2017 Peugeot 301 display

28
or
Range between 0 and 350 miles (0 and 600 km)
or
Breakdown related to a lack of AdBlue
®
To be able to restart the engine, it is
essential to add at least 3.4 litres of
AdBlue
® to its tank.
For more information on AdBlue® and
the SCR (BlueHDi Diesel) system , and
in particular topping it up, refer to the
corresponding section.
When switching on the ignition, the Service
warning light comes on and the AdBlue warning
light flashes, accompanied by an audible signal
and the temporary display of "NO START IN"
and 0 miles or kilometres in the instrument
cluster - ("NO START IN 0 miles" means
"Starting prevented").
The AdBlue
® tank is empty: the starting
inhibition system required by legislation
prevents starting of the engine.
When switching on the ignition, the Service
warning light comes on and the AdBlue warning
light flashes, accompanied by an audible signal
and the temporary display of "NO START
IN" and a distance in the instrument cluster,
indicating the remaining range expressed in
miles or kilometres before engine starting
is prevented - (e.g. "NO START IN 300 km"
means "Starting will be prevented in 300 km
(150 miles)").
When driving, this message is displayed every
30 seconds until the AdBlue
® level has been
topped-up.
It is essential to top-up as soon as possible and
before the tank is completely empty; other wise
it will not be possible to restart the engine after
the next stop.
For more information on AdBlue
® and the SCR
(BlueHDi Diesel) system , and in particular
topping it up, refer to the corresponding
section.
Instruments

29
In the event of a fault with the emissions control system SCR
A device preventing the engine from
starting automatically activates after
1,100 km of driving following confirmation
of a fault in the SCR emissions control
system. Have the system checked by a
PEUGEOT dealer or a qualified workshop
as soon as possible. In the event of the detection of a fault
If it is a temporary fault, the alert
disappears during the next journey,
after self-diagnosis of the emissions
SCRsystem. or
If a fault with the SCR system is confirmed
(after 30 miles (50 km) covered with the
permanent display of the message signalling
a fault), the Service and engine diagnostic
warning lights come on and the AdBlue warning
light flashes, accompanied by an audible signal
and the temporary display in the instrument
cluster of "NO START IN" and a distance,
indicating the remaining range expressed in
miles or kilometres before engine starting
is prevented - (e.g.: "NO START IN 600 km"
means "Starting will be prevented in 600 km
(350 miles)").
While driving, this display appears every
30 seconds while the fault with the emissions
SCR system persists.
The alert is repeated when switching on the
ignition.
You should go to a PEUGEOT dealer or a
qualified workshop as soon as possible.
Other wise, you will not be able to restart the
vehicle. During the permitted driving phase
(between 685 and 0 miles) (1,100 km and 0 km)
or
The AdBlue, Service and engine diagnostic
warning lights come on, accompanied by an
audible signal and the display of the message
"Emissions fault".
The alert is triggered when driving when the
fault is detected for the first time, then when
switching on the ignition for subsequent
journeys, while the fault persists.
1
Instruments

30
Every time the ignition is switched on, the
Service and engine diagnostic warning lights
come on and the AdBlue warning light flashes,
accompanied by the temporary display of "NO
START IN" and 0 miles or kilometres - ("NO
START IN 0 km" means "Starting prevented") in
the instrument cluster. Starting preventedYou have exceeded the authorised driving
limit : the starting prevention system
inhibits engine starting.To be able to start
the engine, you must call on a PEUGEOT
dealer or a qualified workshop.
Distance recorders
Total distance recorder
System which measures the total distance
travelled by the vehicle during its life.
The total and trip distances are displayed for
thirty seconds when the ignition is switched off,
when the driver's door is opened and when the
vehicle is locked or unlocked.
Trip distance recorder
System which measures a distance travelled
during a day or other period since it was reset
to zero by the driver.
F

W
ith the ignition on, press the button until
zeroes appear.
or
Instruments

31
Date and time adjustment
Instrument panelAudio system / Bluetooth
With PEUGEOT Connect
Radio
Operate the left-hand button on the instrument
panel in the following order:
F

P
ress the button for more than two
seconds: the minutes flash.
F

P
ress the button to increase the minutes.
F

P
ress the button for more than two
seconds: the hours flash.
F

P
ress the button to increase the hours.
F

p
ress the button for more than two
seconds: 24H or 12H is displayed,
F

P
ress the button to select 24H or 12H.
F

P
ress the button for more than two
seconds to complete the adjustments.
The usual screen displays again when the
button hasn't been pressed for approximately
30 seconds. F

P
ress the "MENU" button.
Operate the audio system buttons in the
following order:
F

U
sing the arrows, select the
"Personalisation- Configuration" menu and
confirm by pressing the control knob.
F

U
sing the arrows, select the "Screen
configuration" menu then confirm.
F

U
sing the arrows, select the "Set date and
time" menu then confirm. F

S
elect the setting then confirm.
F
M
odify the setting then confirm again to
save the change.
F
A
djust the settings one by one, confirming
each time.
F
S
elect the "OK" tab in the screen and
confirm to exit the "Set date and time"
menu.
F
Sel
ect the Settings menu.
F

Sel
ect "Date " or "Time ".
F

C
hoose the display formats.
F

C
hange the date and/or time using the
numeric keypad.
F

C
onfirm with "OK".
F

Sel
ect "Date and time ".
1
Instruments

32
With PEUGEOT Connect
Nav
Adjustment of the time and date is only
available if synchronisation when the GPS is
deactivated.
F

Sel
ect the Settings menu.
F

P
ress the " OPTIONS " button to go to the
secondary page.
F

Sel
ect "Setting the time- date".
F

Sel
ect the " Date" or "Time " tab.
F

A
djust the date and/or time using the
numeric keypad.
F

C
onfirm with " OK".Additional adjustments
You can choose:
To change the display format of the date and
t i m e (12 h / 24 h).
To change the time zone.
Activate or deactivate the synchronisation with
the GPS (UTC).
The system does not automatically
manage the change between winter and
summer time (depending on country).
The change between winter and summer
time is done by changing the time zone.
Instruments

33
Trip computer
System that gives you information on the
current journey (range, fuel consumption, ...).
Instrument panel display screen
Monochrome screen C
Display of information
F Press the button located at the end of the wiper control stalk , to display the various
trip computer data. The on-board computer
information is the following:
-


Range.
-

C
urrent fuel consumption.
-
D

istance travelled.
-
A

verage fuel consumption.
-
A

verage speed.
F

T
he next press then returns you to the
normal display.
Zero reset
F Hold the control down for more than two seconds to reset to zero the distance
travelled, the average fuel consumption
and the average speed.
1
Instruments

34
Touch screen
The information is accessible in the "Driving"
menu.
Display of information in the
touch screen
Permanent display:
F Sel ect the " Applications " menu, then " Tr i p
computer ". The current fuel consumption tab with:
-


Range.
-
T
he current instantaneous fuel
consumption.
-
T
he Stop & Start time counter,
The trip " 1" tab with:
-
D

istance travelled.
-
A

verage fuel consumption.
-

A
verage speed for the first trip.
The trip " 2" tab with:
-
D

istance travelled.
-
A

verage fuel consumption.
-

A
verage speed for the second trip.
Reset trip
The information of the trip computer isdisplayed
in tabs.
F
P
ress one of the buttons to display the
desired tab.
Temporary display in a new window:
F

P
ress the end of the wiper control lever for
access to the information and display the
different tabs. F

W
hen the desired trip is displayed, press
the reset button or on the end of the wiper
control lever.
Tr i p s " 1" and " 2" are independent and are used
identically.
Tr i p " 1" allows daily calculations to be carried
out, for example, and trip " 2" allows monthly
calculations.
Instruments

35
On-board computer, some definitions
Range
(k m)
The number of kilometres which
can be covered with the fuel
remaining in the tank. Related
to the average fuel consumption
over the last few kilometres
travelled.
This value may vary following a change in
the style of driving or the relief, resulting
in a significant change in the current fuel
consumption.
When the range falls below 20 miles (30 km),
dashes are displayed. After filling with at least
5 litres of fuel, the range is recalculated and is
displayed if it exceeds 60 miles (100 km).
If dashes are displayed continuously while
driving in place of the digits, contact a
PEUGEOT dealer or a qualified workshop.
Current fuel consumption
(l/100 km or km/l)
Calculated over the last few
seconds.
This function is only displayed from
20 mph (30 km/h).
Average fuel consumption
(l/100 km or km/l)
Calculated since the last time the
trip was reset.
Average speed
(km/h)
Calculated since the last time the
trip was reset.
Distance travelled
(k m)
Calculated since the last time the
trip was reset.
Time counter Stop & Start
If your vehicle is fitted with Stop &
Start, a time counter calculates the
time spent in STOP mode during a
j o u r n ey.
It resets to zero every time the
ignition is switched on.
(minutes / seconds or hours / minutes)
1
Instruments