2017 YAMAHA YZF-R6 brake

Periodic maintenance an d a djustment
7-32
7
EAU44276
Checkin g an d lu bricatin g the
b rake an d shift pe dals
The operation of the brake and shift
pedals should be checked before each
ride, and the pedal pivots should be lu-
bricated if necessary.
Brake pe dal
Shift pe dal
EAU23144
Checkin g an d lu bricatin g the
b rake an d clutch levers
The operation of the brake and clutch
levers should be checked before each
ride, and the lever pivots should be lu-
bricated if necessary.
Brake lever
Clutch lever
Recommen ded lu bricant:
Lithium-soap-based greaseRecommen ded lu bricants:
Brake lever: Silicone grease
Clutch lever: Lithium-soap-based grease
UBN6E0E0.book Page 32 Wednesday, January 25, 2017 1:28 PM

Periodic maintenance an d a djustment
7-34
7
EAU23273
Checkin g the front fork
The condition and operation of the
front fork must be checked as follows
at the intervals specified in the periodic
maintenance and lubrication chart.
To check the con dition
Check the inner tubes for scratches,
damage and excessive oil leakage.
To check the operation 1. Place the vehicle on a level surfa- ce and hold it in an upright posi-
tion. WARNING! To avoi d injury,
securely support the vehicle so
there is no d anger of it fallin g
over.
[EWA10752]
2. While applying the front brake, push down hard on the handle-
bars several times to check if the
front fork compresses and re-
bounds smoothly.
NOTICE
ECA10591
If any damag e is foun d or the front
fork does not operate smoothly,
have a Yamaha dealer check or re-
pair it.
EAU23285
Checkin g the steerin g
Worn or loose steering bearings may
cause danger. Therefore, the operation
of the steering must be checked as fol-
lows at the intervals specified in the
periodic maintenance and lubrication
chart.
1. Raise the front wheel off the ground. (See page 7-39.)
WARNING! To avoid injury, se-
curely support the vehicle so
there is no d anger of it fallin g
over.
[EWA10752]
2. Hold the lower ends of the front fork legs and try to move them for-
ward and backward. If any free
play can be felt, have a Yamaha
dealer check or repair the steer-
ing.
UBN6E0E0.book Page 34 Wednesday, January 25, 2017 1:28 PM

Motorcycle care and stora ge
8-3
8 NOTICE:
Do not use warm wa-
ter since it increases the corro-
sive action of the salt.
[ECA10792]
2. After drying the motorcycle, apply a corrosion protection spray on all
metal, including chrome- and
nickel-plated, surfaces (except the
titanium muffler) to prevent corro-
sion.
Cleaning the windshield
Avoid using any alkaline or strong acid
cleaner, gasoline, brake fluid, or any
other solvent. Clean the windshield
with a cloth or sponge dampened with
a neutral detergent, and after cleaning,
thoroughly wash it off with water. For
additional cleaning, use Yamaha Wind-
shield Cleaner or other quality cleaner.
Some cleaning compounds for plastics
may leave scratches on surfaces of the
windshield. Before using them, make a
test by polishing an area which does
not affect your visibility.
Cleaning the titanium muffler
This model is equipped with a titanium
muffler, which requires the following
special care.  Use only a soft, clean cloth or
sponge with mild detergent and
water to clean the titanium muffler.
However, if the muffler cannot be
thoroughly cleaned with mild de-
tergent, alkaline products and a
soft brush may be used.
 Never use compounds or other
special treatments to clean the ti-
tanium muffler, as they will remove
the finish on the outer surface of
the muffler. 
Even the smallest amounts of oil,
such as from oily towels or finger-
prints, will leave stains on the tita-
nium muffler, which can be
removed with a mild detergent.
 Note that the thermally induced
discoloring of the portion of the
exhaust pipe leading into the tita-
nium muffler is normal and cannot
be removed.
After cleaning 1. Dry the motorcycle with a chamois or an absorbing cloth.
2. Immediately dry the drive chain and lubricate it to prevent it from
rusting.
3. Use a chrome polish to shine chrome, aluminum and stainless-
steel parts.
4. To prevent corrosion, it is recom- mended to apply a corrosion pro-
tection spray on all metal,
including chrome- and nickel-plat-
ed, surfaces.
5. Use spray oil as a universal clean- er to remove any remaining dirt.
6. Touch up minor paint damage caused by stones, etc.
7. Wax all painted surfaces.
8. Let the motorcycle dry completely before storing or covering it.
WARNING
EWA11132
Contaminants on the brakes or tires
can cause loss of control.  Make sure that there is no oil or
wax on the brakes or tires.
 If necessary, clean the b rake
d iscs an d b rake linin gs with a
re gular brake disc cleaner or
acetone, an d wash the tires with
UBN6E0E0.book Page 3 Wednesday, January 25, 2017 1:28 PM

Specifications
9-2
9
5th:1.286 (27/21)
6th: 1.150 (23/20)
Chassis:
Frame type:Diamond
Caster angle: 24.0 °
Trail:
97 mm (3.8 in)
Front tire:
Type:Tubeless
Size: 120/70ZR17M/C (58W)
Manufacturer/model:
DUNLOP/SPORTMAX D214F
Manufacturer/model: BRIDGESTONE/BATTLAX S21F
Rear tire:
Type:
Tubeless
Size: 180/55ZR17M/C (73W)
Manufacturer/model: DUNLOP/SPORTMAX D214
Manufacturer/model:
BRIDGESTONE/BATTLAX S21R
Loa din g:
Maximum load:
185 kg (408 lb)
(Total weight of rider, passenger, cargo
and accessories)
Tire air pressure (measure d on col d
tires):
Front:
250 kPa (2.50 kgf/cm², 36 psi)
Rear: 290 kPa (2.90 kgf/cm², 42 psi)
Front wheel:
Wheel type:
Cast wheel
Rim size: 17M/C x MT3.50
Rear wheel:
Wheel type:
Cast wheel
Rim size: 17M/C x MT5.50
Front brake:
Type:
Hydraulic dual disc brake
Specified brake fluid:
DOT 4
Rear brake:
Type:
Hydraulic single disc brake
Specified brake fluid:
DOT 4
Front suspension:
Type:Telescopic fork
Spring:
Coil spring
Shock absorber:
Hydraulic damper
Wheel travel: 120 mm (4.7 in)
Rear suspension:
Type:
Swingarm (link suspension)
Spring: Coil spring
Shock absorber: Gas-hydraulic damper
Wheel travel:
120 mm (4.7 in)
Electrical system:
System voltage:12 V
Ignition system:
TCI
Charging system: AC magneto
Battery:
Model:
YTZ7S
Voltage, capacity: 12 V, 6.0 Ah (10 HR)
Bul b watta ge:
Headlight:
LED
Brake/tail light: LED
Front turn signal light: LED
Rear turn signal light:
LED
UBN6E0E0.book Page 2 Wednesday, January 25, 2017 1:28 PM

11-1
11
Index
A
ABS ...................................................... 4-19
ABS warning light ................................... 4-7
Air filter element ................................... 7-19
Auxiliary DC connector ........................ 4-30
B
Battery .................................................. 7-35
Brake and clutch levers, checking and
lubricating .......................................... 7-32
Brake and shift pedals, checking and lubricating .......................................... 7-32
Brake fluid, changing ........................... 7-28
Brake fluid level, checking ................... 7-27
Brake lever ........................................... 4-18
Brake lever free play, checking ............ 7-25
Brake light switches ............................. 7-26
Brake pedal .......................................... 4-18
C
Cables, checking and lubricating ......... 7-31
Canister ................................................ 7-12
Care ........................................................ 8-1
Catalytic converters ............................. 4-22
Clutch lever .......................................... 4-17
Clutch lever free play, adjusting ........... 7-24
Coolant ................................................. 7-17
Coolant temperature warning light ......... 4-6
Cowlings and panels, removing and installing ............................................... 7-7
D
Data recording, vehicle ........................ 10-3
Diagnostic connector ........................... 10-2
Dimmer switch ....................................... 4-4
D-mode (drive mode) ............................. 3-1
Drive chain, cleaning and lubricating ... 7-30
Drive chain slack .................................. 7-29
Drive mode switch.................................. 4-5
E
Engine break-in ...................................... 6-4
Engine idling speed, checking ............. 7-20
Engine oil and oil filter cartridge ........... 7-13
Engine serial number............................ 10-1
Engine trouble warning light................... 4-6
EXUP system........................................ 4-29
F
Front and rear brake pads, checking ... 7-26
Front fork, adjusting ............................. 4-25
Front fork, checking ............................. 7-34
Fuel....................................................... 4-20
Fuel consumption, tips for reducing ...... 6-4
Fuel level warning light ........................... 4-6 Fuel tank cap ........................................ 4-20
Fuel tank overflow hose ........................ 4-22
Fuses, replacing.................................... 7-37
H
Handlebar switches ................................ 4-4
Hazard switch ......................................... 4-5
High beam indicator light........................ 4-5
Horn switch............................................. 4-4
I
Identification numbers .......................... 10-1
Ignition circuit cut-off system ............... 4-31
Immobilizer system ................................. 4-1
Immobilizer system indicator light .......... 4-7
Indicator lights and warning lights .......... 4-5
L
License plate light bulb, replacing ........ 7-39
M
Main switch/steering lock ....................... 4-2
Maintenance and lubrication, periodic ... 7-4
Maintenance, emission control
system .................................................. 7-3
Matte color, caution ................................ 8-1
Model label ........................................... 10-1
Multi-function meter unit ........................ 4-8
N
Neutral indicator light.............................. 4-5
O
Oil level warning light .............................. 4-5
P
Parking .................................................... 6-5
Part locations .......................................... 2-1
Pass switch............................................. 4-4
Q
Quick shift system .................................. 3-4
R
Rear view mirrors .................................. 4-24
S
Safety information................................... 1-1
Seats ..................................................... 4-23
Shifting .................................................... 6-3
Shift light ................................................. 4-7
Shift pedal............................................. 4-17
Shock absorber assembly, adjusting ... 4-27
Sidestand .............................................. 4-30
Sidestand, checking and lubricating .... 7-33
Spark plugs, checking .......................... 7-11
Special features ...................................... 3-1
Specifications ......................................... 9-1
Starting the engine.................................. 6-2
Steering, checking ................................ 7-34
UBN6E0E0.book Page 1 Wednesday, January 25, 2017 1:28 PM