203
Rear lamps
Amber colour bulbs, such as the direction
indicators, must be replaced by bulbs with
identical colour and specifications.
Except for light guides, lamps located on
the tailgate are dummy units. They are
there for aesthetic purposes only.
Brake and reversing lamps and
direction indicators
These three bulbs are changed from outside
the boot:
F
O
pen the boot.
1. Brake lamps (P21/5W).
2. Sidelamps (LED).
3. Direction indicators (PY21W amber).
4. Reversing lamps (P21W).
5. Foglamps (P21W).
(
LEDs: light-emitting diodes). F
R
emove the access grille from the
corresponding side trim panel.
F
S
lacken the two nuts using a 10 mm socket
wrench then unscrew the nuts by hand.
F
U
nclip the lamp unit connector.
F
E
xtract the lamp unit carefully pulling it
straight towards the outside.
F
R
emove the foam seal. F
U
nclip the two small secondary connectors.
F
S
pread the two tabs and remove the bulb
h o l d e r.
F
T
urn the bulb a quarter of a turn and change
it.
To reassemble, proceed in reverse order.
Make sure to engage the lamp unit in its guides
while keeping it in line with the vehicle.
Tighten sufficiently to ensure sealing, but
without forcing, so as to avoid damaging the
lamp.
08
In the event of a breakdown
204
Light guides/sidelampsNumber plate lamps (W5W)F Insert a thin screwdriver into the cut-out outside the lens.
F
P
ush it outwards.
F
R
emove the lens.
F
R
eplace the faulty bulb.
To refit, press the lens to clip it in.
For the replacement of this type of LED lamp,
contact the dealer network or a qualified
workshop.
To facilitate removal, per form this procedure
with the tailgate half open. For the replacement of this type of light emitting
diode lamp, contact the dealer network or a
qualified workshop.
Third brake lamp (LED)
Foglamps
Take care not to touch the exhaust; there
is a risk of burns if changing a bulb within
a few minutes of switching off the ignition.
These bulbs are replaced from outside the rear
bumper:
F
p
ass your hand under the bumper,
F
t
urn the bulb holder a quarter turn and
remove it,
F
t
urn the bulb a quarter turn, pull it out and fit
a new bulb.
To reassemble, proceed in reverse order.
08
In the event of a breakdown
