Page 550 of 594

||
MAINTENANCE AND SERVICE
* Option/accessory.
548
Positions
• Fuses 13-17 and 21-36 are of the "Micro" type.
• Fuses 1-12, 18-20 and 37 are of the"MCase" type and should be replaced by a workshop 19
.
Function AA
Rear window defroster 30
- -
Compressor for air suspension
*40
Lock motor for backrest on rear right-hand side 15
- -
Lock motor for backrest on rear left-hand side15
- -
- -
Power operated tailgate
*25
Electrically operated front passen- ger seat
* 20
Towbar control module
*40
Function
AA
Seatbelt pretensioner module, right-hand side 40
Internal relay coils 5
- -
Module for detecting foot move- ment
* (for opening the power oper-
ated tailgate) 5
- -
- -
Towbar control module
*25
Power driver seat
* 20
Seatbelt pretensioner module, left- hand side 40
Parking camera
* 5
- -
- -
- -
- -
Function
AA
Control module for airbags and seatbelt tensioners 5
- -
Seat heating left-hand side rear
*15
- -
Blind Spot Information (BLIS)
*5
- -
Seatbelt pretensioner modules 5
Actuator for exhaust gases (petrol, certain engine variants) 5
- -
AWD control module
*15
Seat heating right-hand side rear
*15
- -
A
Ampere
Related information
• Replacing a fuse (p. 536)
• Fuses under glovebox (p. 542)
• Fuses in engine compartment (p. 537)
19
An authorised Volvo workshop is recommended.
Page 551 of 594

MAINTENANCE AND SERVICE
}}
549
Cleaning the exterior
The car should be washed as soon as it becomes dirty. This means that the car is easierto clean since the dirt does not attach as firmly.It also reduces the risk of scratches and keepsthe car fresh. Wash the car in a car wash with oilseparator. Use car shampoo.
Handwashing
• Remove bird droppings from the paintwork as soon as possible. Bird droppings containchemicals that affect and discolour paintworkvery quickly. For example, use soft paper orsponge soaked in plenty of water. An author-ised Volvo workshop is recommended for theremoval of any discoloration.
• Hose down the underbody.
• Rinse the entire car until the dissolved dirthas been removed so as to reduce the risk ofscratches from washing. Do not spray directlyonto the locks.
• If necessary, use cold degreasing agent onvery dirty surfaces. Note that in this case, thesurfaces must not be hot from the sun.
• Wash using a sponge, car shampoo andplenty of lukewarm water.
• Clean the wiper blades with a lukewarm soapsolution or car shampoo.
• Dry the car using a clean, soft chamois or awater scraper. If you avoid allowing drops ofwater to dry in strong sunlight, you reduce the risk of water drying stains which mayneed to be polished out.
WARNING
Always have the engine cleaned by a work- shop. There is a risk of fire if the engine is hot.
IMPORTANT
Dirty headlamps have impaired functionality. Clean them regularly, e.g. when refuelling. Do not use any corrosive cleaning agents but use water and a non-scratching spongeinstead.
NOTE
Outside lighting such as headlamps and rear lamps may temporarily have condensation onthe inside of the lens. This is normal, all exte-rior lighting is designed to withstand this.Condensation is normally vented out of thelamp housing when the lamp has beenswitched on for a time.
Automatic car washAn automatic car wash is a simple and quick way of washing the car, but it cannot reach every-where. Washing the car by hand is recommendedto achieve a good result, or to supplement auto-matic car washes with washing by hand.
NOTE
The car must only be washed by hand over the first few months. This is because the paintis more delicate when it is new.
IMPORTANT
Before driving the car into an automatic car wash, deactivate the functions for Automaticbraking when stationary (Auto Hold) andAutomatic application of parking brake. Ifthese functions are not deactivated, the brakesystem will jam when the car is stationary andthe car will not be able to move.
In car washes where the car is towed through with rolling wheels, the following applies:
1. Drive into the automatic car wash.
2. Deactivate the function for automatic braking
when stationary (Auto Hold) using the switch in the tunnel console.
3. Deactivate the function for automatic appli- cation of parking brake via the centre display.
4. Move the gear lever to position N.
Page 561 of 594
SPECIFICATIONS
}}
559
Decal for type designation, vehicle identifica-
tion number, permissible maximum weights and code designation for exterior colour and date ofmanufacture. The decal is positioned on the doorpillar, and will be visible when the right-hand reardoor is opened.
Decal A/C system for cars with refrigerant
R1234yf.
Decal A/C system for cars with refrigerant
R134a.
Label for parking heater.
Decal for engine code and the engine's serial
number.
Label for engine oil.
Page 568 of 594
SPECIFICATIONS
566
Engine specificationsEngine specifications (output etc.) for each respective engine alternative can be read in thetable.NOTE
Not all engines are available in all markets.
Engine Engine codeA
Output
(kW/rpm) Output
(hp/rpm) Torque
(Nm/rpm) No. of cylinders
T5/Bi-Fuel B4204T23 187/5500 254/5500 350/1500–4800 4
T6 AWD B4204T27 235/5700 320/5700 400/2200-5400 4
D3 D4204T9 110/3750 150/3750 320/1750-3000 4
D3 AWD D4204T4 110/4250 150/4250 350/1500-2500 4
D4 / D4 AWD D4204T14 140/4250 190/4250 400/1750-2500 4
D5 AWD D4204T23 173/4000 235/4000 480/1750-2250 4
A The engine code, component number and serial number can be found on the engine.
Related information
• Type designations (p. 558)
• Engine oil — specifications (p. 567)
• Coolant — specifications (p. 570)
Page 569 of 594
SPECIFICATIONS
}}
567
Engine oil — specifications Engine oil grade and volume for each respective engine alternative can be read in the table.
Volvo recommends:
EngineEngine codeA
Oil grade Volume, incl. oil filter
(litres)
T5/Bi-Fuel B4204T23 Castrol Edge Professional V 0W-20 or VCC RBS0-2AE 0W-20 approx. 5.9 T6 AWD B4204T27 approx. 5.9
D3 D4204T9 Castrol Edge Professional V 0W-20 or VCC RBS0-2AE 0W-20 approx. 5.2
D3 AWD D4204T4 approx. 5.2
D4 / D4 AWD D4204T14 approx. 5.2
D5 AWD D4204T23 approx. 5.2
A
The engine code, component number and serial number can be found on the engine.
Page 570 of 594
||
SPECIFICATIONS
568
Related information
•Type designations (p. 558)
• Adverse driving conditions for engine oil (p. 569)
• Checking and filling with engine oil (p. 517)
• Engine oil (p. 516)
Page 571 of 594

SPECIFICATIONS
569
Adverse driving conditions for engine oil Adverse driving conditions can lead to abnor- mally high oil temperature or oil consumption.Below are some examples of adverse drivingconditions.
Check the oil level more frequently for long jour- neys:• towing a caravan or trailer
• in mountainous regions
• at high speeds
• in temperatures colder than -30 °C or hotterthan +40 °C.
The above also apply to shorter driving distancesat low temperatures. Choose a fully synthetic engine oil for adverse driving conditions. It provides extra protection forthe engine.
Volvo recommends:
IMPORTANT
In order to fulfil the requirements for the engine's service intervals all engines are filledwith a specially adapted synthetic engine oilat the factory. The choice of oil has beenmade very carefully with regard to service life,starting characteristics, fuel consumption andenvironmental impact. An approved engine oil must be used in order that the recommended service intervals canbe applied. Only use a prescribed grade of oilfor both filling and oil change, otherwise thereis a risk of the service life, starting characte-ristics, fuel consumption and environmentalimpact of the car being affected. If engine oil of the prescribed grade and vis- cosity is not used, engine related componentsmay become damaged. Volvo Car Corporationdisclaims any liability for any such damage. Volvo recommends that oil changes are car- ried out at an authorised Volvo workshop.
Related information
• Engine oil — specifications (p. 567)
• Engine oil (p. 516)
Page 581 of 594

ALPHABETICAL INDEX
579
Centre display
change settings 45
cleaning 553
climate control 187
messages 106
operation 36, 40
overview 33
symbols in status bar 45
Checking the engine oil level 517
Child safety 71
Child safety locks 261
Child seat 71 integrated booster cushion 82
i-Size/ISOFIX mounting points 77
lower mounting points 74
positioning/fitting 71
table for location 75
table of i-Size 81
table of ISOFIX 78
Upper mounting points 73
Cigarette lighter 224 City Safety ™330, 332, 333, 335, 336,
337, 339
Cleaning automatic car wash 549
car washing 549
centre display 553
Fabric upholstery 552
rims 551
seatbelts 553
upholstery 552
Clean Zone Interior Package 185
Climate control 182, 186 auto-regulation 189
centre display 187
experienced temperature 183
fan control 193
Parking 206
rear seat 188
sensors 183
temperature control 190
voice control 119
zones 182
Clock, adjustment 99 CO 2 emissions 572
Collision 56, 59, 63, 69
Collision warning 330Collision warning system Pedestrian detection 333
Radar sensor 318
Colour code, paint 554
Combined instrument panel 90 settings 94
Compass 156 calibration 157
Condensation in headlamps 549Controls lighting 135
Coolant 570
Coolant, filling 518Cooling system overheating 414
Cornering lights 142
Corner Traction Control 273Cover cargo area 230
Crash, see Collision 56
Cruise control 284 deactivate 287
managing speed 284, 285
temporary deactivation 286
CTA 343, 344, 345
Cyclist detection 333
CZIP (Clean Zone Interior Package) 185
D
DAB Radio 440 Data recording 22
transfer between car and workshop 511
Data link connector 23
Daytime running lights 137