2017 RENAULT ALASKAN bonnet

Replacing
Replace the wiper blades if they are worn.
1. Pull the wiper arm.
2. Push and hold the release tab j
A, and then move
the wiper blade down ➀the wiper arm to re-
move.
3. Remove the wiper blade.
4. Insert the new wiper blade onto the wiper arm until it clicks into place.
CAUTION
• After wiper blade replacement, return the
wiper arm to its original position. Otherwise
the wiper arm or the engine bonnet may be
scratched and may cause damage.
• Worn windscreen wiper blades can damage
the windscreen and impair driver vision. The variable voltage control system measures the
amount of electrical discharge from the battery and
controls voltage generated by the alternator.
CAUTION
• Do not ground accessories directly to the bat-
tery terminal. Doing so will bypass the vari-
able voltage control system and the vehicle
battery may not charge completely.
• Use electrical accessories with the engine
running to avoid discharging the vehicle bat-
tery. SDI2048Z
VARIABLE VOLTAGE CONTROL
SYSTEM (where fitted)
Maintenance and do-it-yourself 8-17

ENGINE COMPARTMENT
CAUTION
Never use afuse of ahigher or lower amperage
rating than that specified on the fuse box cover.
This could damage the electrical system or cause
af ire.
Never attempt to use other material (wire, alu-
minium foil. etc.) in place of afuse. This could
damage the electrical system or cause afire. The location and the amperage rating of fuses are
shown on the underside of the fuse box lid.
The number of fuses may vary depending on the
features equipped to the vehicle.
If any electrical equipment does not operate, check
for an open fuse.
1. Be sure the ignition switch is in the OFF or LOCK
position.
2. Be sure the headlight switch is in the OFF posi- tion.
3. Open the engine bonnet.
4. Remove the fuse/fusible link cover by pushing the tab.
5. Locate the fuse which needs to be replaced.
6. Remove the fuse using the fuse puller located in the passenger compartment fuse box.
7. If the fuse is open j
A, replace it with anew fuse
j B. If the new fuse also opens, after installing, have
the electrical system checked, and if necessary
repaired, by an approved dealer or qualified
workshop.
Fusible links
If any electrical equipment does not operate and the
fuses are in good condition, check the fusible links.
If any of these fusible links are melted, replace only
with genuine replacement parts. NDI1692
NDI1694
SDI1753Z NDI1693
FUSES
8-18
Maintenance and do-it-yourself

TYRE PLACARD
The cold tyre pressures are shown on the tyre plac-
ard affixed to the driver’s side rear access door
(King Cab model).
AIR CONDITIONER SPECIFICATION
LABEL
The air conditioner specification labels are attached
to the underside of the bonnet as shown. The text on the larger label states “[Contains fluori-
nated greenhouse gases]”.For countries conforming to UN regulation No.10
or equivalent:
The installation of an RF transmitter in your vehicle
could affect electric equipment systems. Be sure to
check with your approved dealer or qualified work-
shop for precautionary measures or special instruc-
tions regarding installation. Upon request, your ap-
proved dealer or qualified workshop will provide the
detailed information (frequency band, power, an-
tenna position, installation guide, etc.) regarding in-
stallation.NTI406
NTI403 NTI404
NTI405INSTALLATION OF AN RF
TRANSMITTER
9-8 Technical information