2017 TOYOTA PRIUS PLUG-IN HYBRID repair

1802-2. Charging
PRIUS PHV_OM_OM47A89E_(EE)
The error warning indicator on the CCID (Charging Circuit Interrupting
Device) flashes.
Electrical leakage detection function
or self- diagnostic function operates
and power is cut off
When the voltage is insufficient, the
error warning indicator may flash
when there is noise interference.
Perform a reset and connect to a
proper power source. (P. 121)
If charging does not start, immedi-
ately stop charging and contact any
authorized Toyota dealer or repairer,
or another duly qualified and
equipped professional.
Charging indicator does not illuminate, even though charging connector
is connected.
The plug is not properly connected
to the socketCheck whether the plug is properly
connected to the socket.
Charging connector is not securely
connected to charging inlet
Check the connection status of the
charging connector.
If the charging indicator does not
illuminate, even though the charging
connector is securely connected,
there may be a malfunction in the
system. Immediately stop charging
and contact any authorized Toyota
dealer or repairer, or another duly
qualified and equipped professional.
Hybrid battery (traction battery) is
already fully chargedWhen the hybrid battery (traction
battery) is fully charged, charging is
not performed.
The charging equipment does not
operatePlease contact the facility manager
when there is a problem with
charging equipment.
Likely causeCorrection procedure

1842-2. Charging
PRIUS PHV_OM_OM47A89E_(EE)
When the hybrid system is started
after charging, a message is dis-
played in the multi-information dis-
play.
When this occurs, follow the
instructions displayed on the
screen.
When charging-related message is displayed
Likely causeCorrection procedure
If “Charging Stopped Connect Plug to Charge” is shown
Charging connector is not securely
connected
Check the connection status of the
charging connector.
If charging cannot be carried out,
even though the proper procedures
were followed, have the vehicle
inspected by any authorized Toyota
dealer or repairer, or another duly
qualified and equipped professional.
Charging connector was unlocked
while charging
When the charging connector is
unlocked while charging, charging
stops. To continue charging, recon-
nect the charging connector.
If “Charging Complete Limited Due to Battery Temp” is shown
Charging was stopped to protect the
hybrid battery (traction battery) as it
continued to remain hot for a certain
period of time.Allow the hybrid battery (traction
battery) to cool down and perform
charging again if the charging
amount has not reached the desired
amount.

1852-2. Charging
2
Plug-in hybrid system
PRIUS PHV_OM_OM47A89E_(EE)
If “Charging Stopped Check Charging Source” is shown (1)
Problem in power supply from exter-
nal power source
Check the following items.
• Plug is not disconnected
• Remote switch is not off
• Power source indicator on the
CCID (Charging Circuit Interrupt-
ing Device) is illuminated
• The circuit breaker has tripped or
not
If there is no problem with any of the
above items, there may be a prob-
lem with the socket. Contact an
electrician and request an inspec-
tion.
Furthermore, if the error warning
indicator on the CCID (Charging Cir-
cuit Interrupting Device) is flashing,
there may be an electrical leakage.
Consult any authorized Toyota
dealer or repairer, or another duly
qualified and equipped professional.
Charging equipment has stopped
charging
• Charging may be canceled by an
interruption of power supply
depending on specifications of a
charging equipment. Refer to the
instructions provided with the
charging equipment.
• When charging is stopped using
the charging equipment
• Equipment with timer charging
function
• Equipment that is not compati-
ble with the timer charging func-
tion of the vehicle
• Check if it is possible to charge
with the charging cable equipped
to the vehicle.
If charging cannot be carried out,
even when using the genuine
charging cable, consult any autho-
rized Toyota dealer or repairer, or
another duly qualified and
equipped professional.
Likely causeCorrection procedure

1862-2. Charging
PRIUS PHV_OM_OM47A89E_(EE)
If “Charging Stopped Check Charging Source” is shown (2)
Charging equipment is not compati-
ble with vehicle
Check if it is possible to charge with
the charging cable equipped to the
vehicle.
If charging cannot be carried out,
even when using the genuine
charging cable, consult any autho-
rized Toyota dealer or repairer, or
another duly qualified and equipped
professional.
Charging equipment has stopped
charging
If “Charging Stopped Check Charging Source” is shown (3)
Problem in power supply from exter-
nal power source
Check the following items.
• Plug is securely inserted
• Extension cord is not used and
socket is not overloaded
• Connected to a dedicated power
line
• Electrical leakage has occurred or
not
There may be a problem with the
socket of the building. Contact an
electrician to request an inspection.
If charging cannot be carried out,
even though there is no problem
with the power source path, there
may be a malfunction in the system.
Have the vehicle inspected by any
authorized Toyota dealer or repairer,
or another duly qualified and
equipped professional.
Charging equipment has stopped
charging
Check if it is possible to charge with
the charging cable equipped to the
vehicle.
If charging cannot be carried out,
even when using the genuine
charging cable, consult any autho-
rized Toyota dealer or repairer, or
another duly qualified and equipped
professional.
Likely causeCorrection procedure

1872-2. Charging
2
Plug-in hybrid system
PRIUS PHV_OM_OM47A89E_(EE)
If “Charging Stopped High Energy Use See Owner’s Manual” is shown
Power is being consumed by electri-
cal components of vehicle
Check the following items, and then
carry out charging again.
• If the headlights and audio are
turned on, turn them off.
• Turn the power switch off.
If charging cannot be carried out,
even after performing the above, the
auxiliary battery may not be suffi-
ciently charged. Operate the hybrid
system for approximately 15 min-
utes or more to charge the auxiliary
battery.
If “Charging System Malfunction See Owner’s Manual” is shown
Malfunction occurred in charging
system
Have the vehicle inspected by any
authorized Toyota dealer or repairer,
or another duly qualified and
equipped professional.
Likely causeCorrection procedure

2013. Instrument cluster
3
Instrument cluster
PRIUS PHV_OM_OM47A89E_(EE)
*1: These lights turn on when the power switch is turned to ON mode to indi-
cate that a system check is being performed. They will turn off after the
hybrid system is on, or after a few seconds. There may be a malfunction in
a system if a light does not come on, or if the lights do not turn off. Have
the vehicle inspected by any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
*2: The light flashes to indicate a malfunction.
The indicators inform the driver of the operating state of the vehicle’s
various systems.
Driver’s and front passenger’s seat belt
reminder lightP. 645
Rear passengers’ seat belt reminder light P. 645
*1Master warning light P. 645
*1Tire pressure warning light P. 645
Indicators
Warning lightsPages
IndicatorsPages
Turn signal indicator P. 339
Tail light indicator P. 341
Parking brake indicator P. 340
Headlight high beam indicator P. 341
Front fog light indicator P. 351
Rear fog light indicator P. 351

2033. Instrument cluster
3
Instrument cluster
PRIUS PHV_OM_OM47A89E_(EE)
*1: These lights turn on when the power switch is turned to ON mode to indi-
cate that a system check is being performed. They will turn off after the
hybrid system is on, or after a few seconds. There may be a malfunction in
a system if a light does not come on, or if the lights do not turn off. Have
the vehicle inspected by any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
*2: The light flashes to indicate that the system is operating.
*3: The light comes on when the system is turned off.
*1S-IPA indicator (if equipped) P. 460
*1“PASSENGER AIR BAG” indicator P. 51
IndicatorsPages

2053. Instrument cluster
3
Instrument cluster
PRIUS PHV_OM_OM47A89E_(EE)■
Multi-information display (symbol display*)
*: These symbols are displayed along with a message. Also, the symbol dis-
plays listed here are only an example, and different symbols may be dis-
played according to the contents of the multi-information display.
■BSM (Blind Spot Monitor) outside rear view mirror indicators
(if equipped) (P. 417)
• When the BSM function is enabled on the screen of the multi-infor-
mation display, the power switch is turned to ON mode.
If the system is functioning correctly, the BSM outside rear view mirror indi-
cators will turn off after a few seconds.
If the BSM outside rear view mirror indicators do not illuminate or do not
turn off, there may be a malfunction in the system.
If this occurs, have the vehicle inspected by any authorized Toyota dealer
or repairer, or another duly qualified and equipped professional.
Symbol displayPages
Smart entry & start system P. 327
Brake Override System/Drive-Start Control/
Intelligent Clearance Sonar (if equipped)P. 646
LDA (Lane Departure Alert with steering con-
trol) systemP. 646
P. 646
●Indicators are also displayed on the out-
side rear view mirrors.
●In order to confirm operation, the BSM
outside rear view mirror indicators illumi-
nate in the following situations:
• When the power switch is in ON
mode, the BSM function is enabled
on the screen of the multi-infor-
mation display.