2018 CHRYSLER 300 battery replacement

NOTE:
•The interior lights will turn off if you place the ignition
in the ACC or ON/RUN position while the Panic Alarm
is activated. However, the exterior lights and horn will
remain on.
• You may need to be less than 35 ft (11 m) from the
vehicle when using the key fob to turn off the Panic
Alarm due to the radio frequency noises emitted by the
system.
Key Fob Battery Replacement
The recommended replacement battery is one CR2032
battery.
NOTE:
• Perchlorate Material — special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate for fur-
ther information.
• Do not touch the battery terminals that are on the back
housing or the printed circuit board. 1. Remove the emergency key by sliding the mechanical
latch on the back of the key fob sideways with your
thumb and then pull the emergency key out with your
other hand.
Emergency Key Removal
1 — Emergency Key Release Button
2 — Emergency Key
3
GETTING TO KNOW YOUR VEHICLE 21

3. Remove the battery by turning the back cover over(battery facing downward) and tapping it lightly on a
solid surface such as a table or similar surface, and then
replace the battery. When replacing the battery, match
the + sign on the battery to the + sign on the inside of the
battery clip, located on the back cover. Avoid touching
the new battery with your fingers because skin oils may
cause battery deterioration. If you touch a battery, clean
it with rubbing alcohol.
4. To assemble the key fob case, snap the two halves together.
Programming Additional Key Fobs
Programming the key fob may be performed by an autho-
rized dealer.
Request For Additional Remote Controls
NOTE: Only key fobs that are programmed to the vehicle
electronics can be used to start and operate the vehicle.
Once a key fob is programmed to a vehicle, it cannot be
programmed to any other vehicle.
WARNING!
• Always remove the key fobs from the vehicle and
lock all doors when leaving the vehicle unattended.
• For vehicles equipped with Keyless Enter-N-Go —
Ignition, always remember to place the ignition in
the OFF mode.
Duplication of key fobs may be performed at an authorized
dealer. This procedure consists of programming a blank
key fob to the vehicle electronics. A blank key fob is one
that has never been programmed.
NOTE: When having the Sentry Key Immobilizer System
serviced, bring all vehicle keys with you to an authorized
dealer.Key Fob Battery Replacement
3
GETTING TO KNOW YOUR VEHICLE 23

Your vehicle has a simple ignition actuated test, which you
can use prior to going to the test station. To check if your
vehicle’s OBD II system is ready, you must do the follow-
ing:
1. Cycle the ignition switch to the ON position, but do notcrank or start the engine.
NOTE: If you crank or start the engine, you will have to
start this test over.
2. As soon as you cycle the ignition switch to the ON position, you will see the “Malfunction Indicator Light
(MIL)” symbol come on as part of a normal bulb check.
3. Approximately 15 seconds later, one of two things will happen:
• The MIL will flash for about ten seconds and then return
to being fully illuminated until you turn OFF the igni-
tion or start the engine. This means that your vehicle’s
OBD II system is not readyand you should notproceed
to the I/M station.
• The MIL will not flash at all and will remain fully
illuminated until you place the ignition in the off posi-
tion or start the engine. This means that your vehicle’s
OBD II system is readyand you can proceed to the I/M
station. If your OBD II system is
not ready,you should see an
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your vehicle
as you normally would in order for your OBD II system to
update. A recheck with the above test routine may then
indicate that the system is now ready.
Regardless of whether your vehicle’s OBD II system is
ready or not, if the MIL is illuminated during normal
vehicle operation you should have your vehicle serviced
before going to the I/M station. The I/M station can fail
your vehicle because the MIL is on with the engine
running.
138 GETTING TO KNOW YOUR INSTRUMENT PANEL

Apple CarPlay........................... .462
Arming System Security Alarm ...........................32
Assist, Hill Start .......................... .147
Audio Systems (Radio) ...................... .419
Auto Down Power Windows ...................84
Automatic Door Locks ........................39
Automatic Headlights ........................64
Automatic High Beams .......................63
Automatic Temperature Control (ATC) ............80
Automatic Transmission ..................... .226
Adding Fluid .....................370, 413, 415
Fluid And Filter Change ...................370
Fluid Change .......................... .370
Fluid Level Check ....................... .369
Fluid Type ...................... .369, 413, 415
Special Additives ........................ .369
Automatic Transmission Limp Home Mode .....39, 231
Autostick Operation ............................. .232
Auto Up Power Windows .....................84
AuxCord............................... .447AW D
Towing ............................... .337
Axle Fluid ........................... .413, 415
Axle Lubrication ....................... .413, 415
Back-Up ................................ .277
Battery .............................. .127, 349
Charging System Light ....................127
Keyless Key Fob Replacement ................21
Location .............................. .349
Belts, Seat ............................... .210
Beverage Holder Cooled (Cupholder) ............107
Beverage Holder Heated (Cupholder) ............107
Body Mechanism Lubrication ..................357
B-Pillar Location .......................... .377
Brake Assist System ........................ .141
Brake Control System ....................... .141
Brake Fluid ....................... .367, 413, 415
Brake

System ......................... .367, 403
Fluid Check ..................... .367, 413, 415
Master Cylinder ........................ .367
Parking .............................. .222
Warning Light ...................... .126, 403
Brake/Transmission Interlock ..................225
Break-In Recommendations, New Vehicle ..........221
12
INDEX 473

Key FobArm The System ..........................32
Panic Alarm .............................20
Programming Additional Key Fobs ..........23, 31
Unlatch The Trunk ........................20
Key Fob Battery Service (Remote Keyless Entry) .....21
Key Fob Programming (Remote Keyless Entry) ......23
Key-In Reminder ............................26
Keyless Enter-N-Go ..................... .35, 217
Enter The Trunk ..........................20
Passive Entry ............................35
Passive Entry Programming ..................35
Keys ....................................17
Replacement ......................... .23, 31
Key, Sentry (Immobilizer) ......................30
Lane Change And Turn Signals .................67
Lane Change Assist ..........................67
LaneSense ............................... .272
Lap/Shoulder Belts ........................ .169
Latches ................................. .212
Hood ..................................90
Lead Free Gasoline ........................ .405
Leaks, Fluid ............................. .212
Life Of Tires ............................. .385Light Bulbs
.......................... .212, 304
Lights .................................. .212
AirBag .........................125, 178, 210
Automatic Headlights ......................64
Brake Assist Warning ..................... .146
Brake Warning ...................... .126, 403
Bulb Replacement ....................... .304
Cruise ............................ .134, 135
Daytime Running .........................63
Dimmer Switch, Headlight ...................63
Engine Temperature Warning ................128
Exterior .............................. .212
Fog ...................................66
Hazard Warning Flasher ...................298
Headlights ....................... .62, 66, 306
Headlights On With Wipers ..................65
Headlight Switch .........................62
High Beam ..............................63
High Beam/Low Beam Select .................63
Instr

ument Cluster ........................62
Intensity Control ..........................70
Interior ................................67
License ............................... .309
Lights On Reminder .......................66
Malfunction Indicator (Check Engine) ..........129
12
INDEX 479