2017 VOLVO XC90 T8 coolant

MAINTENANCE AND SERVICING
* Option/accessory.519
Function A
– –
Tailgate window wiper 15
Fuel pump control module 15
Relay windings for engine compart- ment electrical module; Relay wind-ing for transmission oil pump 5
– –
Driver side front seat heating
*15
Passenger side front seat heating
*15
Coolant pump 10
– –
Front driver-side front door module 20
Active chassis control module
*20
– –
Sensus control module 10
– –
– –
Function
A
Front passenger-side front door module20
Display for rear seat convenience functions; On-board diagnostics (OBDII)
C
; Extra movement sensor
(certain markets only) C5
C
– –
Circuit breaker for fuses 53 and 58 15
A
Certain markets only.
B Not Excellence
C Excellence only
Related information
• Fuses (p. 509)
• Replacing fuses (p. 510)
• Fuses in the engine compartment (p. 511)
• Fuses in the cargo compartment (p. 520)

MAINTENANCE AND SERVICING
}}
535
any components in the engine compart- ment.
• The distributor ignition system operatesat very high voltages. Special safety pre-cautions must be followed to prevent injury. Always turn the ignition
off when
replacing distributor ignition components e.g. plugs, coil, etc.
• Do not touch any part of the distributorignition system while the engine is run-ning. This may result in unintended move-ments and body injury.
The layout of the engine compartment may differ slightly from model to model
Coolant expansion tank
Brake fluid reservoir
Washer fluid reservoir
Relay/fuse box
Air cleaner
Engine oil filler cap
Related information
•Ignition modes (p. 389)
• Opening and closing the hood (p. 533)
• Refilling the windshield washer fluid reservoir (p. 541)
Engine oil
The correct oil must be used for the stated oil change (service) intervals for the warranty toapply.
Volvo recommends:

MAINTENANCE AND SERVICING
540
Refilling coolantCoolant helps keep the gasoline engine at the proper operating temperature. The heat transfer-red from the engine to the coolant can be usedto warm the passenger compartment.
When refilling coolant, follow the instructions on the package and use the recommended amountof coolant. Never fill the cooling system withwater only; this could lead to freezing, corrosionand engine damage.
WARNING
If the engine has been running, the coolant will be very hot. Allow the engine to coolbefore opening the coolant expansion tank. Ifthis is not possible, open the cap very slowlyto allow pressure to dissipate.
Coolant expansion tank
Lift the rubber strip by pressing it inward in the engine compartment.
Remove the plastic cover by folding out the catch and lifting the cover upward.
Unscrew the expansion tank cap and add coolant. The level should be between the MIN and MAX marks on the tank.
Put the other components back in place in the reverse order.
CAUTION
• High levels of chlorine, chlorides and other salts may cause corrosion in thecooling system.
• Only use coolants with corrosion protec-tion recommended by Volvo.
• The ratio of coolant to water is 50/50.
• Mix the coolant with tap water of drinka-ble quality.
• If maintenance is performed on the cool-ing system or if the coolant is replaced,flush the cooling system with clean waterbefore adding new a new coolant/watermixture.
• The engine may only be operated with aproperly filled cooling system. Otherwise,high temperatures and cracks in the cyl-inders may occur.
Related information
•Coolant specifications (p. 560)

SPECIFICATIONS
560
Brake fluid specification and volume
Brake fluid transfers braking force when the brake pedal is depressed to the master cylinderand to the slave cylinders on each wheel. Topping up or replacing brake fluid should only be done by a trained and qualified Volvo servicetechnician.
Specification: Volvo Original Dot 4 class 6 or
equivalent
Related information
• Engine compartment overview (p. 534)
Coolant specifications
Coolant specifications.
Specification: Coolant with corrosion inhibitor mixed with water (50/50 mix), see packaging. Consult a Volvo retailer if you are uncertain.Different types of coolant should not be mixed to help avoid health risks.

SPECIFICATIONS
561
Engine specificationsThe following table provides technical data for the respective engines. Engine specifications forSpecial Edition vehicles may vary. Not all engines listed here are available in allmarkets.
Specification
T8
Engine designation B4204T28
Output (kW/rps) 233/100
Output (hp/rpm) 313/6000
Torque (Nm/rps) 400/37–90
Torque (ft. lbs./rpm) 295/2200–5400
No. of cylinders 4
Electric motorMax. power:87/7000 (65 kW/117).
Torque: 240 Nm/0-50 rpm.
Related information
•Engine oil specifications and volume (p. 562)
• Coolant specifications (p. 560)

INDEX
567
Clean Zone Interior Package 195
Climate system 197
air distribution 210, 211, 213
air filter 196
air vents 211
auto mode 196
blower 199
center display controls 197
Electronic Climate Control 197
introduction 186, 197
passenger compartment filter 195
preconditioning 187, 189
rear controls 197, 199
recirculation 203
refrigerant 559
service 505
setting the temperature 201
voice commands 126
Clock 119
Cold weather driving 376
Collision warning system 313
Compass in rearview mirror 141 calibrate 142
Connected service booking 502
Convertible seats 85
Coolant 560 refilling 540
Corrosion protection 547
Courtesy lighting 151
Crash event data 31
Crash mode 78
Cross Traffic Alert 327, 328, 329, 331
Cruise control 270, 271, 272, 273, 274 adaptive 274, 277, 280, 281, 283, 284 , 285 , 287 , 288 , 289 , 296
Curb weight 478, 557 Curtain sun 113
D
Daytime running lights 143, 145 Defrosterrear window and mirrors 204
Detachable key blade 239, 251
Digital owner's manual 55, 56
Dimensions 555
Disconnecting the front passenger