2017 Peugeot 208 ECO mode

3
.
.
Eco-driving 104
Driving recommendations 1 05
Starting – Switching off the engine

1
08
Parking brake

1
10
Manual gearbox
1

11
Electronic gearbox
1

12
Automatic gearbox

1
14
Gear shift indicator

1
16
Hill start assist

1
17
Stop & Start

1
18
Speed limiter
1

21
Cruise control

1
23
Memorising speeds
1

26
Active City Brake

1
27
Parking sensors
1

29
Reversing camera
1

30
Park Assist

1
31
Under-inflation detection
1

35Fuel tank
1 38
Misfuel prevention (Diesel) 1 39
Compatibility of fuels
1

40
Snow chains

1
41
Towing a trailer

1
42
Load reduction mode

1
43
Energy economy mode
1

43
Changing a window wiper
1

44
Fitting roof bars

1
44
Bonnet


145
Engines


147
Checking levels

1
48
Checks
15

0
AdBlue
® (BlueHDi engines) 1 52
Advice on care 1 56
Warning triangle
1

57
Running out of fuel (Diesel)

1
57
Temporary puncture repair kit
1

58
Spare wheel

1
62
Changing a bulb
1

67
Changing a fuse
1

72
12

V battery
1
78
To w i n g


181
Characteristics of engines and towed loads 18 4
Pe
trol engines
1 85
Diesel engines
1

88
LPG engines
1

90
Dimensions
1

91
Identification markings
1

92
Driving Practical information
In the event of a breakdown Technical data
Alphabetical index
Audio equipment and telematics
PEUGEOT Connect Nav
PEUGEOT Connect Radio
Audio system / Bluetooth
Audio system
.
Contents

9
Gearbox
Park position (Park).
Reverse gear (Rear).
Neutral.
Automatic mode (Drive).
Sequential mode.
Change up / Change down.
Sport programme.Snow programme.
Trip recorder reset
With the trip distance displayed, press the
button for a few seconds.
1
Dashboard instruments

10
Warning and indicator
lamps
When the ignition is switched on
Certain warning lamps come on for a few
seconds when the vehicle's ignition is switched
on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before driving refer to the
information on the warning lamp concerned.
Associated warnings
Certain warning lamps may come on in one of
two modes: fixed (continuous) or flashing.
Only by relating the type of lighting to the
operating status of the vehicle can it be
ascertained whether the situation is normal or
whether a fault has occurred.
In the event of a fault, the illumination of the
warning lamp may be accompanied by an
audible signal and/or a message.
Warning lamps
When the engine is running or the vehicle is
being driven, illumination of one of the following
warning lamps indicates a fault which requires
action on the part of the driver.
Any fault resulting in the illumination of a
warning lamp must be investigated further
using the associated message.
If you encounter any problems, contact a
PEUGEOT dealer or a qualified workshop.
Operation indicator lamps
The lighting of one of the following indicator
lamps confirms that the corresponding system
is on.
Deactivation indicator lamp
If this indicator lamp comes on, this confirms
that the corresponding system has been
switched off intentionally.
This may be accompanied by an audible signal
and a message being displayed.
Visual identifiers informing the driver that
a system is in operation, switched off (on/
off indicator lamps) or has developed a fault
(warning lamp).
Dashboard instruments

21
Warning / indicator lampStateCause Action / Observations
Diesel engine
pre-heating Fixed.
The key is at position 2 (ignition
on) in the ignition switch. Wait until the warning lamp goes off before starting.
The period of illumination of the warning lamp is
determined by the ambient conditions (up to about
thirty seconds in extreme conditions).
If the engine does not start, switch the ignition off and
then on, wait until the indicator lamp goes off again,
then start the engine.
Power steering Fixed. The power steering has a fault. Drive carefully at reduced speed.
Have the vehicle checked by a PEUGEOT dealer or a
qualified workshop.
Rear foglamp Fixed. The rear foglamp has been
switched on using the ring on the
lighting control stalk. Turn the ring on the lighting control stalk to the rear to
switch off the rear foglamp.
Stop & Star t Fixed. When the vehicle stops (red
lights, traffic jams, etc.), the Stop
& Start system puts the engine
into STOP mode. The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want to
move off.
Flashes for a few
seconds, then goes
of f. STOP mode is temporarily
unavailable.
or
START mode is triggered
automatically. For more information on Stop & Start, refer to the
corresponding section.
1
Dashboard instruments

33
Date and time adjustment
Instrument panel
F Each press of this button moves between the following settings:
-


h o u r,
-


minutes,
-

1
2 or 24 hour format.
With PEUGEOT Connect
Radio
F Select the Settings menu.
F
Sel
ect "Date and time ".
F

Sel
ect "Date " or "Time ".
F

C
hoose the display formats.
F

C
hange the date and/or time using the
numeric keypad.
F

C
onfirm with " OK".
Current fuel consumption
(mpg or l/100 km or km/l)
T his function is only displayed from
20
mph (30 km/h).
Calculated over the last few seconds.
Average fuel consumption
(mpg or l/100 km or km/l)
C alculated since the last trip computer
reset.
Distance travelled
(miles or km)
Calculated since the last trip computer
reset.
Average speed
Calculated since the last trip computer
reset.
(mph or km/h)
Total time in stop mode
(minutes / seconds or hours / minutes)
If your vehicle is fitted with the Stop & Start, a
time counter adds up the time spent in STOP
mode during a journey.
It resets to zero every time the ignition is
switched on.
1
Dashboard instruments

43
Locking the vehicle without
activating the alarm
F Lock or deadlock the vehicle using the key in the driver's door lock.
Triggering of the alarm
When the alarm is triggered, the siren sounds
and the direction indicators flash for thirty
seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times
consecutively.
When the vehicle is unlocked using
the remote control, rapid flashing
of the indicator lamp in the button
informs you that the alarm was
triggered during your absence.
Upon ignition, this flashing stops
immediately.
Deactivate the monitoring
functions
To stop the alarm, for example if the remote
control is not working:
F

U
nlock the vehicle using the key in the
driver's door lock.
F

o
pen the door; the alarm is triggered,
F

S
witch on the ignition; this stops the alarm.
The indicator lamp goes off.
Malfunction
When the ignition is switched on,
fixed illumination of the button’s
indicator lamp indicates a fault in the
system.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
Electric windows
Manual mode
Open
Press the control, without passing
the point of resistance. The window
stops as soon as you release the
switch.
Close
Pull the control without going past
the point of resistance. The window
stops as soon as you release the
switch.
2
Access

44
Automatic mode
(depending on version)
Open
Press the control, beyond the
resistance point: the window opens
completely when the switch is
released. Pressing the switch again
stops the movement of the window.
Close
Pull the control, beyond the
resistance point: the window closes
completely when the switch is
released. Pressing the switch again
stops the movement of the window.
The electric window controls remain
operational for approximately 1


minute
after the key has been removed.
Once this time has elapsed, the electric
windows will not operate. To reactivate
them, switch the ignition on again.
Anti-pinch
Deactivating the rear door
electric windows
For the safety of your children, press
the switch to prevent operation of
the electric windows of the rear
doors, irrespective of their position.
With the warning lamp on, the rear switches
are deactivated. With the warning lamp off, the
switches are active.
Reinitialisation
Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch is not active during these
operations:
-

b
ring the window down completely, then
bring it back up. It will go up by a few
centimetres with each press. Repeat the
operation until the window is fully closed,
-

c
ontinue to pull the switch upwards for at
least 1
second after reaching this position,
window closed.
Always remove the key when leaving the
vehicle, even for a short time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this, press
the switch concerned.
When operating the passenger electric
window switches, the driver must ensure
that no one is preventing correct closing of
the windows.
The driver must ensure that the
passengers use the electric windows
c o r r e c t l y.
Be aware of children when operating the
windows.
(depending on version)
When the window rises and meets an obstacle,
it stops and immediately partially lowers again.
In the event of unwanted opening
of the window when closing
automatically, press the switch until
the window opens completely, then
pull the switch immediately until the
window closes. Continue to hold the
control for approximately 1

second
after the window has closed.
The safety anti-pinch function is not active
during this operation.
Access

62
It switches off gradually:
- w hen the vehicle is locked,
-

w
hen the ignition is switched on,
-

3
0 seconds after the last door is closed.
Permanently off.
Permanent lighting.
In "permanent lighting" mode, the lighting
time varies according to the circumstances:
-
w
hen the ignition is off, approximately
ten minutes,
-

i
n energy economy mode,
approximately 30


seconds,
-
w

ith the engine running, unlimited.
Map reading lamps
F With the ignition on, press the corresponding switch.
Take care not to put anything in contact
with the courtesy lamp.
Interior ambient lighting
Switching on
At night, panoramic sunroof light-emitting
diodes (LEDs) come on automatically when the
sidelamps are switched on.
Switching off
The interior ambient lighting switches off
automatically when the sidelamps are switched
of f. The guide-me-home lighting can be
configured in the menu Driving /
Vehicle.
Ease of use and comfort