Page 225 of 228

Keyless Enter-N-Go........................ .122
Maintenance Procedures ..................... .176
Maintenance Schedule ...................... .210
Manual Transmission ....................... .150
Fluid Level Check ....................... .197
Shift Speeds ........................... .151
New Vehicle Break-In Period ...................94
Noise Control Maintenance ........................... .200
Tampering Prohibited .....................200
Noise Emission Warranty .....................200
Oil Change Indicator ....................... .210
Oil, Engine .............................. .176
Capacity .............................. .204
Change Interval ........................ .177
Dipstick .............................. .176
Disposal .............................. .179
Filter ............................ .179 , 205
Filter Disposal .......................... .179
Identification Logo ...................... .178
Materials Added To ...................... .179
Recommendation ........................ .177Synthetic
............................. .179
Viscosity .............................. .178
Overdrive ............................... .148
Overdrive OFF Switch ...................... .148
Perform Service Indicator, Reset ................211
Power Take-Off Adapter ........................ .154
Take-Off Operation ...................... .154
PTO (Power Take-Off) ...................... .154
Radiator Cap (Coolant Pressure Cap) .............191
Remote Starting System .......................92
Resetting Perform Service Indicator ..............211
Selection Of Coolant (Antifreeze) ...............205
Shifting ................................ .140
Automatic Transmission ....................141
Manual
Transmission ..................... .150
Speed Control Accel/Decel .............................99
Cancel .................................97
Speed Control (Cruise Control) ..................96
Starting ................................ .121
Automatic Transmission ....................121
8
INDEX - RAM 2500 / 3500 / 4500 / 5500 223
Page 226 of 228
Engine Block Heater..................125 , 137
Manual Transmission ..................... .121
Remote ................................92
Starting Procedures ........................ .121
Starting Procedures (Diesel Engines) .............121
Synthetic Engine Oil ....................... .179
Tip Start ................................ .121
Torque Converter Clutch .....................149
Traction Control .......................... .197
Transfer Case Fluid ................................ .207
Transmission Automatic ............................ .141
Fluid ................................ .207
Manual ........................... .121 , 150
Shifting .............................. .140
Viscosity, Engine Oil ....................... .178
Voltmeter ............................... .130
Water Separator, Diesel Fuel ...................184
224 INDEX - RAM 2500 / 3500 / 4500 / 5500
Page 227 of 228

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
Page 228 of 228
First Edition
Printed in U.S.A.
©2016 FCA US LLC. All Rights Reserved.
Ram is a registered trademark of FCA US LLC. 17D241-226-AA
STICK WITH THE SPECIALISTS®