2018 DODGE DURANGO SRT tires

If your spare is the same size, load rating, and type of tire as your road
tires, it should be included in the tire rotation process. For vehicles with
a “full-size” spare, the following rotation patterns may be used:
NOTE:
•Never include a “temporary use” spare tire in the rotation.
•Tires with directional tread patterns must be rotated so the direction of
revolution does not change; this may require demounting/mounting
the tires.
•Special attention should be given if your vehicle is equipped with a
Tire Pressure Monitoring System (TPMS). Rotation of your tires may
affect the system; consult your vehicle owner ’s manual or a qualified
tire service professional.
•Some vehicles may have different size tires/wheels on front and rear
which would restrict rotation. Always check and follow the vehicle
manufacturer ’s rotation recommendation.
•To use a full-size spare in the rotation pattern on vehicles with dual
rear wheels, consult your vehicle owner ’s manual for the recom-
mended procedures or consult the vehicle manufacturer.
BRIDGESTONE® - FIRESTONE®
69

YOUR SPARE TIRE
Consult your vehicle owner ’s manual for proper application of your
spare tire. Your car may be equipped with a “temporary use” spare tire;
this spare may differ in size and construction from the other tires on your
vehicle.
WARNING!
Check inflation pressure before use. Failure to have proper inflation
pressure when using your spare tire can result in serious personal
injury or death. See Tire Inflation Pressure in this manual.
WARNING!
Mounting a “temporary use” tire on a wheel which is not
specifically designed for it, or placing another type tire on a wheel
designated for temporary use can be dangerous. Your vehicle’s
handling characteristics can be seriously affected. You could have an
accident resulting in serious personal injury or death. Consult your
vehicle owner ’s manual for proper application of your “temporary
use” spare tire.
The spare tire in your vehicle is intended to be used as a spare when
needed. The spare tire carrier is not intended to be used for long term
storage, except for “temporary use” tires. If your spare is the same size,
load rating, and type of tire as your road tires, it should be included in the
tire rotation process; see “Radial Tire Rotation” in this manual for more
information.
The spare should be included in regular tire inspections and inflation
pressure checks. In addition, it should be replaced 10 years after date of
manufacture, regardless of condition or tread depth. For more informa-
tion, see the “Tire Damage, Inspection and Service Life” in this manual.
TIRE STORAGE
Tires should be stored indoors in a cool, dry place where water cannot
collect inside them. Tires should be placed away from electric
generators/motors and sources of heat such as hot pipes. Storage
surfaces should be clean and free of grease, gasoline or other substances
which can deteriorate the rubber.
BRIDGESTONE® - FIRESTONE®
70

WARNING!
Improper storage can damage your tires in ways that may not be
visible and can lead to a failure resulting in serious personal injury
or death.
The spare tire in your vehicle is intended to be used as a spare when
needed. The spare tire carrier is not intended to be used for long term
storage, except for “temporary use” tires. For more information, see
“Your Spare Tire” and “Radial Tire Rotation” in this manual.
TIRE SERVICE CUSTOMER SATISFACTION
Normal tire maintenance and Limited Warranty services are available at
locations across the U.S.A. and Canada. For more information, visit us on
the internet at
www.bridgestonetire.com, or please call the Technical
Service Department:
U.S.A.: 800-356-4644 or Canada: 800-267-1318 .
Additional information on the care and service of automobile and light
truck tires is available from the following organizations:
Rubber Manufacturers Association 1400 K Street, N.W. Washington, DC
20005-2403
www.rma.org
Rubber Association of Canada 2000 Argentia Road, Plaza 4, Suite 250
Mississauga, Ontario L5N 1W1
www.rubberassociation.ca
TIRE REGISTRATION
Registration of your tires is an important safety precaution since it
enables the manufacturer to notify you in the event of a recall. When you
purchase replacement tires, the retailer will provide a registration card on
which the tire identification numbers have been recorded; fill in your
name and address on the card and mail it promptly. Some retailers may
submit the registration for you. You do not need to register tires which
come as original equipment on new vehicles—the vehicle and tire
manufacturers handle that for you.
BRIDGESTONE® - FIRESTONE®
71

RFT TIRES WITH RUN-FLAT TECHNOLOGY
If your vehicle is equipped with
Bridgestone or Firestone brand RFT
tires, this chapter presents specific
maintenance and safety issues asso-
ciated with these tires that are in addition to those covered elsewhere in
this manual.
What is RFT? Run-Flat Technology tires are extraordinary tires that
utilize specially designed components to temporarily support your
vehicle in the event of inflation pressure loss, such as from a puncture.
This gives you the ability to drive to a convenient and safe location to
change your tire (if equipped with a spare) or have it inspected for
possible repair or replacement.
Naturally, certain run-flat and low pressure operating limitations apply,
which varies according to the specific self-supporting tire design. Like all
tires, during normal operation, they must be properly inflated and
maintained. Regardless of the design or quality, no tire is indestructible.
RFT—How to Identify:Bridgestone and Firestone brand tires are
marked on the sidewalls, near the wheel, with the RFT logo (shown
above).
RFT INFLATION PRESSURE
Like other tires, RFT tires need proper inflation pressure maintenance for
safe operation and to achieve the maximum tire life and performance.
Check inflation pressures monthly and before long trips or carrying extra
weight. Use an accurate tire gauge and check pressures when the tires are
cold. Follow the vehicle manufacturer ’s recommendation for inflation
pressure settings as indicated on the vehicle tire information placard
and/or in the vehicle owner ’s manual. Do not forget the spare, if
applicable. See “Tire Inflation Pressure” in this manual.
TIRE PRESSURE MONITORING SYSTEM (TPMS)
A functioning tire pressure monitoring system (TPMS) must be used with
your RFT tires. Because these tires ride so well even without inflation
pressure, the TPMS may be necessary to alert you of an inflation pressure
loss condition. When alerted, follow the instructions in your vehicle
owner ’s manual and see “Run-Flat or Low Tire Pressure Operation,” the
following section in this manual.
BRIDGESTONE® - FIRESTONE®
72

•If an unusual vibration or vehicle handling difficulty arises, stop
driving as soon as safely and reasonably possible.The tire may be
about to suddenly fail. Release the accelerator and gradually reduce
speed. The tire will need to be replaced before proceeding.
•If towing a trailer, stop driving as soon as safely and reasonably
possible. In this condition, it is potentially dangerous to operate a
vehicle/trailer combination.If possible, disconnect the trailer and
proceed as noted above. Do not continue to tow any trailer until proper
tire service or replacement has been performed.
•Do not touch a tire recently run-low or run-flat (it may be very hot).
Allow the tire to cool before handling.
DISTANCE—HOW FAR YOU CAN DRIVE
Factors affecting run-flat or low tire pressure operating distance include
vehicle speed, load, and maneuvering; the amount of inflation pressure
loss; the extent of any tire damage; and ambient temperature.
The tire may be marked on the sidewall with run-flat or low tire pressure
operating speed and/or distance limitations, which vary by tire design
and vehicle application (consult your vehicle owner ’s manual). By
international standard, RFT tires have a baseline limitation in run-flat
mode of the following:
Maximum Speed: 50 mph (80 km/h)
Maximum Distance: 50 miles (80 km)
NOTE:
•Maximum distance values are determined under controlled condi-
tions, which may vary in actual use.
•Your mileage capability may be less, or more, depending on your
specific operating conditions.
•If in doubt, do not exceed the 50 mile (80 km) limitation.
•Seek tire service as soon as possible to minimize tire damage.
BRIDGESTONE® - FIRESTONE®
74

SPECIAL SERVICE AND REPAIR ISSUES
Run-Flat Certified Retailers
Because of the advanced technology and design of RFT tires and the
required tire pressure monitoring systems (TPMS), Bridgestone Firestone
Run-Flat Certified Retailers are specially trained to sell and service RFT
tires.
Run-Flat Certified Retailers have the necessary equipment and are
specially trained to properly mount and demount RFT tires and to handle
TPMS devices.Conventional mounting equipment may irreparably
damage RFT tires and an improper repair is unsafe and will void the
Limited Warranty.Accordingly, it is important to go to a Bridgestone
Firestone Run-Flat Certified Retailer for tire maintenance and replace-
ment.
Call toll-free 1-877-BFS-4RFT or, 877-237-4738 or visit
www.bridgestonetire.comto locate the nearest Bridgestone Firestone
Run-Flat Certified Retailer.
Inspection after Run-Flat or Low Pressure Operation
Following run-flat or low tire pressure operation, or in the event of any
other tire damage or unusual condition, it is very important to obtain a
proper and complete tire evaluation as soon as possible.
Rotation
Follow the vehicle manufacturer ’s recommendations, or rotate every
5,000 miles per the recommendations in this manual (see “Radial Tire
Rotation”). In some cases, TPMS devices require reprogramming with
each tire rotation.
RFT Tire Replacement
Do not replace or mix RFT tires with conventional tires, unless on an
emergency/temporary basis. Conventional tires do not have run-flat
capability and the handling characteristics of the vehicle with these tires
may be different. If a conventional tire is used on an emergency/
temporary basis, verify that its size, load capacity, inflation pressure, and
speed rating specifications meet the requirements of the vehicle. Replace
any conventional tire with the proper RFT tire as soon as possible.
BRIDGESTONE® - FIRESTONE®
75

RFT Tire Damage and Repair
No tire, regardless of its design or quality is indestructible. RFT tires can
be ultimately rendered unusable due to a puncture or other road hazard
as well as from improper run-flat or low tire pressure operation. Some
punctures may be repaired under certain restrictions and prescribed
procedures.
When driven flat or with low pressure, factors affecting reparability
include vehicle speed, load, and maneuvering; the amount of inflation
pressure loss; and ambient temperature. In any situation, the extent and
location of direct damage from a puncturing object or other road hazard
are also critical factors.
RFT tires are not repairable in any of the following situations:
•
If the tire was operated with inflation pressure less than 15 psi (100 kPa).
•Abrasion or other damage is present on the exterior tread, sidewall or
bead areas.
•Abrasion, wrinkling, or separation is present on the tire interior.
•Any condition or damage is present that disqualifies repair of a
conventional tire.
Run-Flat Certified Retailers will fully inspect your tire, inside and out, to
determine if the tire can be repaired. Tire damage is not always visible
from the outside and the tire must be removed from the wheel for a
complete inspection. For more information, see the section “Tire Repairs”
in this manual.
NOTE:Some vehicle manufacturers do not recommend using repaired
tires. Consult your vehicle owner ’s manual or contact the vehicle
manufacturer before operating a repaired tire on your vehicle.
REFERENCE INFORMATION
TIRE SIDEWALL LABELING
A lot can be learned by reading the tire’s sidewall. The following figures
show typical information on the sidewall of passenger (Figure 3) and
light truck tires (Figure 4):
BRIDGESTONE® - FIRESTONE®
76

DOT Symbol and Tire Identification Number:The “DOT” symbol
constitutes a certification that the tire conforms to applicable U.S.
Department of Transportation motor vehicle safety standards (for tires).
Following the “DOT” symbol is the tire identification number, also
known as the DOT serial number or code. For example:
(a) DOT Symbol (d) Tire Manufacturer ’s Code
(b) Manufacture Plant Code (e) Week of Production (01-52)
(c) Tire Size Code (f) Year of Production (last two digits
of year)
* For tires produced from 2000-on. In the example above, the tire was
produced in the 18th week of 2000. For tires produced prior to 2000, there
is one digit in group (f) which identifies the last digit of the year of
production, i.e. “329” would likely signify the 32nd week of 1999, but
could possibly signify the 32nd week of 1989. If in doubt, consult a
qualified tire service professional.
The DOT symbol and tire identification number can be found on at least
one sidewall near the wheel. The other sidewall may have a partial serial
code that excludes (e) and (f) above.
Maximum Load and Inflation:The maximum load and maximum
inflation pressure is marked on each sidewall in metric and English units.
For example:
MAX LOAD 685 kg (1,510 lbs) AT 240 kPa (35 psi) MAX PRESS
NOTE:The load and inflation values marked on the tire sidewall are
maximum permissible values for the tire only. Never assume that these
values are the actual maximum load capacity or recommended tire
pressure values for your vehicle. See “Tire Inflation Pressure,” “Tips for
Safe Tire Inflation,” and “Tips for Safe Loading” in this manual.
BRIDGESTONE® - FIRESTONE®
78