2018 CITROEN DS3 engine oil

7
Limit the causes of excess
consumption
At the end of winter, remove snow tyres and
refit your summer tyres.
Observe the recommendations on
maintenance
Check the tyre pressures regularly, when cold,
referring to the label in the door aperture,
driver's side.
Carry out this check in particular:
-
b
efore a long journey,
-

a
t each change of season,
-

a
fter a long period out of use. Have your vehicle ser viced regularly (engine
oil, oil filter, air filter, cabin filter, etc.) and
obser ve the schedule of operations in the
manufacturer's service schedule.
With a
BlueHDi Diesel engine, if the SCR
system is faulty, your vehicle becomes
polluting. As soon as possible, visit a member
of the dealer network or a qualified workshop
to make your vehicle's level of nitrogen oxides
emissions compliant to the standard.
When filling the tank, do not continue after the
3
rd cut-off of the nozzle to avoid over flow.
At the wheel of your new vehicle, it is only
after the first 1,900
miles (3,000 kilometres)
that you will see the fuel consumption settle
down to a
consistent average.
Spread loads throughout the vehicle; place
the heaviest items in the bottom of the boot,
as close as possible to the rear seats.
Limit the loads carried in the vehicle and
reduce wind resistance (roof bars, roof rack,
bicycle carrier, trailer, etc.). Preferably, use a
roof box.
Remove roof bars and roof racks after use.
Do not forget the spare wheel and the tyres on
any trailer or caravan.
Eco-driving

10
A.Speed limiter
(mph or km/h) or
Cruise control.
B. Gear efficiency indicator.
C. Electronic or automatic gearbox
information.
D. Range
(miles or km) or
Trip distance recorder.
E. Service indicator
(miles or km) then,
Odometer.
These two functions are displayed
successively when switching on the
ignition.
F. Engine oil level indicator.
Appears a
few seconds after switching on
ignition, then disappears.
Display screen
01
Instruments

12
A.Speed limiter
(mph or km/h) or
Cruise control.
B. Range
(miles or km) or
Trip distance recorder.
C. Service indicator
(miles or km) then,
Odometer.
These two functions are displayed
successively when switching on the
ignition.
D. Engine oil level indicator.
Appears a
few seconds after switching on
ignition, then disappears.
Warning and indicator
lamps
Visual identifiers informing the driver that
a system is in operation, switched off (on/
off indicator lamps) or has developed a
fault
(warning lamp).
When the ignition is switched on
Certain warning lamps come on for a few
s econds when the ignition is switched on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before moving off refer to the
information on the warning lamp concerned.
The passenger airbag system operation
indicator lamp remains lit for one minute after
the ignition is on, even after the engine is
started.
Associated warnings
The lighting of certain indicator lamps may
be accompanied by an audible signal and
a
message on the multifunction screen. The warning lamp may come on
continuously (fixed) or flash.
Some warning lamps may have both types
of lighting. Only by relating the type of
illumination to the operating status of the
vehicle can it be ascertained whether the
situation is normal or whether a
fault has
occurred.
Warning lamps
When the engine is running or the vehicle is
being driven, illumination of one of the following
warning lamps indicates a
fault which requires
action on the part of the driver.
Any fault resulting in the illumination of
a


warning lamp must be investigated
further by reading the associated
message.
If you encounter any problems, contact the
dealer network or a
qualified workshop.
Display screen
01
Instruments

15
Engine oil
pressureFixed.
There is a fault with the engine oil
lubrication circuit. You must stop as soon as it is safe to do so.
Park, switch off the ignition and contact the dealer
network or a
qualified workshop.
Warning/indicator lamp
StateCause Action/Observations
Maximum
coolant
temperature Fixed.
The temperature of the cooling
system is too high. You must stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up the level, if necessary.
If the problem persists, contact the dealer network or
a


qualified workshop.
Battery charge Fixed. The battery charging circuit has
a
fault (dirty or loose terminals, slack
or cut alternator belt, etc.). The warning lamp should go off when the engine is
started.
If it does not go off, contact the dealer network or
a


qualified workshop.
Door(s) open
Fixed, if the speed is
below 6 mph (10 km/h).A door or the boot is still open. Close the door or boot.
Fixed and accompanied
by an audible signal
if the speed is above
6
mph (10 km/h).
Seat belt not
fastened/
unfastened Fixed, then flashing,
accompanied by an
increasing audible
signal. The driver or front passenger has
not fastened or has unfastened their
seat belt.
Pull the strap then insert the tongue into the buckle.
01
Instruments

16
Warning/indicator lampStateCause Action/Observations
Engine
diagnostic
system Flashing.
The engine management system has
a


fault.The catalytic converter may be destroyed.
Have it checked in the dealer network or by
a


qualified workshop.
Fixed. The emission control system has
a


fault.
The warning lamp should go off when the engine is started.
If it does not go off, contact the dealer network or a
qualified workshop without delay.
ServiceTemporarily on. A minor fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in
the screen, such as, for example:
-

e
ngine oil level,
-

s
creenwash fluid level,
-
r

emote control battery,
-

p
article filter saturation on Diesel vehicles.
For any other faults, contact the dealer network or
a


qualified workshop.
Fixed. A major fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in
the screen and then contact the dealer network or a
qualified workshop.
Anti-lock
Braking System
(ABS) Fixed.
The anti-lock braking system has
a


fault.The vehicle retains conventional braking.
Drive carefully at reduced speed and contact the
dealer network or a
qualified workshop without delay.
01
Instruments

27
Resetting the service indicator
After each service, the service indicator must
be reset to zero.
The procedure for resetting to zero is as
follows:
F
S
witch off the ignition.
F

P
ress and hold the trip distance recorder
reset button.
F

S
witch on the ignition; the distance recorder
display begins a


countdown.
F

W
hen the display indicates "=0", release the
button; the spanner disappears.
Following this step, if you wish to
disconnect the battery, lock the vehicle
and wait at least five minutes for the reset
to be taken into account.
Retrieving the service information
You can access the ser vice information at any
time.
F
P
ress the trip distance recorder reset
button. The ser vice information is displayed
for a
few seconds, then disappears.
Engine oil level indicator
Oil level correct
Low oil level
(Depending on version) The level read will only be correct if the
vehicle is on level ground and the engine
has been off for more than 30
minutes.
It is indicated by "OIL" flashing, accompanied
by the Ser vice warning lamp lighting up, an
audible signal and a

message.
If the low oil level is confirmed by a
check using
the dipstick, the level must be topped up to
avoid damage to the engine.
For more information on Checking levels ,
refer to the corresponding section.
On versions fitted with an electric oil level
indicator, the state of the engine oil level is
displayed in the instrument panel for a
few
seconds after switching the ignition on, after
the servicing information.
01
Instruments

28
AdBlue® range indicators
These range indicators are present only on
BlueHDi Diesel versions.
Once the AdBlue
® tank is on reser ve or after
detection of a

fault with the SCR emissions
control system, when the ignition is switched
on, an indicator displays an estimate of the
distance that can be covered, the range, before
engine starting is prevented.
In the event of the risk of non-
starting related to a lack of AdBlue®
The engine start prevention system
required by regulations is activated
automatically once the AdBlue
® tank is
e m pt y.
Range greater than 1,500

miles (2,400 km)
When switching on the ignition, there is no
automatic display of range in the instrument
panel.
Range between 1,500

miles and 370 miles
(2,400

and 600

km) Go to a
member of the dealer network or
a qualified workshop to have the AdBlue
®
topped up.
You can also top up the tank yourself.
Range below 370

miles (600

km)Oil level indicator fault
It is indicated by " OIL- -" flashing.
Contact the dealer network or a qualified
workshop.
In the event of a
fault with the electric indicator,
the oil level is no longer monitored.
If the system is faulty, you must check the
engine oil level using the manual dipstick
located under the bonnet.
For more information on Checking levels ,
refer to the corresponding section.
When driving, this message is displayed every
30
seconds until the AdBlue level has been
topped up.
Go to a
member of the dealer network or
a
qualified workshop to have the AdBlue
®
topped up.
You can also top up the tank yourself.
Other wise you will not be able to restart the
vehicle.
When switching on the ignition, this warning
lamp comes on, accompanied by an audible
signal and the display of a

message (e.g. "Top
up emissions additive: Starting prevented in
900


miles") indicating the remaining range
expressed in miles or kilometres.
When driving, the message is displayed every
185

miles (300

km) until the level is topped up. When switching on the ignition, this warning
lamp flashes and the Service warning lamp
comes on, accompanied by an audible signal
and the display of a

message (e.g. "Top up
emissions additive: Starting prevented in
350


miles") indicating the remaining range
expressed in miles or kilometres.
01
Instruments

150
Compatibility of fuels
Fuel used for petrol engines
The petrol engines are compatible with biofuels
that conform to current and future European
standards and which can be obtained from
filling stations:Petrol that meets standard EN228,
mixed with a
biofuel that meets
standard EN15376.
The only petrol additives authorised
for use are those that meet the
B715001


standard.
Fuel used for Diesel engines
The Diesel engines are compatible with
biofuels that conform to current and future
European standards and which can be
obtained from filling stations. Diesel fuel that meets standard
EN16734
mixed with a biofuel that
meets standard EN14214 (possibly
containing 0 to 10% Fatty Acid Methyl
Ester),
Paraffinic diesel fuel that meets
standard EN15940 mixed with a biofuel
that meets standard EN14214 (possibly
containing 0 to 7% Fatty Acid Methyl
Ester).
The use of B20 or B30 fuel that meets
standard EN16709 is possible in your
Diesel engine. However, this use, even
occasional, requires strict application of
the special servicing conditions referred
to as "Arduous conditions".
For more information, contact the dealer
network or a qualified workshop.
The use of any other type of (bio)fuel
(vegetable or animal oils, pure or diluted,
domestic fuel, etc.) is strictly prohibited
(risk of damage to the engine and fuel
syste m). The only diesel additives authorised
for use are those that meet the
B715000


standard.
Diesel at low temperature
At temperatures below 0°C (+32°F), the
formation of paraffins in summer-type Diesel
fuels could lead to abnormal operation of
the fuel supply circuit. To avoid this, we
recommend using winter-type Diesel fuel and
keeping the fuel tank more than 50% full.
If, despite this, at temperatures below -15°C
(+5°F) the engine has problems starting,
just leave the vehicle in a
garage or heated
workshop for a
little while.
Travelling abroad
Certain fuels could damage the engine of your
vehicle.
In certain countries, the use of a particular
fuel may be required (specific octane rating,
specific trade name, etc.) to ensure correct
operation of the engine.
For any additional information, contact a


dealer.
Diesel fuel that meets standard
EN590

mixed with a

biofuel that meets
standard EN14214


(possibly containing
0

to 7% Fatty Acid Methyl Ester),
07
Practical information