2018 CITROEN DS3 warning

17
Warning/indicator lampStateCause Action/Observations
Dynamic
stability control
(DSC/ASR) Flashing.
Regulation by the system is active. The system optimises traction and allows improved
directional stability of the vehicle.
Fixed, associated
with illumination of
the indicator lamp
in the deactivation
button, accompanied
by an audible signal
and a
message.The DSC/ASR or hill start assist
system has a
fault.Have it checked in the dealer network or by
a


qualified workshop.
Low fuel level Fixed. When it first comes on, around
5
litres of fuel remain in the tank.You must refuel as soon as possible to avoid running
out of fuel.
This warning lamp will come on every time the ignition
is switched on, until sufficient fuel is added.
Tank capacity: approximately 50


litres (petrol)
or 46
litres (Diesel); (depending on version:
approximately 30
litres (petrol or Diesel)).
Never drive until completely empty, this could damage
the emissions control and injection systems.
Airbags Temporarily on. This warning lamp comes on for
a
few seconds when you turn on the
ignition, then goes off.
This warning lamp should go off when the engine is started.
If it does not go off, contact the dealer network or a qualified
workshop.
Fixed. One of the airbag or seat belt
pyrotechnic pretensioner systems
has a


fault. Have it checked in the dealer network or by
a
qualified workshop.
01
Instruments

18
Warning/indicator lampStateCause Action/Observations
Power steering Fixed. The power steering has a
fault. Drive carefully at reduced speed.Have it checked in the dealer network or by
a


qualified workshop.
Under-inflation Fixed, accompanied
by an audible signal
and a
message.One or more wheels has insufficient
pressure.
Check the pressure of the tyres as soon as possible.
This check should preferably be carried out when the
tyres are cold.
You must reinitialise the system after adjusting one or
more tyre pressures and after changing one or more
wheels.
For more information on Tyre under-inflation
detection
, refer to the corresponding section.
+ Flashing then fixed,
accompanied by
the Ser vice warning
lamp.The system is faulty: tyre pressures
are no longer monitored.
As soon as possible, check the pressure of the tyres.
Have the system checked by a
dealer or by a qualified
workshop.
01
Instruments

19
Warning/indicator lampStateCause Action/Observations
AdBlue
®
(BlueHDi Diesel)Fixed, on switching
on the ignition,
accompanied by an
audible signal and
a
message indicating the
remaining driving range.The remaining driving range is
between 370 miles and 1,500 miles
(600
km and 2,400 km). Have the AdBlue® tank topped up as soon as
possible: go to a

member of the dealer network or
a

qualified workshop, or carry out this operation
yourself.
+
Flashing, associated with
the SERVICE warning
light, accompanied by
an audible signal and
a message indicating the
remaining driving range.The remaining driving range is
between 0 and 370 miles
(0
and 600 km). You must top up the AdBlue® tank to avoid
a
breakdown : go to a

member of the dealer network
or a

qualified workshop, or carry out this operation
yourself.
Flashing, associated with
the SERVICE warning
lamp, accompanied
by an audible signal
and a
message
indicating that starting is
prevented.The AdBlue® tank is empty: the
starting inhibition system required
by legislation prevents starting of the
engine. To be able to start the engine, you must top up the
AdBlue® tank: go to the dealer network or a qualified
w
orkshop, or carry out this operation yourself.
It is essential to add at least 4
litres of AdBlue
® to the
corresponding tank.
For topping up or for more information
on AdBlue
®, refer to the corresponding
section.
01
Instruments

20
Warning/indicator lampStateCause Action/Observations
+
+ SCR emissions
control system
(BlueHDi Diesel)
Fixed, on switching
on the ignition,
associated with the
SERVICE and engine
diagnostic warning
lamps, accompanied
by an audible signal
and a
message.A fault with the SCR emissions
control system has been detected.
This alert disappears once the exhaust emissions
return to normal levels.
Flashing, on switching
on the ignition,
associated with the
SERVICE and engine
diagnostic warning
lamps, accompanied by
an audible signal and
a


message indicating
the remaining driving
range.After confirmation of the fault with
the emissions control system,
you can continue driving for up to
685
miles (1,100 km) before the
engine start inhibition system is
triggered. To avoid a
breakdown, contact the dealer network
or a qualified workshop without delay.
Flashing, on switching
on the ignition,
associated with the
SERVICE and engine
diagnostic warning
lamps, accompanied
by an audible signal
and a

message. You have exceeded the authorised
driving limit following confirmation
of a
fault with the emissions control
system: the engine start inhibition
system prevents starting of the
engine. To be able to restart the engine, you must
call on the
dealer network or a
qualified workshop.
01
Instruments

21
Rear foglampsFixed. The rear foglamps are on. Turn the ring on the stalk rear ward to switch off the
rear foglamps.
Diesel engine
pre-heating Fixed.
The key is at position 2
(ignition on)
in the ignition switch. Wait until the warning lamp goes off before starting.
The period of illumination of the warning lamp is
determined by the climatic conditions (up to about
thirty seconds in extreme conditions).
If the engine does not start, switch the ignition off and
then on, wait until the warning lamp goes off again,
then start the engine.
Foot on brake Fixed. The brake pedal must be pressed. With an electronic gearbox, selector in position N ,
press the brake pedal to start the engine.
With an automatic gearbox, with the engine running,
press the brake pedal before releasing the parking
brake to unlock the lever and come out of position P .
If you wish to release the parking brake without
pressing the brake pedal, this warning lamp will
remain on.
Flashing. With an electronic gearbox, if you
hold the vehicle on an incline using
the accelerator for too long, the
clutch overheats. Use the brake pedal and/or the parking brake.
Warning/indicator lamp
StateCause Action/Observations
01
Instruments

22
Warning/indicator lampStateCause Action/Observations
Passenger's
airbag system Fixed.
The control switch, located in
the glove box, is set to the " OFF"
position.
The passenger's front airbag is
deactivated.
You can install a "rearward" facing
child seat, unless there is a
fault with
the airbags (airbag warning lamp on). To activate the passenger front airbag, turn the
control to the "
ON" position.
In this case, do not fit a
child seat in the "rear ward"
facing position.
Stop & Star t Fixed.
When the vehicle stops (red lights, traffic
jams, etc.) the Stop & Start system puts
the engine into STOP mode.The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want
to move off.
Flashes for a

few
seconds, then goes
of f. STOP mode is temporarily
unavailable.
or
START mode is triggered
automatically. For more information on Stop & Star t
, refer to the
corresponding section.
Left-hand
direction
indicator Flashing with audible
signal.
The lighting control stalk has been
moved down.
Right-hand
direction
indicator Flashing with audible
signal.
The lighting control stalk has been
moved up.
Automatic
wiping
Fixed.
The wiper control stalk has been
pushed down. Automatic front wiping is activated.
01
Instruments

23
Warning/indicator lampStateCause Action/Observations
Hazard warning
lamps Flashing with buzzer. The hazard warning lamps switch,
located on the dashboard, has been
operated. The left-hand and right-hand direction indicators and
their associated indicator lamps flash simultaneously.
Sidelamps Fixed. The lighting control stalk is in the
"Sidelamps" position.
Front foglamps Fixed. The front foglamps are switched on
using the ring on the lighting control
stalk. Turn the ring on the lighting control stalk rear ward
twice to switch off the front foglamps.
Dipped beam
headlamps Fixed.
The lighting control stalk is in the
"Dipped beam headlamps" position.
Main beam
headlamps Fixed.
The lighting control stalk has been
pulled towards you. Pull the lighting control stalk to return to dipped beam
headlamps.
01
Instruments

24
Indicators
Coolant temperature indicator
To top up the coolant:
F w ait for the engine to cool,
F

u
nscrew the cap by two turns to allow the
pressure to drop,
F

w
hen the pressure has dropped, remove the
cap,
F

t
op up the coolant to the "MA X" mark.
With the engine running, when the needle is:
-

i

n zone A , the temperature is correct,
-

i

n zone B , the temperature is too high; the
maximum temperature 1

and the central
STOP warning lamps light up in red,
accompanied by an audible signal and
a

message in the multifunction screen.
You must stop as soon as it is safe to do so.
Wait a

few minutes before switching off the
engine.
Contact the dealer network or a

qualified
workshop.
After driving for a

few minutes, the temperature
and pressure in the cooling system increase.
01
Instruments