2017 SUBARU BRZ hood release

11
Headlight switch
Turn signal lever
Fog light switch

P. 228
P. 191
P. 233
Gauges and meters
Multi-information display P. 194
P. 205, 213
Clock P. 305
Windshield wiper and washer switch P. 234
Hazard warning
flasher switch
P. 392
Tilt and telescopic steering
lock release lever
P. 67
Floor mat
P. 310
Engine hood lock release lever P. 334
Fuel filler lid opener P. 76
Push-button ignition switch (vehicles with a keyless
access with push button start system)
P. 169
AUX port
USB port P. 294
P. 294
Pictorial indexInstrument panel

: If equipped

334
4-3. Do-it-yourself maintenance
Engine hood
Release the lock from the inside of the vehicle to open the engine
hood.
Pull the engine hood release
lever.
The engine hood will pop up
slightly.
Push the auxiliary catch lever
to the left and lift the engine
hood.
Hold the engine hood open by
inserting the supporting rod
into the slot.
STEP 1
STEP 2
STEP 3

460 5-2. Steps to take in an emergency
WARNING
■To prevent an accident or injury when inspecting under the hood of
your vehicle
●If steam is seen coming from under the hood, do not open the hood until
the steam has subsided. The engine compartment may be very hot, caus-
ing serious injuries such as burns.
●Keep hands and clothing (especially a tie, a scarf or a muffler) away from
the fans and belts. Failure to do so may cause the hands or clothing to be
caught, resulting in serious injury.
●Do not loosen the radiator cap and the coolant reservoir cap while the
engine and radiator are hot.
Serious injury, such as burns, may result from hot coolant and steam
released under pressure.
CAUTION
■When adding engine coolant
Wait until the engine has cooled down before adding engine coolant.
When adding coolant, do so slowly. Adding cool coolant to a hot engine too
quickly can cause damage to the engine.
■To prevent damage to the cooling system
Observe the following precautions:
●Avoid contaminating the coolant with foreign matter (such as sand or dust
etc.).
●Do not use any coolant additives.

536
GAS STATION INFORMATION
Auxiliary catch lever
P. 334Trunk lid opener
P. 4 6
Engine hood lock release lever
P. 334
Fuel filler lid
P. 7 6
Tire inflation pressure
P. 474Fuel filler lid opener
P. 7 6
Fuel tank capacity
(Reference)13.2 gal. (50 L, 11.0 Imp. gal.)
Fuel type Unleaded gasoline only P. 77, 467
Cold tire inflation
pressureFront:
35 psi (240 kPa, 2.4 kgf/cm
2 or bar)
Rear:
35 psi (240 kPa, 2.4 kgf/cm
2 or bar)
Compact spare:
60 psi (420 kPa, 4.2 kgf/cm
2 or bar)P. 4 7 4
Engine oil capacity
(Drain and refill 
reference)• Without filter
• With filterqt. (L, Imp. qt.)
5.5 (5.2, 4.6)5.7 (5.4, 4.8)P. 468
Engine oil typeSUBARU approved engine oil
Oil grade:
ILSAC multigrade engine oil
API classification SN with the words
“RESOURCE CONSERVING”
Recommended oil viscosity:
SAE 0W-20P. 4 6 8