Page 16 of 392
14
Operation indicator lamps
If one of the following indicator lamps comes on in the instrument panel and/or instrument panel screen, this confirms that the corresponding system has come into operation.
Warning / indicator lamp State Cause Action  / Observations
Left-hand 
direction indicatorflashing with buzzer.th e lighting stalk has been pushed 
down.
Right-hand 
direction indicatorflashing with buzzer.th e lighting stalk has been pushed up.
Sidelamps fixed.
th
e lighting stalk is in the 
"Sidelamps" position.
Dipped beam 
headlamps fixed.
th
e lighting stalk is in the "Dipped 
beam headlamps" position.
Main beam 
headlamps fixed.
th
e lighting stalk has been pulled 
towards you. Pull the stalk to return to dipped beam headlamps.
Front foglamps fixed.
th
e front foglamps are switched on.
tu
 rn the ring on the stalk rear wards twice to switch off 
the front foglamps.
For more information on the Lighting control stalk , refer to the corresponding section. 
Instruments  
         
        
        
     
        
        Page 17 of 392

15
308_en_Chap01_instruments-de-bord_ed01-2016
Warning / indicator lamp State Cause Action  / Observations
Rear foglamps fixed.
th
e rear foglamps are on.
tu
 rn the ring on the stalk rear ward to switch off the 
rear foglamps.
Diesel engine 
pre-heating fixed.
th
e ignition switch is at the 
2
nd position (ignition on) or the 
" ST
ART/STOP " button has been 
pressed. Wait until the warning lamp goes off before starting.
Once it goes off, starting is immediate, on condition that:
-
 t he clutch pedal is pressed fully down with a 
manual gearbox,
-
 
p
 ressure is maintained on the brake pedal with an 
automatic gearbox.
th
e period of illumination of the warning lamp is 
determined by the ambient conditions (up to about 
thirty seconds in extreme conditions).
If the engine does not start, switch the ignition off and 
then on, wait until the warning lamp goes off again, 
then start the engine.
Parking brake fixed.
th
e parking brake is applied or not 
fully released.
to s
witch off the warning lamp: with your foot on the 
brake pedal, release the parking brake.
If your vehicle has an electric parking brake: with your 
foot on the brake pedal, push the brake control lever.
Observe the safety recommendations.
For more information on the Manual parking 
brake  and the Electric parking brake , refer to the 
corresponding section.
1 
Instruments  
         
        
        
     
        
        Page 18 of 392

16
Warning / indicator lamp State Cause Action  / Observations
Automatic 
wiping fixed.
th
e wiper control has been pushed 
down. Automatic front wiping is activated.
to d
eactivate automatic wiping, operate the control 
stalk downwards or put the stalk into another position.
Passenger 's 
airbag system fixed.
the control switch, located at the 
passenger's end of the dashboard, is at 
the 
"ON " position.
the
 passenger's front airbag is activated.
In this case, do not install a rear ward 
facing child seat on the front passenger 
seat.
turn the control switch to the " OFF" position to 
deactivate the passenger's front airbag.
You can install a rear ward facing child seat, unless 
there is a fault with the airbags (airbag warning 
lamp
 
on).
Stop & Star t fixed. When the vehicle stops (red lights, traffic 
jams,
 
...) the Stop & Start system has put 
the engine into S
tO
P mode.
th
 e warning lamp goes off and the engine restarts 
automatically in S
tA
R
t
  mode, as soon as you want to 
move off.
flashes for a few 
seconds, then goes 
of f. S
tO
P mode is temporarily 
unavailable,
or
S
tA
R
t
 mode is invoked 
automatically. For more information on Stop & Star t
, refer to the 
corresponding section.
Blind spot 
monitoring system
(depending on 
ve r s i o n) fixed.
th
e blind spot monitoring system has 
been activated. For more information on the Blind spot monitoring 
system, refer to the corresponding section. 
Instruments  
         
        
        
     
        
        Page 19 of 392

17
308_en_Chap01_instruments-de-bord_ed01-2016
Deactivation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has been switched off intentionally.this is may be accompanied by an audible signal and the display of a message.
Warning
 
/ indicator lamp State Cause Action
 
/ Observations
Passenger's 
front airbag fixed in the seat belt 
and front passenger's 
airbag warning lamps 
display.
th
e control switch, located at the 
passenger's end of the dashboard, is 
set to the "OFF"  position.
the
 passenger's front airbag is 
deactivated.
You can install a rear ward facing 
child seat, unless there is a fault with 
the airbags (airbag warning lamp on).
tu
rn the control switch to the "ON" position to activate 
the passenger's front airbag; in this case, you must 
not install a child seat in the rear ward facing position 
on this seat.
Dynamic 
stability control  
(DSC/ASR )fixed.
th
e button is pressed and the 
indicator lamp comes on.
the
 DSC/ASR is deactivated.
DSC: dynamic stability control.
ASR: anti-slip regulation. Press the button to activate the DSC/ASR. 
Its
  indicator lamp goes off.
th
e DSC/ASR system is activated automatically when 
the vehicle is started.
If deactivated, the system is reactivated automatically 
from around 30 mph (50 km/h).
For more information on the Electronic stability 
programme (ESC)  and in particular, DSC/ASR, refer 
to the corresponding section.
1 
Instruments  
         
        
        
     
        
        Page 22 of 392

20
Warning / indicator lamp State Cause Action  / Observations
Electric parking 
brake flashing.
th
e electric parking brake is not 
applied automatically.
th
e application/release is faulty.You must stop as soon as it is safe to do so.
Park on flat level ground, engage a gear (or place the 
lever in position P for an automatic gearbox), switch 
off the ignition and contact a P
e
uge
Ot
  dealer or a 
qualified workshop.
Electric parking 
brake fault fixed.
th
e electric parking brake has a fault. Contact a P
e
 uge
Ot
  dealer or a qualified workshop 
without delay.
For more information on the Electric parking brake , 
refer to the corresponding section.
Deactivation of 
the automatic 
functions of the 
electric parking 
brake fixed.
th
e "automatic application" (on 
switching off the engine) and 
"automatic release" functions are 
deactivated or faulty.
In the event of a fault, illumination of 
this warning lamp is accompanied by 
a warning message. Contact a P
e
uge
Ot
  dealer or a qualified workshop if 
automatic application / release is no longer possible.
th
e parking brake can be released manually.
For more information on the Electric parking brake  
and in particular the reactivation of the automatic 
functions, refer to the corresponding section. 
Instruments  
         
        
        
     
        
        Page 26 of 392
24
Engine oil 
pressurefixed.th
ere is a fault with the engine 
lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a Pe
ugeOt  
dealer or a qualified workshop.
Under-inflation fixed, accompanied by 
an audible signal and 
a message.
th
e pressure in one or more tyres is 
too low. Check the tyre pressures as soon as possible.
th
is check should preferably be carried out when the 
tyres are cold.
You must reinitialise the system after the adjustment 
of one or more tyre pressures and after changing one 
or more wheels.
For more information on Under-inflation detection , 
refer to the corresponding section.
+ flashing then fixed, 
accompanied by the 
Service warning lamp.
th
e system has a fault: the tyre 
pressures are no longer monitored. Check the tyre pressures as soon as possible.
Have the system checked by a P
e
uge
Ot
  dealer or a 
qualified workshop.
Warning
 
/ indicator lamp
State Cause Action
 
 / Observations 
Instruments  
         
        
        
     
        
        Page 28 of 392

26
AdBlue® 
(BlueHDi Diesel) fixed, on switching 
on the ignition, 
accompanied by an 
audible signal and a 
message indicating the 
remaining driving range.the
 remaining driving range is 
between 350 miles (600 km) and 
1500 miles (2400 km).to p-up the AdBlue® as soon as possible or go to a 
Pe
ugeOt
 dealer or a qualified workshop.
+ flashing, associated with 
the S
eR
VIC
e
 w
arning 
lamp, accompanied by 
an audible signal and a 
message indicating the 
remaining driving range.
the
 remaining driving range is 
between 0 and 350 miles (600 km). You must top-up the AdBlue
® to avoid a breakdown
 
or go to a Pe
ugeOt
 dealer or a qualified workshop.
flashing, associated with 
the S
eR
VIC
e
 w
arning 
lamp, accompanied by 
an audible signal and a 
message indicating that 
starting is prevented.
th
e AdBlue
® tank is empty: the 
starting inhibition system required 
by legislation prevents starting of the 
engine.to b e able to start the engine, you must top-up
 the 
AdBlue® or call on a Pe ugeOt  dealer or a qualified 
workshop.
It is essential  to add at least 3.8 litres of AdBlue
® to 
the fluid tank
Warning or indicator lamp 
in the instrument panel
State
Cause Action
 
/ Observations
For topping-up or for more information on AdBlue
® and the SCR system , refer to the corresponding section. 
Instruments  
         
        
        
     
        
        Page 33 of 392

31
308_en_Chap01_instruments-de-bord_ed01-2016
Engine oil level indicator
On versions fitted with an electric oil gauge, 
information on the conformity of the oil level 
is displayed in the instrument panel for a few 
seconds when the ignition is switched on, at 
the same time as the service information.
th
e level read will only be correct if 
the vehicle is on level ground and the 
engine has been off for more than 
30
 
minutes.
th
is is indicated by a message in the 
instrument panel.
th
is is indicated by a message in the 
instrument panel.
If the low oil level is confirmed by a check using 
the dipstick, the level must be topped-up to 
avoid damage to the engine.
th
is is indicated by a message in the 
instrument panel. Contact a P
e
uge
Ot
  dealer 
or a qualified workshop.Dipstick
there are 2 marks on the 
dipstick:
-
 
A
  = max; never exceed this 
level,
-
 
B
  = min; top-up the level via 
the oil filler, using the grade 
of oil suited to your engine.
to l
ocate the dipstick and the oil filler 
cap on a Petrol engine  or a Diesel 
engine , refer to the corresponding 
section.
Oil level correct Oil level indicator fault Oil level incorrect
1 
Instruments