For your safety – pre-operation checks
5-2
5
Drive chain• Check chain slack.
• Adjust if necessary.
• Check chain condition.
• Lubricate if necessary. 7-21,
7-23
Wheels an d tires •Check for damage.
• Check tire condition and tread depth.
• Check air pressure.
• Correct if necessary.
• Check for loose spokes and tighten if necessary. 7-14,
7-16
Shift pe dal • Make sure that operation is smooth.
• Correct if necessary.
7-18
Brake ped al • Make sure that operation is smooth.
• Lubricate pedal pivoting point if necessary. 7-25
Brake an d clutch le-
vers • Make sure that operation is smooth.
• Lubricate lever pivoting points if necessary.
7-24
Steerin g • Check that the handlebar can be turned smoothly and
has no excessive play. 7-27
Front fork an d rear
shock ab sorber as-
sem bly • Check that they operate smoothly and there is no oil
leakage. 4-8,
4-10,
4-10, 7-26
Chassis fasteners • Make sure that all nuts, bolts and screws are properly
tightened.
• Tighten if necessary. —
Movin g parts an d ca-
b les • Check that the control cables move smoothly.
• Check that the control cables are not caught when the
handlebars are turned or when the front forks travel up
and down.
• Lubricate moving parts and cables if necessary. 7-23,
7-24,
7-26, 7-25
Exhaust system • Check that the exhaust pipe is tightly mounted and has
no cracks.
• Check for leakage. —
En gine stop switch • Check operation. 4-1
I g nition system • Check that all leads and cables are properly connected. 7-6
ITEM CHECKS PAGE
U1SN85E0.book Page 2 Friday, June 10, 2016 1:20 PM
Periodic maintenance an d a djustment
7-5
7
EAU42012
TIP
Hydraulic brake service
• Regularly check and, if necessary, correct the brake fluid levels.
• Every two years replace the internal components of the brake master cyl- inders and calipers, and change the brake fluid.
• Replace the brake hoses every four years and if cracked or damaged.
NO. ITEM ROUTINEAfter
break-in
Everyrace
Every
third race
Every
fifth race
As
required
23 *Shock absorber
assembly Check operation and adjust.√√ Tighten if necessary.
Lubricate with lithium-soap-based
grease.
√√ ∗
24 *Drive chain roller
and support guide Check for wear or damage.√ Replace if necessary.
25
*Rear suspension Check operation and tighten if
necessary.√√
Lubricate with lithium-soap-based grease.√√
Check operation, free play, and tighten if necessary.√√
26 *
Steering head Clean and lubricate with
lithium-soap-based grease.√
Replace bearings.√ Check tire air pressure, wheel runout, spokes for looseness, and tires for
wear.
√√
Tighten sprocket bolts if necessary.√√
27 *Tires and wheels
Check wheel bearings for looseness.√ Lubricate wheel bearings with
lithium-soap-based grease.√
Replace wheel bearings.√
28 *Moving parts and ca-
bles Lubricate.√√
29 *
Throttle grip Check operation.√√ Check throttle grip free play, and
adjust if necessary.
Lubricate cable and grip housing.
After washing the motorcycle or riding in the rain.∗
U1SN85E0.book Page 5 Friday, June 10, 2016 1:20 PM
