must be carried out as
described in this Owner Handbook
only by specialised personnel.
Topping must be carried out by
specialised personnel at a Fiat
Dealership.
REPLACING THE
BATTERY
If required, replace the battery with a
genuine spare part with the same
specifications.
If a battery with different specifications
is fitted, the service intervals given in
the “Scheduled Servicing Plan” will no
longer be valid.
Follow the battery manufacturer’s
instructions for maintenance.
CAR INACTIVITY
(CARS EQUIPPED WITH
START&STOP SYSTEM)
In the event of vehicle inactivity
(or if the battery is replaced), special
attention must be paid to the
disconnection of the battery power
supply.
Page 193 of 224

191
21) VEHICLE REFUELLING
•Do not bring naked flames or lit cigarettes near to the fuel tank
opening: fire risk. Keep your face away from the fuel filler to
prevent breathing in harmful vapours.
•During normal service the catalyst reaches high temperatures;
therefore do not park the car over inflammable materials (grass,
dry leaves, pine needles, etc.): fire hazard.
•Do not use a mobile phone near the refuelling pump: risk of fire.
22) SEAT BELTS - PRETENSIONERS
•Do not press the seat belt release button while the vehicle is
moving.
•Remember that in the event of an accident, the rear seat
passengers not wearing seat belts are exposed to a very serious
risk and also represent a serious danger for the front seat
occupants.
•The pretensioner may be used only once. Contact a Fiat
Dealership to have it replaced after it has been deployed.
•For maximum safety, keep the backrest upright, lean back into
it and make sure the seat belt fits closely across your chest and
pelvis. Always fasten the seat belts on both the front and the rear
seats.
•Travelling without wearing seat belts will increase the risk of
serious injury and even death in the event of an accident.
•Removing or tampering with seat belt and pretensioner
components is strictly prohibited. Any intervention on these
components must be performed by qualified and authorised
technicians. Always go to a Fiat Dealership.
(CONTINUES)
PERSONAL SAFETY
(CONTINUED)
19) START&STOP SYSTEM
•When replacing the battery, always go to a Fiat Dealership.
Replace the battery with one of the same type (HEAVY DUTY)
and with the same specifications.
•Before opening the bonnet, make sure that the vehicle is
switched off and the key is in the STOP position.
Please follow the instructions on the decal near the front
crossmember. It is advisable to extract the key when there are
other people in the car.
The car should always be left after the key has been removed
or turned to the STOP position. When refuelling, make sure
that the car is switched off with the key in the STOP position.
•For cars with Dualogic gearbox, if the engine is
automatically stopped on a slope, the engine should be
restarted by moving the gear lever
to + or – without –releasing the brake pedal.
For vehicles with Dualogic transmission, where the Hill Holder
function is present, in case of stop downhill the motor does
not cut off automatically, so as to make the Hill Holder
function - which is active only when the engine is running -
available.
•If climate comfort is to be favoured, the Start&Stop system
can be disabled, for a continuous operation of the climate
control system.
20) ACCESSORIES PURCHASED BY THE OWNER
Take care when fitting additional spoilers, alloy wheels or non-
standard wheel hubs: they could reduce the ventilation of the
brakes and affect efficiency under sharp, repeated braking or
on long descents. Make sure that nothing obstructs the pedal
stroke (mats, etc.).