2017 TOYOTA AVALON HYBRID door lock

3536-3. Do-it-yourself maintenance
6
Maintenance and care
■Before recharging
When recharging, the 12-volt battery produces hydrogen gas which is flam-
mable and explosive. Therefore, observe the following precautions before
recharging:
●If recharging with the 12-volt battery installed on the vehicle, be sure to dis-
connect the ground cable.
● Make sure the power switch on the charger is off when connecting and dis-
connecting the charger cables to the 12-volt battery.
■ After recharging/reconnect ing the 12-volt battery
● The hybrid system may not start. Follow the procedure below to initialize the
system.
Shift the shift lever to P.
Open and close any of the doors.
Restart the hybrid system.
● Unlocking the doors using the smart key system may not be possible imme-
diately after reconnecting the 12-volt battery. If this happens, use the wire-
less remote control or the mechanical key to lock/unlock the doors.
● Start the hybrid system with the power switch in ACCESSORY mode. The
hybrid system may not start when the power switch turned from off. How-
ever, the hybrid system will operat e normally from the second attempt.
● The power switch mode is recorded by the vehicle. If the 12-volt battery is
reconnected, the vehicle will return the power switch mode to the status it
was in before the 12-volt battery was disconnected. Make sure to turn off
the power switch before disconnect the 12-volt battery. Take extra care
when connecting the 12-volt battery if the power switch mode prior to dis-
charge is unknown.
If the system will not start even after multiple attempts at all methods above,
contact your Toyota dealer.
1
2
3

4227-2. Steps to take in an emergency
■Doors
Use the mechanical key (→P.
106) in order to perform the fol-
lowing operations:
Locks all the doors
Unlocks the door
Turning the key rearward
unlocks the driver’s door. Turn-
ing the key once again within 5
seconds unlocks the other
doors.
■
Tr u n k
→ P. 1 1 9
If the electronic key does not operate
properly
If communication between the electronic key and vehicle is
interrupted ( →P. 126) or the electronic key cannot be used
because the battery is depleted, the smart key system and wire-
less remote control cannot be used. In such cases, the doors
and trunk can be opened and the hybrid system can be started
by following the procedure below.
Locking and unlocking the doors and unlocking the trunk
1
2

4247-2. Steps to take in an emergency
If you have a set of jumper (or booster) cables and a second vehicle
with a 12-volt battery, you can jump start your vehicle by following the
steps below.
Confirm that the electronic key
is being carried.
When connecting the jumper (or
booster) cables, depending on the
situation, the alarm may activate
and doors locked. ( →P. 82)
Open the trunk lid and remove
the 12-volt battery cover.
In the event that the trunk opener
cannot be used, use the loop of
wire to unlock the trunk. ( →P. 119)
If the 12-volt battery is discharged
The following procedures may be used to start the hybrid sys-
tem if the 12-volt battery is discharged.
You can also call your Toyota de aler or a qualified repair shop.
1
2

4277-2. Steps to take in an emergency
7
When trouble arises
■When recharging or repl acing the 12-volt battery
● In some cases, it may not be possible to unlock the doors using the smart
key system when the 12-volt battery is discharged. Use the wireless remote
control or the mechanical key to lock or unlock the doors.
● The hybrid system may not start on the first attempt after the 12-volt battery
has recharged but will start normally after the second attempt. This is not a
malfunction.
● The power switch mode is memorized by the vehicle. When the 12-volt bat-
tery is reconnected, the system will return to the mode it was in before the
12-volt battery was discharged. Before disconnecting the 12-volt battery,
turn the power switch off.
If you are unsure what mode the power switch was in before the 12-volt bat-
tery discharged, be especially careful when reconnecting the 12-volt battery.
WARNING
■Avoiding 12-volt battery fires or explosions
Observe the following precautions to prevent accidentally igniting the flam-
mable gas that may be emitted from the 12-volt battery:
● Make sure each jumper cable is connected to the correct terminal and that
it is not unintentionally in contact with any other than the intended terminal.
● Do not allow the other end of the jumper cable connected to the “+” termi-
nal to come into contact with any other parts or metal surfaces in the area,
such as brackets or unpainted metal.
● Do not allow the + and - clamps of the jumper cables to come into contact
with each other.
● Do not smoke, use matches, cigarette lighters or allow open flame near
the 12-volt battery.

4628-2. Customization
■Smart key system and wireless remote control (→P. 110, 121)
■Smart key system (→P. 121)
FunctionDefault settingCustomized
setting
Operation signal
(Emergency flashers) On Off O O
Operation signal
(Buzzer) On Off — O
Operation buzzer volume Level 5 Off to level 7 O O
Time elapsed before auto-
matic door lock function is acti-
vated if door is not opened
after being unlocked 60 secondsOff
OO
30 seconds
120 seconds
Open door warning buzzerOnOff —O
12
FunctionDefault settingCustomizedsetting
Smart key system OnOff — O
Number of permissible times
of continuous smart lock Twice Unlimited — O
12

4638-2. Customization
8
Vehicle specifications
■Wireless remote control (→P. 106, 110, 116)
■Door lock ( →P. 1 1 0 )
FunctionDefault settingCustomized
setting
Wireless remote control OnOff — O
Unlocking operation Driver's door
unlocked in one step, all doors
unlocked in two
steps All doors
unlocked in one step. OO
Panic function OnOff — O
Trunk unlocking operationPress and hold
(short)
Off
—O
Press twice
One short press
Press and hold (long)
12
FunctionDefault settingCustomizedsetting
Unlocking using a key Driver's door
unlocked in one step, all doors
unlocked in two
steps All doors
unlocked in one step. —O
Speed-detecting automatic
door lock function Off On O O
Opening driver's door unlocks
all doors Off On O O
Shifting gears to P unlocks all
doors. On Off O O
Shifting gears to position other
than P locks all doors. On Off O O
Locking/unlocking of the trunk
when all doors are locked/
unlocked
OnOff—O
12

4658-2. Customization
8
Vehicle specifications
■Automatic light control system (→P. 186)
■Lights (→ P. 186, 189)
*: If equipped
■
Illumination ( →P. 286)
FunctionDefault settingCustomized
setting
Light sensor sensitivity Level 3 Level 1 to 5 O O
Time elapsed before head-
lights automatically turn off
after doors are closed 30 seconds0 seconds
OO
60 seconds
90 seconds
12
FunctionDefault settingCustomized
setting
Daytime running light system On Off O O
Automatic high beam
*On Off—O
12
FunctionDefault settingCustomized
setting
Interior lights illumination con-
trol On Off—O
Time elapsed before interior
lights turn off15 seconds
Off
OO7.5 seconds
30 seconds
Center console spot lightOnOff—O
Operation when the doors are
unlockedOnOff—O
Operation after the power
switch turned offOnOff—O
Operation when you approach
the vehicle with the electronic
key on your person
OnOff—O
Ambient lights*OnOff—O
Outer foot lights*OnOff—O
12

4668-2. Customization
*: If equipped
■
Instrument panel ( →P. 9 2 )
■Automatic air condi tioning system (→P. 274)
■Touch switch (on the audio panel) ( →P. 100)
■Touch switch (on the air conditioning panel) ( →P. 274)
Time elapsed before the outer
foot lights turn off
*
15
seconds
Off
OO
7.5
seconds
30
seconds
Enable/disable operation of
the outer foot lights when you
approach the vehicle with the
electronic key on your person
*
OnOff—O
Enable/disable operation of
the outer foot lights when the
doors are unlocked with the
power door lock switch
*
OnOff—O
FunctionDefault settingCustomized setting12
FunctionDefault settingCustomized
setting
Instrument panel light auto
dimmer control Level 3 Level 1 to 5—O
12
FunctionDefault settingCustomized
setting
A/C auto switch operationAutoManualOO
12
FunctionDefault settingCustomizedsetting
Touch switch sensitivityLevel 3Level 1 to 3O—
12
FunctionDefault settingCustomizedsetting
Touch switch sensitivityLevel 1Level 1 to 3—O
12