2017 Peugeot 208 clutch

14
Warning / indicator lampStateCause Action / Observations
Foot on brake Fixed. The brake pedal must be
pressed. With an electronic gearbox, selector in position N
,
press the brake pedal to start the engine.
With an automatic gearbox, with the engine running,
press the brake pedal before releasing the parking
brake to unlock the lever and come out of position P .
If you wish to release the parking brake without
pressing the brake pedal, this warning lamp will
remain on.
Flashing. With an electronic gearbox, if
you hold the vehicle on an incline
using the accelerator for too long,
the clutch overheats. Use the brake pedal and/or the parking brake.
Anti-lock
Braking System
(ABS) Fixed.
The anti-lock braking system has
a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
PEUGEOT dealer or a qualified workshop without
d e l ay.
Dashboard instruments

16
Passenger's
airbag systemFixed.
The control switch, located in
the glove box, is set to the " OFF"
position.
The passenger's front airbag is
deactivated.
You can install a "rearward"
facing child seat, unless there is
a fault with the airbags (airbag
warning lamp on). To activate the passenger front airbag, turn the control
to the "
ON" position.
In this case, do not fit a child seat in the "rear ward"
facing position.
Min fuel level Fixed, with the needle
in the red zone. Approximately 5
litres of fuel
remain in the tank.
You are now starting to use the
fuel reserve. You must refuel as soon as possible to avoid running
out of fuel.
This warning lamp will come on every time the ignition
is switched on, until sufficient fuel is added.
Capacity of the tank:
-


approximately 50
litres (petrol engines).
-


approximately 50
litres (Diesel engines).
-


approximately 45


litres (Diesel BlueHDi engines).
Never continue to drive until you run out of fuel, as
this could damage the emission control and injection
systems.
Flashing with the
needle in the red zone.
Very little fuel remains in the
tank.
Foot on the
clutch Fixed.
In STOP mode of the Stop &
Start, the transition to START
mode has been rejected because
the clutch pedal is not fully
pressed down. With a manual gearbox, you must depress the clutch
fully to allow the change to engine START mode.
Warning / indicator lamp
StateCause Action / Observations
Dashboard instruments

108
Starting – Switching off
the engine
Ignition switch
1.Stop position.
2. Ignition on position.
3. Starting position.
Avoid attaching heavy objects to the key
or the remote control, which would weigh
down on its blade in the ignition switch
and could cause a malfunction.
Starting
F Insert the key into the ignition switch.
The system recognises the starting code.
With a manual gearbox
, place the gear
selector in neutral then fully depress the clutch
pedal.
With an electronic gearbox , place the gear
selector at N then press the brake pedal firmly. With an automatic gearbox
, place the gear
selector at P or N then press the brake pedal
f i r m l y.
F
U
nlock the steering column by
simultaneously turning the steering and the
key.
Driving

111
Manual gearbox
5-speed
F Move the gear lever fully to the right to engage 5th g e a r.
Engaging reverse gear
F Move the gear lever to the right then pull it back.
Only engage reverse gear when the
vehicle is stationary with the engine at
idle.
6-speed
F Move the lever fully to the right to engage 5th
or 6th g e a r.
Engaging reverse gear
F Raise the collar below the gear lever knob, then push the lever fully to the left and then
forward.
Only engage reverse gear when the vehicle
is stationary with the engine at idle.
As a safety precaution and to aid engine
star t-up:
-

a
lways select neutral,
-

p
ress the clutch pedal. The gear shift indicator is displayed on the
instrument panel.
6
Driving

119
With BlueHDi Diesel and a manual gearbox:
- A s soon as the vehicle stops or the speed is
less than 2
mph (3 km/h) (with 1.5 Blue HDi
engine).
-

G
ear lever in neutral and clutch pedal
released.
With PureTech petrol and a manual,
electronic or automatic gearbox :
-

A
s soon as the vehicle stops or the speed
is less than 2
mph (3 km/h) (with manual
gearbox and depending on which version
you have).
-

G
ear lever in neutral and clutch pedal
released (manual gearbox).
-

B
rake pedal pressed or gear lever in
position N (electronic or automatic gearbox).
Special cases: STOP mode not
available
STOP mode is not invoked when:
- t he driver's door is open,
-

t
he driver's seat belt is not fastened,
-

t
he vehicle has not exceeded 6 mph
(10
km/h) since the last engine start using
t h e key,
-

t
he engine is needed to maintain a
comfortable temperature in the passenger
compartment,
-

d
emisting is active, The ECO warning lamp flashes for a
few seconds, then goes off.
This operation is perfectly normal.
A time counter sums up the time
periods spent in STOP mode
during a journey. It resets every
time the ignition is switched on
using the key.
For your comfort, during parking
manoeuvres, STOP mode is not available
for a few seconds after coming out of
reverse gear.
The Stop & Start system does not affect
the functionality of the vehicle, such as for
example, braking, power steering, With a manual gearbox in STOP mode, if
a gear is engaged without fully depressing
the clutch pedal, a warning lamp comes
on or an alert message is displayed asking
you to depress the clutch pedal to restart
the engine.
Never refuel with the engine in STOP
mode; you must switch off the ignition
using the key.
START mode
The ECO warning lamp goes off and
the engine starts:
With a manual gearbox :
-

C

lutch pedal depressed.
With an electronic / automatic gearbox :
-

G

ear lever in position A / D or M .
-
B

rake pedal released.
or
-
s

ome special conditions (battery charge,
engine temperature, braking assistance,
exterior temperature, etc.) where the engine
is needed to control the system.
6
Driving

124
Registering a cruise speed
setting
- Bring the vehicle up to the desired speed by pressing the accelerator.
-

P
ress the SET – or
SET + button.
The speed setting is registered/activated and
the vehicle will maintain this speed.
Temporarily exceeding the
programmed speed
It is possible to accelerate and
temporarily drive at a speed higher
than the registered speed setting.
The cruise speed setting value
flashes.
When the accelerator pedal is
released, the vehicle will return to
the registered speed setting.
Pause (OFF)
- Press this button or the brake or clutch pedal (depending on the version). With 1.2 PureTech 82 and 110 (Euro
6.2)
or 1.5 BlueHDi (Euro 6.2) engines, a
manual gearbox and the Stop & Start,
pressing the clutch pedal does not pause
the cruise control, the cruise control
remains active after changing gears.
Resume
- After the cruise control has been paused, press this button.
The vehicle returns to the last registered speed.
Alternatively, you can also resume the
procedure for "Registering a cruise speed
setting".
Driving

131
Park Assist
The system detects a parking space and then
provides assistance with the parallel parking
manoeuvres.
It controls the steering and provides visual and
audible information to the driver.
The driver manages the accelerator, brakes,
gears and the clutch in the case of a manual
gearbox.
The driver can take control at any time by
gripping the steering wheel.The Park Assist system cannot in any
circumstances replace the need for
vigilance on the part of the driver.
The driver must remain in control of their
vehicle ensuring that the space remains
clear during the manoeuvre.
In some circumstances, the sensors may
not detect small obstacles located in their
blind spots.
During manoeuvring phases, the steering
wheel per forms rapid turns: do not hold
the steering wheel, do not put your hands
between the spokes of the steering wheel.
Watch out for any object that could block
the manoeuvre (loose clothing, scar ves,
ties, etc.) – Risk of injury! For entry into a parallel parking space the
system does not detect spaces which are
clearly much smaller or larger than the
size of the vehicle.
The "Parking sensors" function activates
automatically during the manoeuvres, it is
possible that a warning lamp illuminates
on the screen, accompanied by an audible
signal, without affecting the parking.
Changing tyre sizes (out-size tyres, winter
tyres, etc.) can inter fere with the correct
operation of the parking assistance
system.
When the Park Assist is active, it prevents
the Stop & Start going into STOP mode.
In STOP mode, activating Park Assist
restarts the engine.
Entering a parallel parking
space
F Once you have detected an available space,
limit the speed of the vehicle to 12 mph
(20


km/h).
F

P
osition your vehicle before this space.
The system provides assistance in entering and
exiting a parking space when parallel parking.
6
Driving