2017 TESLA MODEL S ECU

About the Security System
If Model S does not detect a key nearby and a
locked door or trunk is opened, an alarm sounds and headlights and turn signals
flash.To deactivate the alarm, press any button on the key.
To manually enable or disable the alarm
system, touch Controls > Settings > Safety &
Security > Alarm . When set to on, Model S
activates its alarm one minute after the doors
lock and a recognized key is no longer
detected nearby.
If Model S is equipped with the optional
security package, it includes a battery-backed
siren that sounds instead of the horn in situations where a locked door or trunk isopened and Model S does not detect a key
nearby. If the Tilt/Intrusion setting is on, the siren also sounds if Model S detects motioninside the cabin, a window is broken, or if it is
moved or tilted (for example, with a tow truck
or jack). To turn the tilt/ intrusion detection systems on or
off, touch Controls > Settings
> Safety & Security > Tilt/Intrusion .
Note: If you plan to leave something that
moves, such as a dog, inside your locked
Model S, remember to turn
off the tilt/
intrusion system. Any type of motion detected
inside Model S activates the siren.
Note: To turn on Tilt/Intrusion, the Alarm must
be ON.
Security Settings
Using the Touchscreen125

Inflating with Air Only
If you have a Tesla tire repair kit, follow these
steps to
inflate a tire with air:
1. Detach the power supply connector from the rear of the compressor and plug it into
the 12V power socket located in Model S
on the front of center console.
2. Release the black air hose from the compressor.
3. Attach the air hose to the valve and press the lever down to secure it in place.
4. Ensure the compressor is lying on a level
surface with the pressure gauge facing tothe side where you can read it.
5. To add air, turn on the compressor and
inflate until the desired pressure is
reached.
6. To release air, turn
off the compressor,
then press and hold the red button until
the desired pressure is reached.
Note: For your convenience, the tire repair kit
includes a selection of adapters that allow you to
inflate other items. These adapters are
located in a compartment on the back of the
compressor.
Caution: To avoid overheating, do not use
the compressor continuously for more
than eight minutes. Allow the compressor
to cool for 15 minutes between uses.Caution: The compressor runs slowly
when overheated from excessive use. Turn
it
off and allow it to cool.Temporary Tire Repair
Maintenance147

Connect the Towing Eye1. Locate the towing eye in the front trunk.
2. Remove the tow hook cover by inserting a small
flat screwdriver into the slot located
along the top of the cover, then prying
gently to release the cover from the top
snap.
3. Insert the towing eye.
Fully insert the towing eye into the
opening on the right side, then turn it
counter-clockwise until securely fastened.
4. Attach the winch cable to the towing eye.
Caution: Before pulling, make sure the
towing eye is securely tightened.Pull Onto the Trailer and Secure the
Wheels
Secure wheels using the eight-point tie-downmethod with basket straps or tie-down straps:

Article XIV: The use of low-power radio-
frequency devices shall not influence aircraft
security and interfere with legal
communications; interference phenomenon discovered over time, should be immediately
suspended, and improved to no interference before use can continue. Legal
communications, referring to the provisions of
the Telecommunications Act of radio
communications operations. Low-power radio
communications shall tolerate radio wave
interference from radiated devices, legal or
industrial,
scientific and medical.
Tire Pressure Monitoring System FCC IDs: TZSTPMS201, Z9F-201FS43X
IC ID: 11852A-201FS4X
The tire pressure monitoring system (TPMS)
complies with Part 15 of the FCC rules and
RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
Changes or
modifications not expressly
approved by Tesla could void the user

NCC certifications 179
Neutral gear 44
night mode 101
O odometer 64
offset from speed limit 91
overhang dimensions 162
overtake acceleration 70
Owner Information, about 175, 176
P Park Assist 60
Park gear 44
parking brake 58
parking, automatic 81
parts replacement 158
personal data, erasing 104
phonesteering wheel buttons 40
using 117
PIN 37
power management 65
power socket 115
power windows 9
powering on and
off 43
Preconditioning 101
preferences, setting 101
public charging stations 132
R
radar 68
radio 112
Radio Frequency information 179
rain sensor 56
rangedisplayed on instrument panel 45
driving tips to maximize 65
regenerative braking 58
range assurance 65
Range mode 65
Range Mode 98
Rated range 101
re-routing 120
rear seats, folding and raising 18
rear view camera 67
rear window switches, disabling 9
Recent (Media Player) 114
Recents 119
regenerative braking 58
region format 101
relative speed limit 91
release notes 129
restarting the touchscreen
43
Reverse gear 44
RFID transponders 158
roadside assistance 170
roof racks 161
rotating tires 140
route overview 120
Ssafety informationairbags 36
child seats 27
rear facing child seats 32
seat belts 20seat beltscleaning 150
in a collision 20
overview of 19
pre-tensioners 20
wearing when pregnant 19
seat covers
18
seat heaters 105
seating capacity 160
seatsadjusting 17
heaters 105
Tesla built-in rear facing 29
security settings 125
sensors 68
service data recording 177
service intervals 138
Settings 101
Settings, erasing 104
shifting gears 44
Show Commute Advice 120
side collision avoidance 86
side collision warning 86
slip start 59
Smart Preconditioning 101
software reset 104
software updates 129
specificationscargo volume 163
dimensions 162
exterior 162
interior 162
motor 164
subsystems 164
tires 167
weights 163
wheels 167
speed assist 91
speed limit warning 91
stability control 59
starting 43
Statutory Plate 160
steering
specifications 164
Index
184Model S Owner